| 1. |
- Kaern, Martin Ryhl, et al.
(författare)
-
Continuous versus pulsating flow boiling. Experimental comparison, visualization, and statistical analysis
- 2017
-
Ingår i: Science and Technology for the Built Environment. - : Taylor & Francis. - 2374-4731 .- 2374-474X. ; 23:6, s. 983-996
-
Tidskriftsartikel (refereegranskat)abstract
- This experimental study investigates an active method for flow boiling heat transfer enhancement by means of fluid flow pulsation. The hypothesis is that pulsations increase the flow boiling heat transfer by means of better bulk fluid mixing, increased wall wetting, and flow-regime destabilization. The fluid pulsations are introduced by a flow modulating expansion device and are compared with continuous flow by a stepper-motor expansion valve in terms of time-averaged heat transfer coefficient. The cycle time ranges from 1 to 9 s for the pulsations. The time-averaged heat transfer coefficients are reduced from transient measurements immediately downstream of the expansion valves at low vapor qualities. The results show that the pulsations improve the time-averaged heat transfer coefficient by 3.2% on average at low cycle time (1 to 2 s), whereas the pulsations may reduce the time-averaged heat transfer coefficient by as much as 8% at high heat flux (q >= 35 kW/m(2)) and cycle time (8 s). The latter reduction is attributed to a significant dry-out that occurs when the flow modulating expansion valve is closed. Additionally, the effect of fluid flow pulsations is found to be statistically significant, disregarding the lowest heat flux measurements.
|
|
| 2. |
- Kaern, Martin Ryhl, et al.
(författare)
-
Experimental comparison and visualization of in-tube continuous and pulsating flow boiling
- 2018
-
Ingår i: International Journal of Heat and Mass Transfer. - : Pergamon Press. - 0017-9310 .- 1879-2189. ; 125, s. 229-242
-
Tidskriftsartikel (refereegranskat)abstract
- This experimental study investigated the application of fluid flow pulsations for in-tube flow boiling heat transfer enhancement in an 8 mm smooth round tube made of copper. The fluid flow pulsations were introduced by a flow modulating expansion device and were compared with continuous flow generated by a stepper-motor expansion valve in terms of the time-averaged heat transfer coefficient. The cycle time ranged from 1 s to 7 s for the pulsations, the time-averaged refrigerant mass flux ranged from 50 kg m(-2) s(-1) to 194 kg m(-2) and the time-averaged heat flux ranged from 1.1 kW m(-2) to 30.6 kW m(-2). The time-averaged heat transfer coefficients were reduced from transient measurements immediately downstream of the expansion valves with 2 K and 20 K subcooling upstream, resulting in inlet vapor qualities at 0.05 and 0.18, respectively, and covered the saturated flow boiling range up to the dry-out inception. Averaged results of the considered range of vapor qualities, refrigerant mass flux and heat flux showed that the pulsations at low cycle time (1 s) improved the time-averaged heat transfer coefficients by 5.6% and 2.2% for the low and high subcooling, respectively. However, the pulsations at high cycle time (7 s) reduced the time-averaged heat transfer coefficients by 1.8% and 2.3% for the low and high subcooling, respectively, due to significant dry-out when the flow-modulating expansion valve was closed. Furthermore, the flow pulsations were visualized by high-speed camera to assist in understanding the time-periodic flow regimes and the effect they had on the heat transfer performance.
|
|
