| 1. |
- Hoglund, L, et al.
(författare)
-
Selective optical doping to predict the performance and reveal the origin of photocurrent peaks in quantum dots-in-a-well infrared photodetectors
- 2009
-
Ingår i: INFRARED PHYSICS and TECHNOLOGY. - Exeter : Elsevier BV. - 1350-4495 .- 1879-0275. ; 52:6, s. 272-275
-
Tidskriftsartikel (refereegranskat)abstract
- Resonant optical pumping across the band gap was used as artificial doping in InAs/In0.15Ga0.85As/GaAs quantum dots-in-a-well infrared photodetectors. Through efficient filling of the quantum dot energy levels by simultaneous optical pumping into the ground states and the excited states of the quantum dots, the response was increased by a factor of 10. Low temperature photocurrent peaks observed at 120 and 148 meV were identified as intersubband transitions emanating from the quantum dot ground state and the quantum dot excited state, respectively by a selective increase of the electron population in the different quantum dot energy levels.
|
|
| 2. |
- Höglund, Linda, 1974-, et al.
(författare)
-
Energy level scheme of InAs/InxGa1-xAs/GaAs quantum-dots-in-a-well infrared photodetector structures
- 2010
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - Woodbury, NY : American Physical Society. - 1098-0121 .- 1550-235X. ; 82:3, s. 035314-
-
Tidskriftsartikel (refereegranskat)abstract
- A thorough investigation of quantum-dots-in-a-well structures for infrared photodetector applications has been performed employing different experimental techniques. The electronic structure of self-assembled InAs quantum dots embedded in an In0.15Ga0.85As/GaAs quantum well (QW) was deduced from photoluminescence (PL) and PL excitation (PLE) spectroscopy. From polarization-dependent PL it was revealed that the quantum dots hold two electron energy levels and two heavy-hole levels. Tunnel capacitance spectroscopy confirmed an electron energy level separation of about 50 meV, and additionally, that the conduction-band ground state and excited state of the dots are twofold and fourfold degenerates, respectively. Intersubband photocurrent spectroscopy, combined with simultaneous interband pumping of the dots, revealed a dominant transition at 150 meV (8.5 mu m) between the ground state of the quantum dots and the excited state of the QW. Results from detailed full three-dimensional calculations of the electronic structure, including effects of composition intermixing and interdot interactions, confirm the experimentally unravelled energy level scheme of the dots and well.
|
|
| 3. |
- Jain, Vishal, 1989-, et al.
(författare)
-
Processing and Characterization of Nanowire Arrays for Photodetectors
- 2015
-
Ingår i: Nano-Structures for Optics and Photonics. - Dordrecht : Springer. - 9789401791427 - 9789401791328 - 9789401791335 ; , s. 511-512
-
Konferensbidrag (refereegranskat)abstract
- We present a fabrication scheme of contacting arrays of vertically standing nanowires (NW) for LEDs (Duan et al. Nature 409:66–69, 2001), photodetectors (Wang et al. Science (NY) 293:1455–1457, 2001) or solar cell applications (Wallentin et al. Science (NY) 339:1057–1060, 2013). Samples were prepared by depositing Au films using nano-imprint lithography (Må rtensson et al. Nano Lett 4:699–702, 2004) which are used as catalysts for NW growth in a low-pressure metal organic vapour phase epitaxy system where III-V precursors and dopant gases are flown at elevated temperatures which lead to the formation of NWs with different segments (Borgström et al. Nano Res 3:264–270, 2010). An insulating SiO2 layer is then deposited and etched from the top segments of the NWs followed by sputtering of a transparent top conducting oxide and opening up 1 × 1 mm2 device areas through a UV lithography step and etching of the top contact from non-device areas. A second UV lithography step was subsequently carried out to open up smaller windows on the ITO squares for bond pad definition, followed by metallization and lift-off; and the substrate is used as back contact. We also report on the electrical and optical properties of near-infrared p+−i−n+ photodetectors/solar cells based on square millimeter ensembles of InP nanowires grown on InP substrates. The study includes a sample series where the p +-segment length was varied between 0 and 250 nm, as well as solar cell samples with 9.3 % efficiency with similar design. The NWs have a complex modulated crystal structure of alternating wurtzite and zincblende segments, a polytypism that depends on dopant type. The electrical data for all samples display excellent rectifying behavior with an ideality factor of about 2 at 300 K. From spectrally resolved photocurrent measurements, we conclude that the photocurrent generation process depends strongly on the p +-segment length. Without p +-segment in the NWs, photogenerated carriers funneled from the substrate into the NWs contribute significantly to the photocurrent. Adding a p +-segment shifts the depletion region up into the i-region of the NWs reducing the substrate contribution to photocurrent while strongly improving the collections of carriers generated in the NWs, in agreement with theoretical modeling (Fig. 48.1). © Springer Science+Business Media Dordrecht 2015.
|
|
| 4. |
- Landin, L., et al.
