| 1. |
- Baldini, L., et al.
(författare)
-
Preliminary results of the LAT Calibration Unit beam tests
- 2007
-
Ingår i: First GLAST Symposium. - Melville : American Institute of Physics (AIP). - 9780735404311 ; , s. 190-204
-
Konferensbidrag (refereegranskat)abstract
- The calibration strategy of the GLAST Large Area Telescope (LAT) combines analysis of cosmic ray data with accelerator particle beams measurements. An advanced Monte Carlo simulation of the LAT, based on the Geant4 package, was set up to reproduce the LAT response to such radiation and to benchmark the event reconstruction and the background rejection strategy before launch and during operation. To validate the LAT simulation, a massive campaign of beam tests was performed between July and November 2006, in parallel with the LAT integration and test, on the LAT Calibration Unit. This is a detector built with spare flight modules and flight-like readout electronics, which was exposed to a large variety of beams, representing the whole spectrum of the signal that will be detected by the LAT, using the CERN and the GSI accelerator facilities. Beams of photons (0 - 2.5 GeV), electrons (1-300 GeV), hadrons (π and p, a few GeV - 100 GeV) and ions (C, Xe, 1.5 GeV/n) were shot through the CU to measure the physical processes taking place in the detector and eventually fine-tune their description in the LAT Monte Carlo simulation. This paper describes the motivations and goals of the test runs, the many different experimental setups used, the measured detector performance and preliminary results of the LAT Monte Carlo validation.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Benisty, H., et al.
(författare)
-
Low-loss photonic-crystal and monolithic InP integration : Bands, bends, lasers, filters
- 2004
-
Ingår i: Photonic Crystal Materials and Devices II. - : SPIE - International Society for Optical Engineering. - 0819452688 ; , s. 119-128
-
Konferensbidrag (refereegranskat)abstract
- Practical realizations of 2D (planar) photonics crystal (PhC) are either on a membrane or etched through a conventional heterostructure. While fascinating objects can emerge from the first approach, only the latter approach lends itself to a progressive integration of more compact PhC's towards monolithic PICs based on InP. We describe in this talk the various aspects from technology to functions and devices, as emerged from the European collaboration "PCIC". The main technology tour de force is deep-etching with aspect ratio of about 10 and vertical sidewall, achieved by three techniques (CAIBE, ICP-RIE, ECR-RIE). The basic functions explored are bends, splitters/combiners, mirrors, tapers, and the devices are filters and lasers. At the end of the talk, I will emphasize some positive aspects of "broad" multimode PhC waveguides, in view of compact add-drop filtering action, notably.
|
|
| 7. |
- Pfrommer, H., et al.
(författare)
-
Experimental Demonstration of Full-Duplex DOCSIS Signal Transmissions over a Wireline/Wireless-Fibre Access Network
- 2006
-
Ingår i: 2006 International Topical Meeting on Microwaves Photonics. ; , s. 89-92
-
Konferensbidrag (refereegranskat)abstract
- A fibre-radio access network architecture for simultaneous wireline and wireless transmissions of data over cable service interface specification (DOCSIS) signals is presented. An all-optical harmonic up-conversion technique using a dual-drive Mach-Zehnder modulator (DD-MZM) is employed at the central station while an InGaAsP/InGaAsP multiple quantum well (MQW) asymmetric Fabry-Perot modulator/detector (AFPM) functions as a single optical/electrical transducer performing optical intensity modulation and photodetection simultaneously at the base station. Full-duplex operation is demonstrated for both access types in an indoor laboratory environment as well as in a small-scale outdoor field trial
|
|
| 8. |
|
|
| 9. |
- Hill, Daniel, et al.
(författare)
-
Microfluidic and Transducer Technologies for Lab on a Chip Applications
- 2010
-
Ingår i: 2010 ANNUAL INTERNATIONAL CONFERENCE OF THE IEEE ENGINEERING IN MEDICINE AND BIOLOGY SOCIETY (EMBC). - : IEEE conference proceedings. - 9781424441242 ; , s. 305-307
-
Konferensbidrag (refereegranskat)abstract
- Point-of-care diagnostic devices typically require six distinct qualities: they must deliver at least the same sensitivity and selectivity, and for a cost per assay no greater than that of today's central lab technologies, deliver results in a short period of time (<15 min at GP; <2h in hospital), be portable or at least small in scale, and require no or extremely little sample preparation. State-of-the-art devices deliver information of several markers in the same measurement.
|
|
| 10. |
|
|
