| 1. |
- Schael, S, et al.
(author)
-
Precision electroweak measurements on the Z resonance
- 2006
-
In: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 427:5-6, s. 257-454
-
Research review (peer-reviewed)abstract
- We report on the final electroweak measurements performed with data taken at the Z resonance by the experiments operating at the electron-positron colliders SLC and LEP. The data consist of 17 million Z decays accumulated by the ALEPH, DELPHI, L3 and OPAL experiments at LEP, and 600 thousand Z decays by the SLID experiment using a polarised beam at SLC. The measurements include cross-sections, forward-backward asymmetries and polarised asymmetries. The mass and width of the Z boson, m(Z) and Gamma(Z), and its couplings to fermions, for example the p parameter and the effective electroweak mixing angle for leptons, are precisely measured: m(Z) = 91.1875 +/- 0.0021 GeV, Gamma(Z) = 2.4952 +/- 0.0023 GeV, rho(l) = 1.0050 +/- 0.0010, sin(2)theta(eff)(lept) = 0.23153 +/- 0.00016. The number of light neutrino species is determined to be 2.9840 +/- 0.0082, in agreement with the three observed generations of fundamental fermions. The results are compared to the predictions of the Standard Model (SM). At the Z-pole, electroweak radiative corrections beyond the running of the QED and QCD coupling constants are observed with a significance of five standard deviations, and in agreement with the Standard Model. Of the many Z-pole measurements, the forward-backward asymmetry in b-quark production shows the largest difference with respect to its SM expectation, at the level of 2.8 standard deviations. Through radiative corrections evaluated in the framework of the Standard Model, the Z-pole data are also used to predict the mass of the top quark, m(t) = 173(+10)(+13) GeV, and the mass of the W boson, m(W) = 80.363 +/- 0.032 GeV. These indirect constraints are compared to the direct measurements, providing a stringent test of the SM. Using in addition the direct measurements of m(t) and m(W), the mass of the as yet unobserved SM Higgs boson is predicted with a relative uncertainty of about 50% and found to be less than 285 GeV at 95% confidence level. (c) 2006 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Aamodt, K., et al.
(author)
-
The ALICE experiment at the CERN LHC
- 2008
-
In: Journal of Instrumentation. - 1748-0221. ; 3:S08002
-
Research review (peer-reviewed)abstract
- ALICE (A Large Ion Collider Experiment) is a general-purpose, heavy-ion detector at the CERN LHC which focuses on QCD, the strong-interaction sector of the Standard Model. It is designed to address the physics of strongly interacting matter and the quark-gluon plasma at extreme values of energy density and temperature in nucleus-nucleus collisions. Besides running with Pb ions, the physics programme includes collisions with lighter ions, lower energy running and dedicated proton-nucleus runs. ALICE will also take data with proton beams at the top LHC energy to collect reference data for the heavy-ion programme and to address several QCD topics for which ALICE is complementary to the other LHC detectors. The ALICE detector has been built by a collaboration including currently over 1000 physicists and engineers from 105 Institutes in 30 countries, Its overall dimensions are 16 x 16 x 26 m(3) with a total weight of approximately 10 000 t. The experiment consists of 18 different detector systems each with its own specific technology choice and design constraints, driven both by the physics requirements and the experimental conditions expected at LHC. The most stringent design constraint is to cope with the extreme particle multiplicity anticipated in central Pb-Pb collisions. The different subsystems were optimized to provide high-momentum resolution as well as excellent Particle Identification (PID) over a broad range in momentum, up to the highest multiplicities predicted for LHC. This will allow for comprehensive studies of hadrons, electrons, muons, and photons produced in the collision of heavy nuclei. Most detector systems are scheduled to be installed and ready for data taking by mid-2008 when the LHC is scheduled to start operation, with the exception of parts of the Photon Spectrometer (PHOS), Transition Radiation Detector (TRD) and Electro Magnetic Calorimeter (EMCal). These detectors will be completed for the high-luminosity ion run expected in 2010. This paper describes in detail the detector components as installed for the first data taking in the summer of 2008.
|
|
| 3. |
- Ablikim, M., et al.
