| 1. |
- Pankratov, Dmitry, et al.
(author)
-
Scalable, high performance, enzymatic cathodes based on nanoimprint lithography
- 2015
-
In: Beilstein Journal of Nanotechnology. - : Beilstein Institut. - 2190-4286. ; 6, s. 1377-1384
-
Journal article (peer-reviewed)abstract
- Here we detail high performance, enzymatic electrodes for oxygen bio-electroreduction, which can be easily and reproducibly fabricated with industry-scale throughput. Planar and nanostructured electrodes were built on biocompatible, flexible polymer sheets, while nanoimprint lithography was used for electrode nanostructuring. To the best of our knowledge, this is one of the first reports concerning the usage of nanoimprint lithography for amperometric bioelectronic devices. The enzyme (Myrothecium verrucaria bilirubin oxidase) was immobilised on planar (control) and artificially nanostructured, gold electrodes by direct physical adsorption. The detailed electrochemical investigation of bioelectrodes was performed and the following parameters were obtained: open circuit voltage of approximately 0.75 V, and maximum bio-electrocatalytic current densities of 18 mu A/cm(2) and 58 mu A/cm(2) in air-saturated buffers versus 48 mu A/cm(2) and 186 mu A/cm(2) in oxygen-saturated buffers for planar and nanostructured electrodes, respectively. The half-deactivation times of planar and nanostructured biocathodes were measured to be 2 h and 14 h, respectively. The comparison of standard heterogeneous and bio-electrocatalytic rate constants showed that the improved bio-electrocatalytic performance of the nanostructured biocathodes compared to planar biodevices is due to the increased surface area of the nanostructured electrodes, whereas their improved operational stability is attributed to stabilisation of the enzyme inside nanocavities.
|
|
| 2. |
|
|
| 3. |
- Pankratov, Dmitry, et al.
(author)
-
The influence of nanoparticles on enzymatic bioelectrocatalysis
- 2014
-
In: RSC Advances. - : Royal Society of Chemistry. - 2046-2069. ; 4:72, s. 38164-38168
-
Journal article (peer-reviewed)abstract
- In nearly all papers concerning enzyme–nanoparticle based bioelectronic devices, it is stated that the presence of nanoparticles on electrode surfaces per se enhances bioelectrocatalysis, although the reasons for that enhancement are often unclear. Here, we report detailed experimental evidence that neither an overpotential of bioelectrocatalysis, nor direct electron transfer and bioelectrocatalytic reaction rates for an adsorbed enzyme depend on the size of nanoparticles within the range of 20–80 nm, i.e. for nanoparticles that are considerably larger than the enzyme molecules.
|
|
| 4. |
- Pankratov, Dmitry, et al.
(author)
-
The influence of nanoparticles on enzymatic bioelectrocatalysis
- 2014
-
In: RSC Advances. - : Royal Society of Chemistry (RSC). - 2046-2069. ; 4:72, s. 38164-38168
-
Journal article (peer-reviewed)abstract
- In nearly all papers concerning enzyme-nanoparticle based bio-electronic devices, it is stated that the presence of nanoparticles on electrode surfaces per se enhances bioelectrocatalysis, although the reasons for that enhancement are often unclear. Here, we report detailed experimental evidence that neither an overpotential of bioelectrocatalysis, nor direct electron transfer and bioelectrocatalytic reaction rates for an adsorbed enzyme depend on the size of nanoparticles within the range of 20-80 nm, i.e. for nanoparticles that are considerably larger than the enzyme molecules.
|
|
| 5. |
- Pankratov, Dmitry, et al.
(author)
-
Transparent and flexible, nanostructured and mediatorless glucose/oxygen enzymatic fuel cells
- 2015
-
In: Journal of Power Sources. - : Elsevier BV. - 1873-2755 .- 0378-7753. ; 294, s. 501-506
-
Journal article (peer-reviewed)abstract
- Here we detail transparent, flexible, nanostructured, membrane-less and mediator-free glucose/oxygen enzymatic fuel cells, which can be reproducibly fabricated with industrial scale throughput. The electrodes were built on a biocompatible flexible polymer, while nanoimprint lithography was used for their nanostructuring. The electrodes were covered with gold, their surfaces were visualised using scanning electron and atomic force microscopies, and they were also studied spectrophotometrically and electrochemically. The enzymatic fuel cells were fabricated following our previous reports on membrane-less and mediator-free biodevices in which cellobiose dehydrogenase and bilirubin oxidase were used as anodic and cathodic biocatalysts, respectively. The following average characteristics of transparent and flexible biodevices operating in glucose and chloride containing neutral buffers were registered: 0.63 V open-circuit voltage, and 0.6 mu W cm(-2) maximal power density at a cell voltage of 0.35 V. A transparent and flexible enzymatic fuel cell could still deliver at least 0.5 mu W cm(-2) after 12 h of continuous operation. Thus, such biodevices can potentially be used as self-powered biosensors or electric power sources for smart electronic contact lenses. (C) 2015 Elsevier B.V. All rights reserved.
|
|
| 6. |
- Ahvenniemi, Esko, et al.
