| 1. |
-
Overview of the JET results
- 2015
-
In: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 55:10
-
Journal article (peer-reviewed)
|
|
| 2. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 3. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 4. |
|
|
| 5. |
- Herzan, A., et al.
(author)
-
Detailed spectroscopy of Bi-195
- 2017
-
In: Physical Review C. - : American Physical Society. - 2469-9985 .- 2469-9993. ; 96:1
-
Journal article (peer-reviewed)abstract
- An experiment focused on the study of shape coexistence and new high-spin structures in Bi-195 has been performed. The nucleus is in a transitional region of the bismuth isotope chain. A large number of new states have been found, resulting in a significant extension of the previously known level scheme. Several new collective structures have been identified. A strongly coupled rotational band built upon the 13/2(+) isomeric state was extended up to I-pi = (49/2(+)) and an energy of 5706 keV. The I-pi = 31/2(+) member of the pi i(13/2) band was also found to feed a new long-lived isomeric state with an excitation energy of 2616 keV and a spin and parity of I-pi = 29/2(+). The half-life of the 29/2+ isomeric state was determined to be 1.49(1) mu s. It decays via the emission of 457-keV E2 and 236-keV E1 transitions, respectively. A low-energy 46-keV E2 transition has been identified to depopulate the (29/(2-)) isomeric state, with a measured half-life of T-1/2 = 614(5) ns. This transition allows the excitation energy of the isomeric state to be determined as 2381 keV. The feeding patterns of both 29/2(+) and (29/2(-)) isomeric states have also been described. This is the first time collective structures have also been observed up to high spins and excitation energies in the neutron-deficient Bi-195 nucleus. Evidence for the manifestation of shape coexistence in Bi-195 is also discussed.
|
|
| 6. |
|
|
| 7. |
- Nieminen, P., et al.
(author)
-
gamma-ray spectroscopy of Bi-191,Bi-193
- 2004
-
In: Physical Review C. Nuclear Physics. - 0556-2813 .- 1089-490X. ; 69:6, s. 064326-
-
Journal article (peer-reviewed)abstract
- Prompt and delayed gamma rays from Bi-191,Bi-193 have been identified using the recoil-decay tagging, isomer tagging, and recoil gating techniques, resulting in extensive level schemes for both nuclei. Excitation energies of the isomeric 13/2(+) states have been established and oblate strongly coupled bands built on them have been observed. The nearly spherical 9/2(-) ground-state bands appear to be crossed by more oblate-deformed low-lying structures. The properties of the bands feeding the 1/2(+) intruder states indicate some structural change between Bi-193 and Bi-191. The deformation associated with each of these states has been extracted from total Routhian surface calculations which also reveal the development of prolate minima with decreasing neutron number. B(M1)/B(E2) ratios have been measured for the observed strongly coupled bands in order to resolve the intrinsic excitations. The observed quasiparticle structures in Bi-193 and high-spin isomers both in Bi-193 and Bi-191 are interpreted based on the coupling of the odd proton to the even-even Pb core.
|
|
| 8. |
- Ohd, JN, et al.
(author)
-
Evaluation of the latent tuberculosis screening and treatment strategy for asylum seekers in Stockholm, Sweden 2015-2018: a record linkage study of the care cascade
- 2021
-
In: The European respiratory journal. - : European Respiratory Society (ERS). - 1399-3003 .- 0903-1936. ; 57:3
-
Journal article (peer-reviewed)abstract
- About 90% of active tuberculosis (TB) cases in Sweden are foreign born and are mainly due to latent TB infection (LTBI) reactivation. The aim of this study was to assess the current migrant LTBI screening programme with regards to test results and completion of the care cascade.MethodA retrospective cohort of all 14173 individuals attending a health examination was established for the Stockholm Region 2015–2018 through record-linkage of data extracted from the Swedish Migration Authority and medical records. Screening results, referrals to specialist care and treatment initiation were ascertained through automated data extraction for the entire cohort. Detailed cascade steps, including treatment completion, were analysed through manual data extraction for a subsample of all persons referred to specialist care in the period 2016–2017.ResultsOf 5470 patients screened with an interferon-gamma release assay (IGRA), 1364 (25%) were positive, of whom 358 (26%) initiated LTBI treatment. An increased trend in IGRA-positivity was seen for increased age and TB-incidence in country of origin. Among the IGRA positive patients, 604 (44%) were referred to specialist care. Lower age was the main referral predictor. In the subsample of 443 patients referred to specialist care in 2016–2017, 386 (87%) were invited, of whom 366 (95%) attended. Of 251 patients (69%) recommended for LTBI treatment, 244 (97%) started such treatment and of those 221 (91%) completed it.ConclusionThe low attrition in patient-dependent cascade steps shows that the voluntary approach works well. Low LTBI treatment attainment is due to the current conservative local treatment policy, which means the vast majority are IGRA-tested without an intention to treat for LTBI.