(author)
-
Measurements of (XcJ)-> K+K-K+K- decays
- 2006
-
In: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 642:3, s. 197-202
-
Journal article (peer-reviewed)abstract
- Using 14M psi(2S) events taken with the BESII detector, chi(cJ) -> 2(K+K-) decays are studied. For the four-kaon final state, the branching fractions are B(chi(c0,1,2) ->.2(K+K-)) = (3.48 +/- 0.23 +/- 0.47) x 10(-3), (0.70 +/- 0.13 +/- 0.10) x 10(-3), and (2.17 +/- 0.20 +/- 0.31) x 10(-3). For the phi K+K- final state, the branching fractions, which are measured for the first time, are B(chi(c0,1,2) -> phi K+K-) = (1.03 +/- 0.22 +/- 0.15) x 10(-3), (0.46 +/- 0.16 +/- 0.06) x 10(-3), and (1.67 +/- 0.26 +/- 0.24) x 10(-4). For the phi phi final state, B(chi(c0,2) -> phi phi) = (0.94 +/- 0.21 +/- 0.13) x 10(-3) and (1.70 +/- 0.30 +/- 0.25) x 10(-3).
|
|
| 4. |
- Haas, Brian J., et al.
(author)
-
Genome sequence and analysis of the Irish potato famine pathogen Phytophthora infestans
- 2009
-
In: Nature. - : Springer Science and Business Media LLC. - 0028-0836 .- 1476-4687. ; 461:7262, s. 393-398
-
Journal article (peer-reviewed)abstract
- Phytophthora infestans is the most destructive pathogen of potato and a model organism for the oomycetes, a distinct lineage of fungus-like eukaryotes that are related to organisms such as brown algae and diatoms. As the agent of the Irish potato famine in the mid-nineteenth century, P. infestans has had a tremendous effect on human history, resulting in famine and population displacement(1). To this day, it affects world agriculture by causing the most destructive disease of potato, the fourth largest food crop and a critical alternative to the major cereal crops for feeding the world's population(1). Current annual worldwide potato crop losses due to late blight are conservatively estimated at $6.7 billion(2). Management of this devastating pathogen is challenged by its remarkable speed of adaptation to control strategies such as genetically resistant cultivars(3,4). Here we report the sequence of the P. infestans genome, which at similar to 240 megabases (Mb) is by far the largest and most complex genome sequenced so far in the chromalveolates. Its expansion results from a proliferation of repetitive DNA accounting for similar to 74% of the genome. Comparison with two other Phytophthora genomes showed rapid turnover and extensive expansion of specific families of secreted disease effector proteins, including many genes that are induced during infection or are predicted to have activities that alter host physiology. These fast-evolving effector genes are localized to highly dynamic and expanded regions of the P. infestans genome. This probably plays a crucial part in the rapid adaptability of the pathogen to host plants and underpins its evolutionary potential.
|
|
| 5. |
- Gao, Feng, et al.
(author)
-
Preparation of la-doped BiFeO3 thin films with Fe2+ ions on Si substrates
- 2006
-
In: Journal of Applied Physics. - : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 99:9, s. 094105-
-
Journal article (peer-reviewed)abstract
- La-doped BiFeO3 thin films with Fe2+ ions have been prepared on Pt/TiO2/SiO2/Si substrates by pulsed laser deposition in order to enhance the ferroelectric and magnetic properties. The targets for the film deposition were synthesized using a rapid liquid phase sintering technique to ensure the low leakage. The dielectric properties at room temperature and above were investigated. It was observed that the La doping greatly enhances the ferroelectric polarization at room temperature by modifying the film structure from rhombohedral to monoclinic. The saturation magnetization was enhanced about two times due to the Fe2+ ions in the thin films. (C) 2006 American Institute of Physics.
|
|
| 6. |
- Nascimento, V. B., et al.
(author)
-
Procedure for LEED I-V structural analysis of metal oxide surfaces : Ca1.5Sr0.5RuO4(001)
- 2007
-
In: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 75:3, s. 035408-
-
Journal article (peer-reviewed)abstract
- Transition metal oxides (TMOs) are famous for the intimate coupling between the lattice, electrons, and spin, creating exotic functionality. Creating a surface, breaking the symmetry, should result in lattice distortions that due to the close coupling could create different "surface phases." Historically it has been very difficult to use low energy electron diffraction I-V to quantitatively determine the surface structure of TMOs. A signature of this problem is the large values commonly reported in the literature of the Pendry reliability factor (R-P), which is used to quantify the agreement between experimental data and calculated diffraction. In this paper we describe a consistent procedure for determining the phase shifts using an optimized muffin-tin potential approach combined with an energy-dependent real and imaginary inner potential. This procedure is used to determine the surface structure of the layered TMO Ca1.5Sr0.5RuO4. An acceptable Pendry reliability factor is achieved (R-P=0.28).
|
|
| 7. |
- Arsenlis, Athanasios, et al.
