| 1. |
- Forsberg, Johan, et al.
(författare)
-
System for in situ studies of atmospheric corrosion of metal films using soft x-ray spectroscopy and quartz crystal microbalance
- 2007
-
Ingår i: Review of Scientific Instruments. - : AIP Publishing. - 0034-6748 .- 1089-7623. ; 78:8
-
Tidskriftsartikel (refereegranskat)abstract
- We present a versatile chamber (atmospheric corrosion cell) for soft x-ray absorption/emission spectroscopy of metal surfaces in a corrosive atmosphere allowing novel in situ electronic structure studies. Synchrotron x rays passing through a thin window separating the corrosion cell interior from a beamline vacuum chamber probe a metal film deposited on a quartz crystal microbalance (QCM) or on the inside of the window. We present some initial results on chloride induced corrosion of iron surfaces in humidified synthetic air. By simultaneous recording of QCM signal and soft x-ray emission from the corroding sample, correlation between mass changes and variations in spectral features is facilitated.
|
|
| 2. |
- Hedberg, Yolanda S., et al.
(författare)
-
Electrochemical surface oxide characteristics of metal nanoparticles (Mn, Cu and Al) and the relation to toxicity
- 2016
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686 .- 1873-3859. ; 212, s. 360-371
-
Tidskriftsartikel (refereegranskat)abstract
- Most metal nanoparticles (NPs), except noble metal NPs, rapidly form a thin surface oxide in ambient conditions. The protective properties of these oxides improve or worsen depending on the environment, e.g., the human lung. Several properties, including the chemical/electrochemical stability and defect density, determine the capacity of these surface oxides to hinder the bulk metal from further oxidation (corrosion). The aim of this study was to investigate whether electrochemical surface oxide characterization of non-functionalized base metal NPs of different characteristics (Al, Mn and Cu) can assist in understanding their bioaccessibility (metal release) in cell media (DMEM+) and their cytotoxic properties following exposure in lung epithelial (A549) cells. The composition and valence states of surface oxides of metal NPs and their electrochemical activity were investigated using an electrochemical technique based on a graphite paste electrode to perform cyclic voltammetry in buffer solutions and open circuit potential measurements in DMEM+. The electrochemical surface oxide characterization was complemented and verified by Raman spectroscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. The open circuit potential trends in DMEM+ correlated well with metal release results in the same solution, and provided information on the kinetics of oxide dissolution in the case of Cu NPs. Extensive particle agglomeration in cell medium (DMEM+) was observed by means of photon-cross correlation spectroscopy for all metal NPs, with sedimentation taking place very quickly. As a consequence, measurements of the real dose of added non-functionalized metal NPs to cell cultures for cytotoxicity testing from a sonicated stock solution were shown necessary. The cytotoxic response was found to be strongly correlated to changes in physico-chemical and electrochemical properties of the surface oxides of the metal NPs, the most potent being Cu NPs, followed by Mn NPs. No cytotoxicity was observed for Al NPs. The electrochemical surface oxide characterization corresponded well with other tools commonly used for nanotoxicological characterization and provided additional information.
|
|
| 3. |
- Hedberg, Yolanda, Docent, 1985-, et al.
(författare)
-
Welding fume nanoparticles from solid and flux-cored wires : Solubility, toxicity, and role of fluorides
- 2021
-
Ingår i: Journal of Hazardous Materials. - : Elsevier BV. - 0304-3894 .- 1873-3336. ; 413
-
Tidskriftsartikel (refereegranskat)abstract
- Welding fume particles are hazardous. Their toxicity likely depends on their composition and reactivity. This study aimed at exploring the role of sodium or other fluorides (NaF), which are intentionally added to flux-cored wire electrodes for stainless steel welding, on the solubility (in phosphate buffered saline) and toxicity of the generated welding fume particles. A multi-analytical particle characterization approach along with in-vitro cell assays was undertaken. The release of Cr(VI) and Mn from the particles was tested as a function of fluoride solution concentration. The welding fume particles containing NaF released significantly higher amounts of Cr (VI) compared with solid wire reference fumes, which was associated with increased cytotoxicity and genotoxicity in-vitro. No crystalline Na or potassium (K) containing chromates were observed. Cr(VI) was incorporated in an amorphous mixed oxide. Solution-added fluorides did not increase the solubility of Cr(VI), but contributed to a reduced Mn release from both solid and flux-cored wire fume particles and the reduction of Cr (VI) release from solid wire fume particles. Chemical speciation modeling suggested that metal fluoride complexes were not formed. The presence of NaF in the welding electrodes did not have any direct, but possibly an indirect, role in the Cr(VI) solubility of welding fumes.
|
|
| 4. |
- Henderson, Rayetta G., et al.
(författare)
-
Inter-laboratory validation of bioaccessibility testing for metals
- 2014
-
Ingår i: Regulatory toxicology and pharmacology. - : Elsevier BV. - 0273-2300 .- 1096-0295. ; 70:1, s. 170-181
-
Tidskriftsartikel (refereegranskat)abstract
- Bioelution assays are fast, simple alternatives to in vivo testing. In this study, the intra- and inter-laboratory variability in bioaccessibility data generated by bioelution tests were evaluated in synthetic fluids relevant to oral, inhalation, and dermal exposure. Using one defined protocol, five laboratories measured metal release from cobalt oxide, cobalt powder, copper concentrate, Inconel alloy, leaded brass alloy, and nickel sulfate hexahydrate. Standard deviations of repeatability (S-r) and reproducibility (S-R) were used to evaluate the intra- and inter-laboratory variability, respectively. Examination of the s(R):s(r) ratios demonstrated that, while gastric and lysosomal fluids had reasonably good reproducibility, other fluids did not show as good concordance between laboratories. Relative standard deviation (RSD) analysis showed more favorable reproducibility outcomes for some data sets; overall results varied more between- than within-laboratories. RSD analysis of s(r) showed good within-laboratory variability for all conditions except some metals in interstitial fluid. In general, these findings indicate that absolute bioaccessibility results in some biological fluids may vary between different laboratories. However, for most applications, measures of relative bioaccessibility are needed, diminishing the requirement for high inter-laboratory reproducibility in absolute metal releases. The inter-laboratory exercise suggests that the degrees of freedom within the protocol need to be addressed.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Latvala, Siiri, et al.
