| 1. |
- Belitsky, Victor, 1955, et al.
(författare)
-
ALMA Band 2 Cold Cartridge Assembly Design
- 2022
-
Ingår i: 32nd International Symposium of Space Terahertz Technology, ISSTT 2022.
-
Konferensbidrag (refereegranskat)abstract
- As part of the ALMA development, we present the design of the ALMA Band 2 Cold Cartridge Assembly (CCA). The Band 2 is the last band that completes the suit of the 10 receiver channels of ALMA. The originally planned ALMA Band 2 receiver cartridge should cover the RF band of 67 - -90 GHz. The recent progress in technology, optics, OMT design and mm-wave amplifiers, however allowed to implement receiver that has an extended RF band up to 116 GHz. Furthermore, the Band 2 receiver pursues 2SB layout and provides 4-18 GHz IF band for two sidebands in a dual-polarization configuration. Here, we describe the design of the Band 2 CCA that includes optics, amplifier assembly, internal RF transport, mechanics and cryogenics. The downconverter part and performances are described elsewhere.
|
|
| 2. |
- Persson, Bertil, et al.
(författare)
-
Creep of Heat-cured High-Performance Concrete Subjected to Freezing or Elevated Temperatures
- 1998
-
Ingår i: Concrete under Severe Conditions - Environmental and Loading. ; , s. 1616-1626
-
Konferensbidrag (refereegranskat)abstract
- This article outlines an experimental and numerical study of the short-term creep of High-Performance Concrete, HPC, with sealed curing and temperature under freezing point, which is compared with the creep of HPC at normal and elevated temperatures. For this purpose one quality of HPC was studied at 6 different temperatures (-15, -1, 20, 30, 40 and 60 °C) over a period of 66 hours. Parallel studies of both autogenous and drying long-term creep after heat curing were carried out. New and original results and analyses of the effect of temperature as regards compressive creep of HPC are pre-sented. At -1 °C in the concrete, a loading level as low as 25% of the ultimate loading was needed to perform the creep tests properly. At -15 °C HPC withstood at least 43% of the ultimate loading during creep test. The study was carried out from 1992 to 1994.
|
|
| 3. |
- Minelli, Caterina, et al.
(författare)
-
Versailles project on advanced materials and standards (VAMAS) interlaboratory study on measuring the number concentration of colloidal gold nanoparticles
- 2022
-
Ingår i: Nanoscale. - : Royal Society of Chemistry (RSC). - 2040-3372 .- 2040-3364. ; 14, s. 4690-4704
-
Tidskriftsartikel (refereegranskat)abstract
- We describe the outcome of a large international interlaboratory study of the measurement of particle number concentration of colloidal nanoparticles, project 10 of the technical working area 34, "Nanoparticle Populations" of the Versailles Project on Advanced Materials and Standards (VAMAS). A total of 50 laboratories delivered results for the number concentration of 30 nm gold colloidal nanoparticles measured using particle tracking analysis (PTA), single particle inductively coupled plasma mass spectrometry (spICP-MS), ultraviolet-visible (UV-Vis) light spectroscopy, centrifugal liquid sedimentation (CLS) and small angle X-ray scattering (SAXS). The study provides quantitative data to evaluate the repeatability of these methods and their reproducibility in the measurement of number concentration of model nanoparticle systems following a common measurement protocol. We find that the population-averaging methods of SAXS, CLS and UV-Vis have high measurement repeatability and reproducibility, with between-labs variability of 2.6%, 11% and 1.4% respectively. However, results may be significantly biased for reasons including inaccurate material properties whose values are used to compute the number concentration. Particle-counting method results are less reproducibile than population-averaging methods, with measured between-labs variability of 68% and 46% for PTA and spICP-MS respectively. This study provides the stakeholder community with important comparative data to underpin measurement reproducibility and method validation for number concentration of nanoparticles.
|
|
