| 1. |
- Aad, G., et al.
(författare)
-
A search for prompt lepton-jets in pp collisions at root s=7 TeV with the ATLAS detector
- 2013
-
Ingår i: Physics Letters B. - Elsevier Science BV. - 0370-2693. ; 719:4-5, s. 299-317
-
Tidskriftsartikel (refereegranskat)abstract
- We present a search for a light (mass < 2 GeV) boson predicted by Hidden Valley supersymmetric models that decays into a final state consisting of collimated muons or electrons, denoted "lepton-jets". The analysis uses 5 fb(-1) of root s = 7 TeV proton-proton collision data recorded by the ATLAS detector at the Large Hadron Collider to search for the following signatures: single lepton-jets with at least four muons; pairs of lepton-jets, each with two or more muons; and pairs of lepton-jets with two or more electrons. This study finds no statistically significant deviation from the Standard Model prediction and places 95% confidence-level exclusion limits on the production cross section times branching ratio of light bosons for several parameter sets of a Hidden Valley model. (c) 2013 CERN. Published by Elsevier B.V. All rights reserved.
|
|
| 2. |
- Aad, G., et al.
(författare)
-
Readiness of the ATLAS Tile Calorimeter for LHC collisions
- 2010
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 70:4, s. 1193-1236
-
Tidskriftsartikel (refereegranskat)abstract
- The Tile hadronic calorimeter of the ATLAS detector has undergone extensive testing in the experimental hall since its installation in late 2005. The readout, control and calibration systems have been fully operational since 2007 and the detector has successfully collected data from the LHC single beams in 2008 and first collisions in 2009. This paper gives an overview of the Tile Calorimeter performance as measured using random triggers, calibration data, data from cosmic ray muons and single beam data. The detector operation status, noise characteristics and performance of the calibration systems are presented, as well as the validation of the timing and energy calibration carried out with minimum ionising cosmic ray muons data. The calibration systems' precision is well below the design value of 1%. The determination of the global energy scale was performed with an uncertainty of 4%.
|
|
| 3. |
- Aad, G., et al.
(författare)
-
Measurement of isolated-photon pair production in pp collisions at root s=7 TeV with the ATLAS detector
- 2013
-
Ingår i: Journal of High Energy Physics. - Springer. - 1126-6708. ; :1, s. 086
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS experiment at the LHC has measured the production cross section of events with two isolated photons in the final state, in proton-proton collisions at root s = 7 TeV. The full data set collected in 2011, corresponding to an integrated luminosity of 4.9 fb(-1), is used. The amount of background, from hadronic jets and isolated electrons, is estimated with data-driven techniques and subtracted. The total cross section, for two isolated photons with transverse energies above 25 GeV and 22 GeV respectively, in the acceptance of the electromagnetic calorimeter (vertical bar eta vertical bar < 1.37 and 1.52 < vertical bar eta vertical bar 2.37) and with an angular separation Delta R > 0.4, is 44.0(-4.2)(+3.2) pb. The differential cross sections as a function of the di-photon invariant mass, transverse momentum, azimuthal separation, and cosine of the polar angle of the largest transverse energy photon in the Collins-Soper di-photon rest frame are also measured. The results are compared to the prediction of leading-order parton-shower and next-to-leading-order and next-to-next-to-leading-order parton-level generators.
|
|
| 4. |
- Aad, G, et al.
(författare)
-
Readiness of the ATLAS liquid argon calorimeter for LHC collisions
- 2010
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 70:3, s. 723-753
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS liquid argon calorimeter has been operating continuously since August 2006. At this time, only part of the calorimeter was readout, but since the beginning of 2008, all calorimeter cells have been connected to the ATLAS readout system in preparation for LHC collisions. This paper gives an overview of the liquid argon calorimeter performance measured in situ with random triggers, calibration data, cosmic muons, and LHC beam splash events. Results on the detector operation, timing performance, electronics noise, and gain stability are presented. High energy deposits from radiative cosmic muons and beam splash events allow to check the intrinsic constant term of the energy resolution. The uniformity of the electromagnetic barrel calorimeter response along eta (averaged over phi) is measured at the percent level using minimum ionizing cosmic muons. Finally, studies of electromagnetic showers from radiative muons have been used to cross-check the Monte Carlo simulation. The performance results obtained using the ATLAS readout, data acquisition, and reconstruction software indicate that the liquid argon calorimeter is well-prepared for collisions at the dawn of the LHC era.
|
|
| 5. |
- Aad, G., et al.
(författare)
-
Commissioning of the ATLAS Muon Spectrometer with cosmic rays
- 2010
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 70:3, s. 875-916
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS detector at the Large Hadron Collider has collected several hundred million cosmic ray events during 2008 and 2009. These data were used to commission the Muon Spectrometer and to study the performance of the trigger and tracking chambers, their alignment, the detector control system, the data acquisition and the analysis programs. We present the performance in the relevant parameters that determine the quality of the muon measurement. We discuss the single element efficiency, resolution and noise rates, the calibration method of the detector response and of the alignment system, the track reconstruction efficiency and the momentum measurement. The results show that the detector is close to the design performance and that the Muon Spectrometer is ready to detect muons produced in high energy proton-proton collisions.
|
|
| 6. |
- Aad, G., et al.