(författare)
-
Optimization of an air-liquid interface exposure system for assessing toxicity of airborne nanoparticles
- 2016
-
Ingår i: Journal of Applied Toxicology. - : Wiley. - 0260-437X .- 1099-1263.
-
Tidskriftsartikel (refereegranskat)abstract
- The use of refined toxicological methods is currently needed for characterizing the risks of airborne nanoparticles (NPs) to human health. To mimic pulmonary exposure, we have developed an air-liquid interface (ALI) exposure system for direct deposition of airborne NPs on to lung cell cultures. Compared to traditional submerged systems, this allows more realistic exposure conditions for characterizing toxicological effects induced by airborne NPs. The purpose of this study was to investigate how the deposition of silver NPs (AgNPs) is affected by different conditions of the ALI system. Additionally, the viability and metabolic activity of A549 cells was studied following AgNP exposure. Particle deposition increased markedly with increasing aerosol flow rate and electrostatic field strength. The highest amount of deposited particles (2.2 μg cm-2) at cell-free conditions following 2 h exposure was observed for the highest flow rate (390 ml min-1) and the strongest electrostatic field (±2 kV). This was estimated corresponding to deposition efficiency of 94%. Cell viability was not affected after 2 h exposure to clean air in the ALI system. Cells exposed to AgNPs (0.45 and 0.74 μg cm-2) showed significantly (P < 0.05) reduced metabolic activities (64 and 46%, respectively). Our study shows that the ALI exposure system can be used for generating conditions that were more realistic for in vitro exposures, which enables improved mechanistic and toxicological studies of NPs in contact with human lung cells.
|
|
| 8. |
|
|
| 9. |
- McCarrick, S., et al.
(författare)
-
Toxtracker reporter cell lines as a tool for mechanism-based (Geno)toxicity screening of nanoparticles—metals, oxides and quantum dots
- 2020
-
Ingår i: Nanomaterials. - : MDPI AG. - 2079-4991. ; 10:1
-
Tidskriftsartikel (refereegranskat)abstract
- The increased use of nanoparticles (NPs) requires efficient testing of their potential toxic effects. A promising approach is to use reporter cell lines to quickly assess the activation of cellular stress response pathways. This study aimed to use the ToxTracker reporter cell lines to investigate (geno)toxicity of various metal-or metal oxide NPs and draw general conclusions on NP-induced effects, in combination with our previous findings. The NPs tested in this study (n = 18) also included quantum dots (QDs) in different sizes. The results showed a large variation in cytotoxicity of the NPs tested. Furthermore, whereas many induced oxidative stress only few activated reporters related to DNA damage. NPs of manganese (Mn and Mn3O4) induced the most remarkable ToxTracker response with activation of reporters for oxidative stress, DNA damage, protein unfolding and p53-related stress. The QDs (CdTe) were highly toxic showing clearly size-dependent effects and calculations suggest surface area as the most relevant dose metric. Of all NPs investigated in this and previous studies the following induce the DNA damage reporter; CuO, Co, CoO, CdTe QDs, Mn, Mn3O4, V2O5, and welding NPs. We suggest that these NPs are of particular concern when considering genotoxicity induced by metal-and metal oxide NPs.
|
|
| 10. |
- Shi, J., et al.
(författare)
-
Hemolytic properties of synthetic nano- and porous silica particles : The effect of surface properties and the protection by the plasma corona
- 2012
-
Ingår i: Acta Biomaterialia. - : Elsevier BV. - 1742-7061 .- 1878-7568. ; 8:9, s. 3478-3490
-
Tidskriftsartikel (refereegranskat)abstract
- Novel silica materials incorporating nanotechnology are promising materials for biomedical applications, but their novel properties may also bring unforeseen behavior in biological systems. Micro-size silica is well documented to induce hemolysis, but little is known about the hemolytic activities of nanostructured silica materials. In this study, the hemolytic properties of synthetic amorphous silica nanoparticles with primary sizes of 7-14 nm (hydrophilic vs. hydrophobic), 5-15 nm, 20 nm and 50 nm, and model meso/macroporous silica particles with pore diameters of 40 nm and 170 nm are investigated. A crystalline silica sample (0.5-10 ÎŒm) is included for benchmarking purposes. Special emphasis is given to investigations of how the temperature and solution complexity (solvent, plasma), as well as the physicochemical properties (such as size, surface charge, hydrophobicity and other surface properties), link to the hemolytic activities of these particles. Results suggests the potential importance of small size and large external surface area, as well as surface charge/structure, in the hemolysis of silica particles. Furthermore, a significant correlation is observed between the hemolytic profile of red blood cells and the cytotoxicity profile of human promyelocytic leukemia cells (HL-60) induced by nano- and porous silica particles, suggesting a potential universal mechanism of action. Importantly, the results generated suggest that the protective effect of plasma towards silica nanoparticle-induced hemolysis as well as cytotoxicity is primarily due to the protein/lipid layer shielding the silica particle surface. These results will assist the rational design of hemocompatible silica particles for biomedical applications.
|
|
