SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Simion S.) "

Sökning: WFRF:(Simion S.)

  • Resultat 1-8 av 8
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Abat, E., et al. (författare)
  • Study of the response of the ATLAS central calorimeter to pions of energies from 3 to 9 GeV
  • 2009
  • Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - Elsevier. - 0167-5087. ; 607:2, s. 372-386
  • Tidskriftsartikel (refereegranskat)abstract
    • A fully instrumented slice of the ATLAS central detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. in this paper, the response of the central calorimeters to pions with energies in the range between 3 and 9 GeV is presented. The linearity and the resolution of the combined calorimetry (electromagnetic and hadronic calorimeters) was measured and compared to the prediction of a detector simulation program using the toolkit Geant 4. (C) 2009 Elsevier B.V. All rights reserved.
  •  
2.
  • Abata, E., et al. (författare)
  • Study of energy response and resolution of the ATLAS barrel calorimeter to hadrons of energies from 20 to 350 GeV
  • 2010
  • Ingår i: Nuclear Instruments and Methods in Physics Research Section A : Accelerators, Spectrometers, Detectors and Associated Equipment. - Elsevier. - 0168-9002 .- 1872-9576. ; 621:1-3, s. 134-150
  • Tidskriftsartikel (refereegranskat)abstract
    • <p>A fully instrumented slice of the ATLAS detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. In this paper, the results of the measurements of the response of the barrel calorimeter to hadrons with energies in the range 20-350 GeV and beam impact points and angles corresponding to pseudo-rapidity values in the range 0.2-0.65 are reported. The results are compared to the predictions of a simulation program using the Geant 4 toolkit. (C) 2010 Published by Elsevier B.V.</p>
  •  
3.
  • Abata, E., et al. (författare)
  • Study of energy response and resolution of the ATLAS barrel calorimeter to hadrons of energies from 20 to 350 GeV
  • 2010
  • Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - Elsevier. - 0167-5087. ; 621:1-3, s. 134-150
  • Tidskriftsartikel (refereegranskat)abstract
    • A fully instrumented slice of the ATLAS detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. In this paper, the results of the measurements of the response of the barrel calorimeter to hadrons with energies in the range 20-350 GeV and beam impact points and angles corresponding to pseudo-rapidity values in the range 0.2-0.65 are reported. The results are compared to the predictions of a simulation program using the Geant 4 toolkit. (C) 2010 Published by Elsevier B.V.
  •  
4.
  • Allaire, C., et al. (författare)
  • Beam test measurements of Low Gain Avalanche Detector single pads and arrays for the ATLAS High Granularity Timing Detector
  • 2018
  • Ingår i: Journal of Instrumentation. - Institute of Physics (IOP). - 1748-0221 .- 1748-0221. ; 13
  • Tidskriftsartikel (refereegranskat)abstract
    • <p>For the high luminosity upgrade of the LHC at CERN, ATLAS is considering the addition of a High Granularity Timing Detector (HGTD) in front of the end cap and forward calorimeters at vertical bar z vertical bar = 3:5 m and covering the region 2:4 &lt; vertical bar eta vertical bar &lt; 4 to help reducing the effect of pile-up. The chosen sensors are arrays of 50 mu m thin Low Gain Avalanche Detectors (LGAD). This paper presents results on single LGAD sensors with a surface area of 1.3 x 1.3 mm(2) and arrays with 2 x 2 pads with a surface area of 2 x 2 mm(2) or 3 x 3 mm(2) each and different implant doses of the p(+) multiplication layer. They are obtained from data collected during a beam test campaign in autumn 2016 with a pion beam of 120 GeV energy at the CERN SPS. In addition to several quantities measured inclusively for each pad, the gain, efficiency and time resolution have been estimated as a function of the position of the incident particle inside the pad by using a beam telescope with a position resolution of few mu m. Different methods to measure the time resolution are compared, yielding consistent results. The sensors with a surface area of 1.3 x 1.3 mm(2) have a time resolution of about 40 ps for a gain of 20 and of about 27 ps for a gain of 50 and fulfil the HGTD requirements. Larger sensors have, as expected, a degraded time resolution. All sensors show very good efficiency and time resolution uniformity.</p>
  •  
5.