(författare)
-
Measurement of upsilon production in 7 TeV pp collisions at ATLAS
- 2013
-
Ingår i: Physical Review D. - American Physical Society. - 1550-7998. ; 87:5, s. 052004
-
Tidskriftsartikel (refereegranskat)abstract
- Using 1.8 fb(-1) of pp collisions at a center- of- mass energy of 7 TeV recorded by the ATLAS detector at the Large Hadron Collider, we present measurements of the production cross sections of Upsilon(1S,2S,3S) mesons. Upsilon mesons are reconstructed using the dimuon decay mode. Total production cross sections for p(T) < 70 GeV and in the rapidity interval vertical bar y(Upsilon)vertical bar < 2. 25 are measured to be, 8.01 +/- 0.02 +/- 0.36 +/- 0.31 nb, 2.05 +/- 0.01 +/- 0.12 +/- 0.08 nb, and 0.92 +/- 0.01 +/- 0.07 +/- 0.04 nb, respectively, with uncertainties separated into statistical, systematic, and luminosity measurement effects. In addition, differential cross section times dimuon branching fractions for Upsilon(1S), Upsilon(2S), and Upsilon(3S) as a function of Upsilon transverse momentum pT and rapidity are presented. These cross sections are obtained assuming unpolarized production. If the production polarization is fully transverse or longitudinal with no azimuthal dependence in the helicity frame, the cross section may vary by approximately +/- 20%. If a nontrivial azimuthal dependence is considered, integrated cross sections may be significantly enhanced by a factor of 2 or more. We compare our results to several theoretical models of Upsilon meson production, finding that none provide an accurate description of our data over the full range of Upsilon transverse momenta accessible with this data set. DOI. 10.1103/ PhysRevD. 87.052004
|
|
| 7. |
- Aad, G., et al.
(författare)
-
Search for R-parity-violating supersymmetry in events with four or more leptons in root s=7 TeV pp collisions with the ATLAS detector
- 2012
-
Ingår i: Journal of High Energy Physics. - Springer. - 1126-6708. ; :12, s. 124
-
Tidskriftsartikel (refereegranskat)abstract
- A search for new phenomena in final states with four or more leptons (electrons or muons) is presented. The analysis is based on 4.7 fb(-1) of root s = 7TeV proton-proton collisions delivered by the Large Hadron Collider and recorded with the ATLAS detector. Observations are consistent with Standard Model expectations in two signal regions: one that requires moderate values of missing transverse momentum and another that requires large effective mass. The results are interpreted in a simplified model of R-parity-violating supersymmetry in which a 95% CL exclusion region is set for charged wino masses up to 540GeV. In an R-parity-violating MSUGRA/CMSSM model, values of m(1/2) up to 820GeV are excluded for 10 < tan beta < 40.
|
|
| 8. |
- Aad, G, et al.
(författare)
-
The ATLAS Inner Detector commissioning and calibration
- 2010
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 70:3, s. 787-821
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS Inner Detector is a composite tracking system consisting of silicon pixels, silicon strips and straw tubes in a 2 T magnetic field. Its installation was completed in August 2008 and the detector took part in data-taking with single LHC beams and cosmic rays. The initial detector operation, hardware commissioning and in-situ calibrations are described. Tracking performance has been measured with 7.6 million cosmic-ray events, collected using a tracking trigger and reconstructed with modular pattern-recognition and fitting software. The intrinsic hit efficiency and tracking trigger efficiencies are close to 100%. Lorentz angle measurements for both electrons and holes, specific energy-loss calibration and transition radiation turn-on measurements have been performed. Different alignment techniques have been used to reconstruct the detector geometry. After the initial alignment, a transverse impact parameter resolution of 22.1 +/- 0.9 mu m and a relative momentum resolution sigma (p) /p=(4.83 +/- 0.16)x10(-4) GeV(-1)xp (T) have been measured for high momentum tracks.
|
|
| 9. |
- Aad, G, et al.
(författare)
-
The ATLAS Simulation Infrastructure
- 2010
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 70:3, s. 823-874
-
Tidskriftsartikel (refereegranskat)abstract
- The simulation software for the ATLAS Experiment at the Large Hadron Collider is being used for large-scale production of events on the LHC Computing Grid. This simulation requires many components, from the generators that simulate particle collisions, through packages simulating the response of the various detectors and triggers. All of these components come together under the ATLAS simulation infrastructure. In this paper, that infrastructure is discussed, including that supporting the detector description, interfacing the event generation, and combining the GEANT4 simulation of the response of the individual detectors. Also described are the tools allowing the software validation, performance testing, and the validation of the simulated output against known physics processes.
|
|
| 10. |
- Åsman, Barbro, et al.
(författare)
-
Studies of the performance of the ATLAS detector using cosmic-ray muons
- 2011
-
Ingår i: European Physical Journal C. - Springer. - 1434-6044. ; 71:3, s. 1593
-
Tidskriftsartikel (refereegranskat)abstract
- Muons from cosmic-ray interactions in the atmosphere provide a high-statistics source of particles that can be used to study the performance and calibration of the ATLAS detector. Cosmic-ray muons can penetrate to the cavern and deposit energy in all detector subsystems. Such events have played an important role in the commissioning of the detector since the start of the installation phase in 2005 and were particularly important for understanding the detector performance in the time prior to the arrival of the first LHC beams. Global cosmic-ray runs were undertaken in both 2008 and 2009 and these data have been used through to the early phases of collision data-taking as a tool for calibration, alignment and detector monitoring. These large datasets have also been used for detector performance studies, including investigations that rely on the combined performance of different subsystems. This paper presents the results of performance studies related to combined tracking, lepton identification and the reconstruction of jets and missing transverse energy. Results are compared to expectations based on a cosmic-ray event generator and a full simulation of the detector response.
|
|
