| 1. |
- Al-Adili, Ali, et al.
(författare)
-
Neutron-multiplicity experiments for enhanced fission modelling
- 2017
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 9782759890200
-
Konferensbidrag (refereegranskat)abstract
- The nuclear de-excitation process of fission fragments (FF) provides fundamental information for the understanding of nuclear fission and nuclear structure in neutron-rich isotopes. The variation of the prompt-neutron multiplicity, ν(A), as a function of the incident neutron energy (En) is one of many open questions. It leads to significantly different treatments in various fission models and implies that experimental data are analyzed based on contradicting assumptions. One critical question is whether the additional excitation energy (Eexc) is manifested through an increase of ν(A) for all fragments or for the heavy ones only. A systematic investigation of ν(A) as a function of En has been initiated. Correlations between prompt-fission neutrons and fission fragments are obtained by using liquid scintillators in conjunction with a Frisch-grid ionization chamber. The proof-of-principle has been achieved on the reaction 235U(nth,f) at the Van De Graff (VdG) accelerator of the JRC-Geel using a fully digital data acquisition system. Neutrons from 252Cf(sf) were measured separately to quantify the neutron-scattering component due to surrounding shielding material and to determine the intrinsic detector efficiency. Prelimenary results on ν(A) and spectrum in correlation with FF properties are presented.
|
|
| 2. |
- Al-Adili, Ali, et al.
(författare)
-
Studying fission neutrons with 2E-2v and 2E
- 2018
-
Ingår i: SCIENTIFIC WORKSHOP ON NUCLEAR FISSION DYNAMICS AND THE EMISSION OF PROMPT NEUTRONS AND GAMMA RAYS (THEORY-4). - : EDP Sciences. - 9782759890316
-
Konferensbidrag (refereegranskat)abstract
- This work aims at measuring prompt-fission neutrons at different excitation energies of the nucleus. Two independent techniques, the 2E-2v and the 2E techniques, are used to map the characteristics of the mass-dependent prompt fission neutron multiplicity, 7(A), when the excitation energy is increased. The VERDI 2E-2v spectrometer is being developed at JRC-GEEL. The Fission Fragment (FF) energies are measured using two arrays of 16 silicon (Si) detectors each. The FFs velocities are obtained by time-of-flight, measured between micro-channel plates (MCP) and Si detectors. With MCPs placed on both sides of the fission source, VERDI allows for independent timing measurements for both fragments. Cf-252(sf) was measured and the present results revealed particular features of the 2E-2v technique. Dedicated simulations were also performed using the GEF code to study important aspects of the 2E-2v technique. Our simulations show that prompt neutron emission has a non-negligible impact on the deduced fragment data and affects also the shape of 17(A). Geometrical constraints lead to a total-kinetic energy-dependent detection efficiency. The 2E technique utilizes an ionization chamber together with two liquid scintillator detectors. Two measurements have been performed, one of Cf-252(sf) and another one of thermal-neutron induced fission in U-235(n,f). Results from Cf-252(sf) are reported here.
|
|
| 3. |
- Al-Adili, Ali, et al.
(författare)
-
Analysis of prompt fission neutrons in U-235(nth,f) and fission fragment distributions for the thermal neutron induced fission of U-234
- 2016
-
Ingår i: CNR*15 - 5th International Workshop On Compound-Nuclear Reactions And Related Topics. - : EDP Sciences.
-
Konferensbidrag (refereegranskat)abstract
- This paper presents the ongoing analysis of two fission experiments. Both projects are part of the collaboration between the nuclear reactions group at Uppsala and the JRC-IRMM. The first experiment deals with the prompt fission neutron multiplicity in the thermal neutron induced fission of U-235(n,f). The second, on the fission fragment properties in the thermal fission of U-234(n,f). The prompt fission neutron multiplicity has been measured at the JRC-IRMM using two liquid scintillators in coincidence with an ionization chamber. The first experimental campaign focused on U-235(nth,f) whereas a second experimental campaign is foreseen later for the same reaction at 5.5 MeV. The goal is to investigate how the so-called saw-tooth shape changes as a function of fragment mass and excitation energy. Some harsh experimental conditions were experienced due to the large radiation background. The solution to this will be discussed along with preliminary results. In addition, the analysis of thermal neutron induced fission of U-234(n,f) will be discussed. Currently analysis of data is ongoing, originally taken at the ILL reactor. The experiment is of particular interest since no measurement exist of the mass and energy distributions for this system at thermal energies. One main problem encountered during analysis was the huge background of U-235(nth, f). Despite the negligible isotopic traces in the sample, the cross section difference is enormous. Solution to this parasitic background will be highlighted.
|
|
| 4. |
- Al-Adili, Ali, et al.
(författare)
-
Fission Activities of the Nuclear Reactions Group in Uppsala
- 2015
-
Ingår i: Scientific Workshop on Nuclear Fission Dynamics and the Emission of Prompt Neutrons and Gamma Rays, THEORY-3. - : Elsevier BV. ; , s. 145-149
-
Konferensbidrag (refereegranskat)abstract
- This paper highlights some of the main activities related to fission of the nuclear reactions group at Uppsala University. The group is involved for instance in fission yield experiments at the IGISOL facility, cross-section measurements at the NFS facility, as well as fission dynamics studies at the IRMM JRC-EC. Moreover, work is ongoing on the Total Monte Carlo (TMC) methodology and on including the GEF fission code into the TALYS nuclear reaction code. Selected results from these projects are discussed.
|
|
| 5. |
- Al-Adili, Ali, et al.
(författare)
-
Ion counting efficiencies at the IGISOL facility
- 2014
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- At the IGISOL-JYFLTRAP facility, fission mass yields can be studied at high precision. Fission fragments from a U target are passing through a Ni foil and entering a gas filled chamber. The collected fragments are guided through a mass separator to a Penning trap where their masses are identified. This simulation work focuses on how different fission fragment properties (mass, charge and energy) affect the stopping efficiency in the gas cell. In addition, different experimental parameters are varied (e. g. U and Ni thickness and He gas pressure) to study their impact on the stopping efficiency. The simulations were performed using the Geant4 package and the SRIM code. The main results suggest a small variation in the stopping efficiency as a function of mass, charge and kinetic energy. It is predicted that heavy fragments are stopped about 9% less efficiently than the light fragments. However it was found that the properties of the U, Ni and the He gas influences this behavior. Hence it could be possible to optimize the efficiency.
|
|
| 6. |
- Al-Adili, Ali, et al.
(författare)
-
Isomer yields in nuclear fission
- 2021
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 2100-014X. ; 256
-
Tidskriftsartikel (refereegranskat)abstract
- The generation of angular momentum in the fission process is still an open question. To shed light on this topic, we started a series of measurements at the IGISOL-JYFLTRAP facility in Finland. Highprecision measurements of isomeric yield ratios (IYR) are performed with a Penning trap, partly with the aim to extract average root-mean-square (rms) quantities of fragment spin distributions. The newly installed Phase-Imaging Ion-Cyclotron Resonance (PI-ICR) technique allows the separation of masses down to tens of keV, which is suffcient to disentangle many isomers. In this paper, we first summarize the previous measurements on the neutron and proton-induced fission of uranium and thorium, e.g. the odd cadmium and indium isotopes (119 ≤ A ≤ 127). The measurements revealed systematic trends as function of mass number, which stimulated further exploration. A recent measurement was performed at IGISIOL and several new IYR data will soon be published, for the first time. Secondly, we employ the TALYS nuclear-reaction code to model one of the newly measured isomer yields. Detailed GEF and TALYS calculations are discussed for the fragment angular momentum distribution in 134I.
|
|
| 7. |
- Al-Adili, Ali, et al.
(författare)
-
Simulations of the fission-product stopping efficiency in IGISOL
- 2015
-
Ingår i: European Physical Journal A. - : Springer Science and Business Media LLC. - 1434-6001 .- 1434-601X. ; 51:59, s. 1-7
-
Tidskriftsartikel (refereegranskat)abstract
- At the Jyväskylä Ion Guide Isotope Separator On-Line (IGISOL) facility, independent fission yields are measured employing the Penning-trap technique. Fission products are produced, e.g. by impinging protons on a uranium target, and are stopped in a gas-filled chamber. The products are collected by a flow of He gas and guided through a mass separator to a Penning trap, where their masses are identified. This work investigates how fission-product properties, such as mass and energy, affect the ion stopping efficiency in the gas cell. The study was performed using the Geant4 toolkit and the SRIM code. The main results show a nearly mass-independent ion stopping with regard to the wide spread of ion masses and energies, with a proper choice of uranium target thickness. Although small variations were observed, in the order of 5%, the results are within the systematic uncertainties of the simulations. To optimize the stopping efficiency while reducing the systematic errors, different experimental parameters were varied; for instance material thicknesses and He gas pressure. Different parameters influence the mass dependence and could alter the mass dependencies in the ion stopping efficiency.
|
|
| 8. |
- Gao, Zhihao, et al.