|
|
| 9. |
- Parail, V., et al.
(author)
-
Integrated modelling of ITER reference scenarios
- 2009
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 49:7
-
Journal article (peer-reviewed)abstract
- The ITER Scenario Modelling Working Group (ISM WG) is organized within the European Task Force on Integrated Tokamak Modelling (ITM-TF). The main responsibility of the WG is to advance a pan-European approach to integrated predictive modelling of ITER plasmas with the emphasis on urgent issues, identified during the ITER Design Review. Three major topics are discussed, which are considered as urgent and where the WG has the best possible expertize. These are modelling of current profile control, modelling of density control and impurity control in ITER (the last two topics involve modelling of both core and SOL plasma). Different methods of heating and current drive are tested as controllers for the current profile tailoring during the current ramp-up in ITER. These include Ohmic, NBI, ECRH and LHCD methods. Simulation results elucidate the available operational margins and rank different methods according to their ability to meet different requirements. A range of ITER-relevant' plasmas from existing tokamaks were modelled. Simulations confirmed that the theory-based transport model, GLF23, reproduces the density profile reasonably well and can be used to assess ITER profiles with both pellet injection and gas puffing. In addition, simulations of the SOL plasma were launched using both H-mode and L-mode models for perpendicular transport within the edge barrier and in the SOL. Finally, an integrated approach was also used for the predictive modelling of impurity accumulation in ITER. This includes helium ash, extrinsic impurities (such as argon) and impurities coming from the wall (including tungsten). The relative importance of anomalous and neo-classical pinch contributions towards impurity penetration through the edge transport barrier and further accumulation in the core was assessed.
|
|
| 10. |
- Shedrawy, J, et al.
(author)
-
Cost-effectiveness of the latent tuberculosis screening program for migrants in Stockholm Region
- 2021
-
In: The European journal of health economics : HEPAC : health economics in prevention and care. - : Springer Science and Business Media LLC. - 1618-7601. ; 22:3, s. 445-454
-
Journal article (peer-reviewed)abstract
- IntroductionThe majority of tuberculosis (TB) cases in Sweden occur among migrants from endemic countries through activation of latent tuberculosis infection (LTBI). Sweden has LTBI-screening policies for migrants that have not been previously evaluated. This study aimed to assess the cost-effectiveness of the current screening strategy in Stockholm.MethodsA Markov model was developed to predict the costs and effects of the current LTBI-screening program compared to a scenario of no LTBI screening over a 50-year time horizon. Epidemiological and cost data were obtained from local sources when available. The primary outcomes were incremental cost-effectiveness ratio (ICER) in terms of societal cost per quality-adjusted life year (QALY).ResultsScreening migrants in the age group 13–19 years had the lowest ICER, 300,082 Swedish Kronor (SEK)/QALY, which is considered cost-effective in Sweden. In the age group 20–34, ICER was 714,527 SEK/QALY (moderately cost-effectives) and in all age groups above 34 ICERs were above 1,000,000 SEK/QALY (not cost-effective). ICER decreased with increasing TB incidence in country of origin.ConclusionScreening is cost-effective for young cohorts, mainly between 13 and 19, while cost-effectiveness in age group 20–34 years could be enhanced by focusing on migrants from highest incidence countries and/or by increasing the LTBI treatment initiation rate. Screening is not cost-effective in older cohorts regardless of the country of origin.
|
|
