| 1. |
|
|
| 2. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 3. |
- Abele, H., et al.
(författare)
-
Particle physics at the European Spallation Source
- 2023
-
Ingår i: Physics reports. - : Elsevier. - 0370-1573 .- 1873-6270. ; 1023, s. 1-84
-
Forskningsöversikt (refereegranskat)abstract
- Presently under construction in Lund, Sweden, the European Spallation Source (ESS) will be the world’s brightest neutron source. As such, it has the potential for a particle physics program with a unique reach and which is complementary to that available at other facilities. This paper describes proposed particle physics activities for the ESS. These encompass the exploitation of both the neutrons and neutrinos produced at the ESS for high precision (sensitivity) measurements (searches).
|
|
| 4. |
- Carlsson, Ella, et al.
(författare)
-
Mass composition of the escaping plasma at Mars
- 2006
-
Ingår i: Icarus. - : Elsevier BV. - 0019-1035 .- 1090-2643. ; 182:2, s. 320-328
-
Tidskriftsartikel (refereegranskat)abstract
- Data from the Ion Mass Analyzer (IMA) sensor of the ASPERA-3 instrument suite on Mars Express have been analyzed to determine the mass composition of the escaping ion species at Mars. We have examined 77 different ion-beam events and we present the results in terms of flux ratios between the following ion species: CO2+/O+ and O-2(+)/O+. The following ratios averaged over all events and energies were identified: CO2+/O+ = 0.2 and O-2(+)/O+ = 0.9. The values measured are significantly higher, by a factor of 10 for O-2(+)/O+, than a contemporary modeled ratio for the maximum fluxes which the martian ionosphere can supply. The most abundant ion species was found to be O+, followed by O-2(+) and CO2+. We estimate the loss of CO2+ to be 4.0 x 10(24) s(-1) (0.29 kg s(-1)) by using the previous measurements of Phobos-2 in our calculations. The dependence of the ion ratios in relation to their energy ranges we studied, 0.3-3.0 keV, indicated that no clear correlation was found.
|
|
| 5. |
|
|
| 6. |
- Harri, A.-M., et al.
(författare)
-
Mars Science Laboratory relative humidity observations: Initial results
- 2014
-
Ingår i: Journal of Geophysical Research - Planets. - 2169-9097 .- 2169-9100. ; 119:9, s. 2132-2147
-
Tidskriftsartikel (refereegranskat)abstract
- The Mars Science Laboratory (MSL) made a successful landing at Gale crater early August 2012. MSL has an environmental instrument package called the Rover Environmental Monitoring Station (REMS) as a part of its scientific payload. REMS comprises instrumentation for the observation of atmospheric pressure, temperature of the air, ground temperature, wind speed and direction, relative humidity (REMS-H), and UV measurements. We concentrate on describing the REMS-H measurement performance and initial observations during the first 100 MSL sols as well as constraining the REMS-H results by comparing them with earlier observations and modeling results. The REMS-H device is based on polymeric capacitive humidity sensors developed by Vaisala Inc., and it makes use of transducer electronics section placed in the vicinity of the three humidity sensor heads. The humidity device is mounted on the REMS boom providing ventilation with the ambient atmosphere through a filter protecting the device from airborne dust. The final relative humidity results appear to be convincing and are aligned with earlier indirect observations of the total atmospheric precipitable water content. The water mixing ratio in the atmospheric surface layer appears to vary between 30 and 75 ppm. When assuming uniform mixing, the precipitable water content of the atmosphere is ranging from a few to six precipitable micrometers.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Prikhna, T., et al.
(författare)
-
Effects of high pressure on the physical properties of MgB2
- 2011
-
Ingår i: Journal of Superconductivity and Novel Magnetism. - : Springer Science and Business Media LLC. - 1557-1939 .- 1557-1947. ; 24:5, s. 137-150
-
Tidskriftsartikel (refereegranskat)abstract
- The synthesis of MgB2-based materials under high pressure gave the possibility to suppress the evaporation of magnesium and to obtain near theoretically dense nanograined structures with high superconducting, thermal conducting, and mechanical characteristics: critical current densities of 1.8-1.0×106 A/cm2 in the self-field and 103 A/cm2 in a magnetic field of 8 T at 20 K, 5-3×105 A/cm2 in self-field at 30 K, the corresponding critical fields being Hc2=15 T at 22 K and irreversible fields Hirr=13 T at 20 K, and Hirr=3.5 T at 30 K, thermal conduction of 53±2 W/(m{dot operator}K), the Vickers hardness HV=10.12±0.2 GPa under a load of 148.8 N and the fracture toughness K1 C=7.6±2.0 MPa{dot operator}m0.5 under the same load, the Young modulus E=213 GPa. Estimation of quenching current and AC losses allowed the conclusion that high-pressure-prepared materials are promising for application in transformer-type fault current limiters working at 20-30 K.
|
|