(author)
-
Recommended reading list of early publications on atomic layer deposition-Outcome of the "Virtual Project on the History of ALD"
- 2017
-
In: Journal of Vacuum Science & Technology. A. Vacuum, Surfaces, and Films. - : American Vacuum Society. - 0734-2101 .- 1520-8559. ; 35:1
-
Research review (peer-reviewed)abstract
- Atomic layer deposition (ALD), a gas-phase thin film deposition technique based on repeated, self-terminating gas-solid reactions, has become the method of choice in semiconductor manufacturing and many other technological areas for depositing thin conformal inorganic material layers for various applications. ALD has been discovered and developed independently, at least twice, under different names: atomic layer epitaxy (ALE) and molecular layering. ALE, dating back to 1974 in Finland, has been commonly known as the origin of ALD, while work done since the 1960s in the Soviet Union under the name "molecular layering" (and sometimes other names) has remained much less known. The virtual project on the history of ALD (VPHA) is a volunteer-based effort with open participation, set up to make the early days of ALD more transparent. In VPHA, started in July 2013, the target is to list, read and comment on all early ALD academic and patent literature up to 1986. VPHA has resulted in two essays and several presentations at international conferences. This paper, based on a poster presentation at the 16th International Conference on Atomic Layer Deposition in Dublin, Ireland, 2016, presents a recommended reading list of early ALD publications, created collectively by the VPHA participants through voting. The list contains 22 publications from Finland, Japan, Soviet Union, United Kingdom, and United States. Up to now, a balanced overview regarding the early history of ALD has been missing; the current list is an attempt to remedy this deficiency.
|
|
| 7. |
- Andoralov, Viktor, et al.
(author)
-
Biofuel cell based on microscale nanostructured electrodes with inductive coupling to rat brain neurons
- 2013
-
In: Scientific Reports. - : Nature Publishing Group. - 2045-2322. ; :3
-
Journal article (peer-reviewed)abstract
- Miniature, self-contained biodevices powered by biofuel cells may enable a new generation of implantable, wireless, minimally invasive neural interfaces for neurophysiological in vivo studies and for clinical applications. Here we report on the fabrication of a direct electron transfer based glucose/oxygen enzymatic fuel cell (EFC) from genuinely three-dimensional (3D) nanostructured microscale gold electrodes, modified with suitable biocatalysts. We show that the process underlying the simple fabrication method of 3D nanostructured electrodes is based on an electrochemically driven transformation of physically deposited gold nanoparticles. We experimentally demonstrate that mediator-, cofactor-, and membrane-less EFCs do operate in cerebrospinal fluid and in the brain of a rat, producing amounts of electrical power sufficient to drive a self-contained biodevice, viz. 7 μW cm−2 in vitro and 2 μW cm−2 in vivo at an operating voltage of 0.4 V. Last but not least, we also demonstrate an inductive coupling between 3D nanobioelectrodes and living neurons.
|
|
| 8. |
|
|
| 9. |
- Fadil, Ahmed, et al.
(author)
-
Fabrication and improvement of nanopillar InGaN/GaN light-emitting diodes using nanosphere lithography
- 2015
-
In: Journal of Nanophotonics. - 1934-2608. ; 9:1
-
Journal article (peer-reviewed)abstract
- Surface-patterning technologies have enabled the improvement of currently existing light-emitting diodes (LEDs) and can be used to overcome the issue of low quantum efficiency of green GaN-based LEDs. We have applied nanosphere lithography to fabricate nanopillars on InGaN/GaN quantum-well LEDs. By etching through the active region, it is possible to improve both the light extraction efficiency and, in addition, the internal quantum efficiency through the effects of lattice strain relaxation. Nanopillars of different sizes are fabricated and analyzed using Raman spectroscopy. We have shown that nanopillar LEDs can be significantly improved by applying a combination of ion-damage curing techniques, including thermal and acidic treatment, and have analyzed their effects using x-ray photoelectron spectroscopy. (C) 2015 Society of Photo-Optical Instrumentation Engineers (SPIE)
|
|
| 10. |
- Falk, Magnus, et al.
(author)
-
Biofuel cell as a power source for electronic contact lenses
- 2012
-
In: Biosensors & bioelectronics. - : Elsevier. - 0956-5663 .- 1873-4235. ; 37:1, s. 38-45
-
Journal article (peer-reviewed)abstract
- Here we present unequivocal exptl. proof that microscale cofactor- and membrane-less, direct electron transfer based enzymic fuel cells do produce significant amts. of elec. energy in human lachrymal liq. (tears). 100 μm diam. gold wires, covered with 17 nm gold nanoparticles, were used to fashion three-dimensional nanostructured microelectrodes, which were biomodified with Corynascus thermophilus cellobiose dehydrogenase and Myrothecium verrucaria bilirubin oxidase as anodic and cathodic bioelements, resp. The following characteristics of miniature glucose/oxygen biodevices operating in human tears were registered: 0.57 V open-circuit voltage, about 1 μW cm-2 max. power d. at a cell voltage of 0.5 V, and more than 20 h operational half-life. Theor. calcns. regarding the max. recoverable elec. energy can be extd. from the biofuel and the biooxidant, glucose and mol. oxygen, each readily available in human lachrymal liq., fully support our belief that biofuel cells can be used as elec. power sources for so called smart contact lenses.
|
|