(författare)
-
Applying machine learning methods for the analysis of two-dimensional mass spectra
- 2023
-
Ingår i: European Physical Journal A. - : Springer Nature. - 1434-6001 .- 1434-601X. ; 59:169
-
Tidskriftsartikel (refereegranskat)abstract
- In a measurement of isomeric yield-ratios in fission, the Phase-Imaging Ion-Cyclotron-Resonance technique, which projects the radial motions of ions in the Penning trap (JYFLTRAP) onto a position-sensitive micro-channel plate detector, has been applied. To obtain the yield ratio, that is the relative population of two states of an isomer pair, a novel analysis procedure has been developed to determine the number of detected ions in each state, as well as corrections for the detector efficiency and decay losses. In order to determine the population of the states in cases where their mass difference is too small to reach full separation, a Bayesian Gaussian Mixture model was implemented. The position-dependent efficiency of the micro-channel plate detector was calibrated by mapping it with 133Cs+ ions, and a Gaussian Process was trained with the position data to construct an efficiency function that could be used to correct the recorded distributions. The obtained numbers of counts of excited and ground-state ions were used to derive the isomeric yield ratio, taking into account decay losses as well as feeding from precursors.
|
|
| 9. |
- Gao, Zhihao, et al.
(författare)
-
Benchmark of a multi-physics Monte Carlo simulation of an ionguide for neutron-induced fission products
- 2022
-
Ingår i: European Physical Journal. - : Springer Nature. - 1286-0042 .- 1286-0050. ; 58:2
-
Tidskriftsartikel (refereegranskat)abstract
- To enhance the production of medium-heavy,neutron-rich nuclei, and to facilitate measurements of independentyields of neutron-induced fission, a proton-toneutronconverter and a dedicated ion guide for neutroninducedfission have been developed for the IGISOL facilityat the University of Jyväskylä. The ion guide holds thefissionable targets, and the fission products emerging fromthe targets are collected in helium gas and transported to thedownstream experimental stations.Acomputer model, basedon a combination of MCNPX for modeling the neutron production,the fission code GEF, and GEANT4 for the transportof the fission products, was developed. The model willbe used to improve the setup with respect to the productionand collection of fission products. In this paper we benchmarkthe model by comparing simulations to a measurementin which fission products were implanted in foils located atdifferent positions in the ion guide. In addition, the productsfrom neutron activation in the titanium foil and the uraniumtargets are studied. The result suggests that the neutron fluxat the high-energy part of the neutron spectrum is overestimatedby approximately 40%.However, the transportation offission products in the uranium targets agrees with the experimentwithin 10%. Furthermore, the simulated transportationof fission products in the helium gas achieves almost perfectagreement with the measurement. Hence, we conclude thatthe model, after correction for the neutron flux, is well suitedfor optimization studies of future ion guide designs.
|
|
| 10. |
- Gao, Zhihao, et al.
(författare)
-
Fission studies at IGISOL/JYFLTRAP : Simulations of the ion guide for neutron-induced fission and comparison with experimental data
- 2020
-
Ingår i: ND 2019. - : EDP Sciences. - 9782759891061
-
Konferensbidrag (refereegranskat)abstract
- For the production of exotic nuclei at the IGISOL facility, an ion guide for neutron-induced fission has been developed and tested in experiments. Fission fragments are produced inside the ion guide and collected using a helium buffer gas. Meanwhile, a GEANT4 model has been developed to simulate the transportation and stopping of the charged fission products. In a recent measurement of neutron-induced fission yields, implantation foils were located at different positions in the ion guide. The gamma spectra from these foils and the fission targets are compared to the results from the GEANT4 simulation.In order to allow fission yield measurements in the low yield regions, towards the tails and in the symmetric part of the mass distribution, the stopping and extraction efficiency of the ion guide has to be significantly improved. This objective can be achieved by increasing the size while introducing electric field guidance using a combination of static electrodes and an RF-carpet. To this end, the GEANT4 model is used to optimise the design of such an ion guide.
|
|