(författare)
-
Interband transitions in InAs quantum dots in InP studied by photoconductivity and photoluminescence techniques
- 2004
-
Ingår i: Journal of Applied Physics. - Melville : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 95:12, s. 8007-8010
-
Tidskriftsartikel (refereegranskat)abstract
- We report on a detailed investigation of the interband optics of self-assembled InAs dots embedded in a matrix of InP. In photoconductivity (PC) measurements, we observe optical processes related to the dots and a wetting layer, band-to-band excitation of the InP barrier, as well as to an interesting As-related impurity. In particular, the PC measurements reveal the electronic structure of the dots and strongly suggest that an Auger effect is involved in forming the PC signal. Comparing the PC and photoluminescence (PL) signals, we observe that the fundamental transition is not observed in PC, which we interpret in terms of Pauli blocking due to electrons populating the ground state of the dots. In general, it is demonstrated that the PC technique is in many respects complementary to PL and gives additional insight into the electronic structure of quantum dots.
|
|
| 5. |
- Liu, Ruisheng, et al.
(författare)
-
Large magnetoresistance in Co/Ni/Co ferromagnetic single electron transistors
- 2007
-
Ingår i: Applied Physics Letters. - New York : American Institute of Physics. - 0003-6951 .- 1077-3118. ; 90:12, s. 123111-
-
Tidskriftsartikel (refereegranskat)abstract
- The authors report on magnetotransport investigations of nanoscaled ferromagnetic Co/Ni/Co single electron transistors. As a result of reduced size, the devices exhibit single electron transistor characteristics at 4.2 K. Magnetotransport measurements carried out at 1.8 K reveal tunneling magnetoresistance (TMR) traces with negative coercive fields, which the authors interpret in terms of a switching mechanism driven by the shape anisotropy of the central wirelike Ni island. A large TMR of about 18% is observed within a finite source-drain bias regime. The TMR decreases rapidly with increasing bias, which the authors tentatively attribute to excitation of magnons in the central island.
|
|
| 6. |
- Liu, Ruisheng, et al.
(författare)
-
Probing spin accumulation in Ni/Au/Ni single-electron transistors with efficient spin injection and detection electrodes
- 2007
-
Ingår i: Nano letters (Print). - Washington, DC : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 7:1, s. 81-85
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated spin accumulation in Ni/Au/Ni single-electron transistors assembled by atomic force microscopy. The fabrication technique is unique in that unconventional hybrid devices can be realized with unprecedented control, including real-time tunable tunnel resistances. A grid of Au disks, 30 nm in diameter and 30 nm thick, is prepared on a SiO2 surface by conventional e-beam writing. Subsequently, 30 nm thick ferromagnetic Ni source, drain, and side-gate electrodes are formed in similar process steps. The width and length of the source and drain electrodes were different to exhibit different coercive switching fields. Tunnel barriers of NiO are realized by sequential Ar and O2 plasma treatment. By use of an atomic force microscope with specially designed software, a single nonmagnetic Au nanodisk is positioned into the 25 nm gap between the source and drain electrodes. The resistance of the device is monitored in real time while the Au disk is manipulated step-by-step with angstrom-level precision. Transport measurements in magnetic field at 1.7 K reveal no clear spin accumulation in the device, which can be attributed to fast spin relaxation in the Au disk. From numerical simulations using the rate-equation approach of orthodox Coulomb blockade theory, we can put an upper bound of a few nanoseconds on the spin-relaxation time for electrons in the Au disk. To confirm the magnetic switching characteristics and spin injection efficiency of the Ni electrodes, we fabricated a test structure consisting of a Ni/NiO/Ni magnetic tunnel junction with asymmetric dimensions of the electrodes similar to those of the single-electron transistors. Magnetoresistance measurements on the test device exhibited clear signs of magnetic reversal and a maximum tunneling magnetoresistance of 10%, from which we deduced a spin polarization of about 22% in the Ni electrodes. © 2007 American Chemical Society.
|
|
| 7. |
- Liu, Ruisheng, et al.
(författare)
-
Tunneling anisotropic magnetoresistance in Co/AlOx/Au tunnel junctions
- 2008
-
Ingår i: Nano letters (Print). - Washington : American Chemical Society. - 1530-6984 .- 1530-6992. ; 8:3, s. 848-852
-
Tidskriftsartikel (refereegranskat)abstract
- We observe spin-valve-like effects in nanoscaled thermally evaporated Co/AlOx/Au tunnel junctions. The tunneling magnetoresistance is anisotropic and depends on the relative orientation of the magnetization direction of the Co electrode with respect to the current direction. We attribute this effect to a two-step magnetization reversal and an anisotropic density of states resulting from spin-orbit interaction. The results of this study points to future applications of novel spintronics devices involving only one ferromagnetic layer.
|
|
| 8. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Case study of an InAs quantum dot memory : Optical storing and deletion of charge
- 2001
-
Ingår i: Applied Physics Letters. - New York : American Institute of Physics (AIP). - 0003-6951 .- 1077-3118. ; 79:1, s. 78-80
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied self-assembled InAs quantum dots embedded in an InP matrix using photocapacitance and photocurrent spectroscopy. These dots are potentially promising for memories due to the large confinement energy for holes. In this work we have realized simple quantum dot memory by placing the dots in the space–charge region of a Schottky junction. Our measurements reveal that a maximum of about one hole can be stored per dot. We also find that illumination for an extended period deletes the stored charge. We show that these limitations do not reflect the intrinsic properties of the dots, but rather the sample structure in combination with deep traps present in the sample.
|
|
