| 1. |
- Meyer, H.F., et al.
(författare)
-
Overview of physics studies on ASDEX Upgrade
- 2019
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 59:11
-
Forskningsöversikt (refereegranskat)abstract
- The ASDEX Upgrade (AUG) programme, jointly run with the EUROfusion MST1 task force, continues to significantly enhance the physics base of ITER and DEMO. Here, the full tungsten wall is a key asset for extrapolating to future devices. The high overall heating power, flexible heating mix and comprehensive diagnostic set allows studies ranging from mimicking the scrape-off-layer and divertor conditions of ITER and DEMO at high density to fully non-inductive operation (q 95 = 5.5, ) at low density. Higher installed electron cyclotron resonance heating power 6 MW, new diagnostics and improved analysis techniques have further enhanced the capabilities of AUG. Stable high-density H-modes with MW m-1 with fully detached strike-points have been demonstrated. The ballooning instability close to the separatrix has been identified as a potential cause leading to the H-mode density limit and is also found to play an important role for the access to small edge-localized modes (ELMs). Density limit disruptions have been successfully avoided using a path-oriented approach to disruption handling and progress has been made in understanding the dissipation and avoidance of runaway electron beams. ELM suppression with resonant magnetic perturbations is now routinely achieved reaching transiently . This gives new insight into the field penetration physics, in particular with respect to plasma flows. Modelling agrees well with plasma response measurements and a helically localised ballooning structure observed prior to the ELM is evidence for the changed edge stability due to the magnetic perturbations. The impact of 3D perturbations on heat load patterns and fast-ion losses have been further elaborated. Progress has also been made in understanding the ELM cycle itself. Here, new fast measurements of and E r allow for inter ELM transport analysis confirming that E r is dominated by the diamagnetic term even for fast timescales. New analysis techniques allow detailed comparison of the ELM crash and are in good agreement with nonlinear MHD modelling. The observation of accelerated ions during the ELM crash can be seen as evidence for the reconnection during the ELM. As type-I ELMs (even mitigated) are likely not a viable operational regime in DEMO studies of 'natural' no ELM regimes have been extended. Stable I-modes up to have been characterised using -feedback. Core physics has been advanced by more detailed characterisation of the turbulence with new measurements such as the eddy tilt angle - measured for the first time - or the cross-phase angle of and fluctuations. These new data put strong constraints on gyro-kinetic turbulence modelling. In addition, carefully executed studies in different main species (H, D and He) and with different heating mixes highlight the importance of the collisional energy exchange for interpreting energy confinement. A new regime with a hollow profile now gives access to regimes mimicking aspects of burning plasma conditions and lead to nonlinear interactions of energetic particle modes despite the sub-Alfvénic beam energy. This will help to validate the fast-ion codes for predicting ITER and DEMO.
|
|
| 2. |
- Schneppenheim, Reinhard, et al.
(författare)
-
A common origin of the 4143insA ADAMTS13 mutation
- 2006
-
Ingår i: Thrombosis and Haemostasis. - 0340-6245. ; 96:1, s. 3-6
-
Tidskriftsartikel (refereegranskat)abstract
- Severely deficient activity of the von Willebrand Factor (VWF) cleaving metalloprotease,ADAMTS 13, is associated with thrombotic thrombocytopenic purpura (TTP). The mutation spectrum ofADAMTS 13 is rather heterogeneous, and numerous mutations spread across the gene have been described in association with congenital TTP. The 4143insA mutation is unusual with respect to its geographic concentration. Following the initial report from Germany in which the 4143insA mutation was detected in four apparently unrelated families, we have now identified this mutation in a further eleven patients from Norway, Sweden, Poland, Germany, the Czech Republic and Australia. Confirmation that the Australian patient is of German ancestry, together with the Northern and Central European origin of most of the other patients, suggests that the 4143insA mutation has a common genetic background.We established ADAMTS 13 haplotypes by analyzing 17 polymorphic intragenic markers.The haplotypes linked to 4143insA were identical in all informative families. Three novel candidate mutations, C347S, P67IL and RI060W, as well as the known mutation R507Q, were also identified during the course of the study.We conclude that 4143insA has a common genetic background and is frequent among patients with hereditary ADAMTS 13 deficiency in Northern and Central European countries.
|
|