(author)
-
Enabling strain hardening simulations with dislocation dynamics
- 2007
-
In: Modelling and Simulation in Materials Science and Engineering. - : IOP Publishing. - 0965-0393 .- 1361-651X. ; 15, s. 553-595
-
Journal article (peer-reviewed)abstract
- Numerical algorithms for discrete dislocation dynamics simulations areinvestigated for the purpose of enabling strain hardening simulations of singlecrystals on massively parallel computers. The algorithms investigated includethe O(N) calculation of forces, the equations of motion, time integration,adaptive mesh refinement, the treatment of dislocation core reactions and thedynamic distribution of data and work on parallel computers. A simulationintegrating all these algorithmic elements using the Parallel DislocationSimulator (ParaDiS) code is performed to understand their behaviour in concertand to evaluate the overall numerical performance of dislocation dynamicssimulations and their ability to accumulate percent of plastic strain.
|
|
| 8. |
- Cai, G-H, et al.
(author)
-
Quantitative PCR analysis of fungal DNA in Swedish day care centers and comparison with building characteristics and allergen levels
- 2009
-
In: Indoor Air. - : Hindawi Limited. - 0905-6947 .- 1600-0668. ; 19:5, s. 392-400
-
Journal article (peer-reviewed)abstract
- Sweden has had allergen-avoidance day care centers (AADCs) since 1979. The aim of this study was to measure fungal DNA by quantitative polymerase chain reaction (qPCR), a new method, in AADCs and ordinary day care centers (ODCs) and examine associations between allergen levels and building characteristics. Dust samples were collected by swabbing doorframes, vacuum-cleaning, and using Petri dishes. In total, 11 AADCs and 11 ODCs were studied (70 rooms). Total fungal DNA, measured by qPCR in the swab dust, was detected in 89%, Aspergillus or Penicillium (Asp/Pen) DNA in 34%, and Stachybotrys chartarum DNA in 6% of the rooms. Total fungal DNA was significantly higher in rooms with linoleum floor (P = 0.02), textile carpets (P = 0.03), reported dampness/molds (P = 0.02) and reported odor (P < 0.001) in the buildings, and significantly lower in wooden facade buildings (P = 0.003). Reported odor was related to the amount of sieved fine dust, reported dampness/molds and type of building construction. Total fungal DNA was related to cat, dog, horse and total allergen levels (P = 0.003) in the day care centers. In conclusion, total fungal DNA is related to reported dampness/molds, reported odor, and type of wall construction. The association between fungal and allergen contamination indicated a general 'hygiene factor' related to biological contaminants. Practical Implications The associations between fungal DNA, reported dampness/molds, and odor support the view that buildings with odor problems should be investigated for possible hidden fungal growth. There is a need to measure fungal biomass in different types of building constructions by monitoring fungal DNA. Analysis of fungal DNA with quantitative PCR can be a fast and practical way to study indoor fungal contamination. Swabbing dust from the doorframe of the main entrance to the room can be a convenient method of sampling dust for fungal DNA analysis. The high prevalence of reported dampness/molds and the common occurrence of fungal DNA indicate the need to improve the indoor environment of Swedish day care centers.
|
|
| 9. |
|
|
| 10. |
- Nosek, Brian A., et al.
(author)
-
National differences in gender-science stereotypes predict national sex differences in science and math achievement
- 2009
-
In: Proceedings of the National Academy of Sciences of the United States of America. - : Proceedings of the National Academy of Sciences. - 0027-8424 .- 1091-6490. ; 106:26, s. 10593-10597
-
Journal article (peer-reviewed)abstract
- About 70% of more than half a million Implicit Association Tests completed by citizens of 34 countries revealed expected implicit stereotypes associating science with males more than with females. We discovered that nation-level implicit stereotypes predicted nation-level sex differences in 8th-grade science and mathematics achievement. Self-reported stereotypes did not provide additional predictive validity of the achievement gap. We suggest that implicit stereotypes and sex differences in science participation and performance are mutually reinforcing, contributing to the persistent gender gap in science engagement.
|
|