  • Antonova, M., et al. (författare)
  • Baby MIND : a magnetized segmented neutrino detector for the WAGASCI experiment
  • 2017
  • Ingår i: Journal of Instrumentation. - Institute of Physics (IOP). - 1748-0221 .- 1748-0221. ; 12:07, s. 1-6
  • Tidskriftsartikel (refereegranskat)abstract
    • <p>T2K (Tokai-to-Kamioka) is a long-baseline neutrino experiment in Japan designed to study various parameters of neutrino oscillations. A near detector complex (ND280) is located 280 m downstream of the production target and measures neutrino beam parameters before any oscillations occur. ND280’s measurements are used to predict the number and spectra of neutrinos in the Super-Kamiokande detector at the distance of 295 km. The difference in the target material between the far (water) and near (scintillator, hydrocarbon) detectors leads to the main non-cancelling systematic uncertainty for the oscillation analysis. In order to reduce this uncertainty a new WAter-Grid-And-SCintillator detector (WAGASCI) has been developed. A magnetized iron neutrino detector (Baby MIND) will be used to measure momentum and charge identification of the outgoing muons from charged current interactions. The Baby MIND modules are composed of magnetized iron plates and long plastic scintillator bars read out at the both ends with wavelength shifting fibers and silicon photomultipliers. The front-end electronics board has been developed to perform the readout and digitization of the signals from the scintillator bars. Detector elements were tested with cosmic rays and in the PS beam at CERN. The obtained results are presented in this paper.</p>
  •  
6.
  • Jepsen, S., et al. (författare)
  • Regeneration of alveolar ridge defects. Consensus report of group 4 of the 15th European Workshop on Periodontology on Bone Regeneration
  • 2019
  • Ingår i: Journal of Clinical Periodontology. - 0303-6979. ; 46, s. 277-286
  • Tidskriftsartikel (refereegranskat)abstract
    • Background and Aims Bone augmentation procedures to enable dental implant placement are frequently performed. The remit of this working group was to evaluate the current evidence on the efficacy of regenerative measures for the reconstruction of alveolar ridge defects. Material and Methods The discussions were based on four systematic reviews focusing on lateral bone augmentation with implant placement at a later stage, vertical bone augmentation, reconstructive treatment of peri-implantitis associated defects, and long-term results of lateral window sinus augmentation procedures. Results A substantial body of evidence supports lateral bone augmentation prior to implant placement as a predictable procedure in order to gain sufficient ridge width for implant placement. Also, vertical ridge augmentation procedures were in many studies shown to be effective in treating deficient alveolar ridges to allow for dental implant placement. However, for both procedures the rate of associated complications was high. The adjunctive benefit of reconstructive measures for the treatment of peri-implantitis-related bone defects has only been assessed in a few RCTs. Meta-analyses demonstrated a benefit with regard to radiographic bone gain but not for clinical outcomes. Lateral window sinus floor augmentation was shown to be a reliable procedure in the long term for the partially and fully edentulous maxilla. Conclusions The evaluated bone augmentation procedures were proven to be effective for the reconstruction of alveolar ridge defects. However, some procedures are demanding and bear a higher risk for post-operative complications.
  •  
7.
  • Jepsen, S, et al. (författare)
  • Regenration of alveolar ridge defects : Consensus report of group 4 of the 15th European Workshop on Periodontology on Bone Regeneration
  • 2019
  • Ingår i: Journal of Clinical Periodontology. - 0303-6979 .- 1600-051X. ; 46, s. 277-286
  • Tidskriftsartikel (refereegranskat)abstract
    • <p><strong>BACKGROUND AND AIMS:</strong> Bone augmentation procedures to enable dental implant placement are frequently performed. The remit of this working group was to evaluate the current evidence on the efficacy of regenerative measures for the reconstruction of alveolar ridge defects.</p><p><strong>MATERIAL AND METHODS:</strong> The discussions were based on four systematic reviews focusing on lateral bone augmentation with implant placement at a later stage, vertical bone augmentation, reconstructive treatment of peri-implantitis associated defects, and long-term results of lateral window sinus augmentation procedures.</p><p><strong>RESULTS:</strong> A substantial body of evidence supports lateral bone augmentation prior to implant placement as a predictable procedure in order to gain sufficient ridge width for implant placement. Also, vertical ridge augmentation procedures were in many studies shown to be effective in treating deficient alveolar ridges to allow for dental implant placement. However, for both procedures the rate of associated complications was high. The adjunctive benefit of reconstructive measures for the treatment of peri-implantitis-related bone defects has only been assessed in a few RCTs. Meta-analyses demonstrated a benefit with regard to radiographic bone gain but not for clinical outcomes. Lateral window sinus floor augmentation was shown to be a reliable procedure in the long-term for the partially and fully edentulous maxilla.</p><p><strong>CONCLUSIONS:</strong> The evaluated bone augmentation procedures were proven to be effective for the reconstruction of alveolar ridge defects. However, some procedures are demanding and bear a higher risk for postoperative complications. This article is protected by copyright. All rights reserved.</p>
  •  
8.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-8 av 8
 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy