| 1. |
|
|
| 2. |
|
|
| 3. |
- Dahl, Andreas, et al.
(författare)
-
Traffic-generated emissions of ultrafine particles from pavement-tire interface
- 2006
-
Ingår i: Atmospheric Environment. - : Elsevier. - 1352-2310 .- 1873-2844. ; 40:7, s. 1314-1323
-
Tidskriftsartikel (refereegranskat)abstract
- In a road simulator study, a significant source of sub-micrometer fine particles produced by the road-tire interface was observed. Since the particle size distribution and source strength is dependent on the type of tire used, it is likely that these particles largely originate from the tires, and not the road pavement. The particles consisted most likely of mineral oils from the softening filler and fragments of the carbon-reinforcing filler material (soot agglomerates). This identification was based on transmission electron microscopy studies of collected ultrafine wear particles and on-line thermal treatment using a thermodesorber. The mean particle number diameters were between 15-50 nm, similar to those found in light duty vehicle (LDV) tail-pipe exhaust. A simple box model approach was used to estimate emission factors in the size interval 15-700 nm. The emission factors increased with increasing vehicle speed, and varied between 3.7 x 10(11) and 3.2 x 10(12) particles vehicle(-1) km(-1) at speeds of 50 and 70 km h(-1). This corresponds to between 0.1-1% of tail-pipe emissions in real-world emission studies at similar speeds from a fleet of LDV with 95% gasoline and 5% diesel-fueled cars. The emission factors for particles originating from the road-tire interface were, however, similar in magnitude to particle number emission factors from liquefied petroleum gas-powered vehicles derived in test bench studies in Australia 2005. Thus the road-tire interface may be a significant contributor to particle emissions from ultraclean vehicles. (c) 2005 Elsevier Ltd. All rights reserved.
|
|
| 4. |
|
|
| 5. |
- Gustafsson, Mats, et al.
(författare)
-
Properties and toxicological effects of particles from the interaction between tyres, road pavement and winter traction material
- 2008
-
Ingår i: Science of the Total Environment. - : Institutionen för klinisk och experimentell medicin. - 0048-9697 .- 1879-1026. ; 393:2-3, s. 226-240
-
Tidskriftsartikel (refereegranskat)abstract
- In regions where studded tyres and traction material are used during winter, e.g. the Nordic countries, northern part of USA, Canada, and Japan, mechanically generated particles from traffic is the main reason for high particle concentrations in busy street- and road environments. In many Nordic municipalities the European environmental quality standard for inhalable particles (PM10) is exceeded due to these particles. In this study, particles from the wear of studded and studless friction tyres on two pavements and traction sanding were generated using a road simulator. The particles were characterized using particle sizers, PIXE and electron microscopy. Cell studies were conducted on particles sampled from the tests with studded tyres and compared with street environment, diesel exhaust and subway PM10, respectively. The results show that in the road simulator, where resuspension is minimised, studded tyres produce tens of times more particles than friction tyres. Chemical analysis of the sampled particles shows that the generated wear particles consists almost entirely of minerals from the pavement stone material, but also that S is enriched for the sub-micron particles and that Zn is enriched for friction tyres for all particles sizes. The chemical data can be used for source identification and apportionment in urban aerosol studies. A mode of ultra-fine particles was also present and is hypothesised to originate in the tyres. Further, traction material properties affect PM10 emission. The inflammatory potential of the particles from wear of pavements seems to depend on type of pavement and can be at least as potent as diesel exhaust particles. The results implies that there is a need and a good potential to reduce particle emission from pavement wear and winter time road and street operation by adjusting both studded tyre use as well as pavement and traction material properties.
|
|
| 6. |
- Melin, Malin, et al.
(författare)
-
A founder mutation for ichthyosis prematurity syndrome restricted to 76 kb by haplotype association
- 2006
-
Ingår i: Journal of Human Genetics. - : Springer Science and Business Media LLC. - 1434-5161 .- 1435-232X. ; 51:10, s. 864-871
-
Tidskriftsartikel (refereegranskat)abstract
- Autosomal recessive congenital ichthyosis (ARCI) is a group of keratinisation disorders that includes the ichthyosis prematurity syndrome (IPS). IPS is rare and almost exclusively present in a restricted region in the middle of Norway and Sweden, which indicates a founder effect for the disorder. We recently reported linkage of IPS to chromosome 9q34, and we present here the subsequent fine-mapping of this region with known and novel microsatellite markers as well as single nucleotide polymorphisms (SNPs). Allelic association, evaluated with Fisher's exact test and P (excess), was used to refine the IPS haplotype to approximately 1.6 Mb. On the basis of the average length of the haplotype in IPS patients, we calculated the age of a founder mutation to approximately 1,900 years. The IPS haplotype contains a core region of 76 kb consisting of four marker alleles shared by 97.7% of the chromosomes associated with IPS. This region spans four known genes, all of which are expressed in mature epidermal cells. We present the results from the analysis of these four genes and their corresponding transcripts in normal and patient-derived samples.
|
|
| 7. |
|
|
| 8. |
- Berntsson, Andreas, 1978, et al.
(författare)
-
A LIF-study of OH in the Negative Valve Overlap of a Spark-assisted HCCI Combustion Engine
- 2008
-
Ingår i: SAE Technical Papers. - 400 Commonwealth Drive, Warrendale, PA, United States : SAE International. - 0148-7191 .- 2688-3627.
-
Tidskriftsartikel (refereegranskat)abstract
- Future requirements for emission reduction from combustionengines in ground vehicles might be met byusing the HCCI combustion concept. In this study,negative valve overlap (NVO) and low lift, short duration,camshaft profiles, were used to initiate HCCIcombustion by increasing the internal exhaust gas recirculation(EGR) and thus retaining sufficient thermalenergy for chemical reactions to occur when a pilot injectionwas introduced prior to TDC, during the NVO.One of the crucial parameters to control in HCCI combustionis the combustion phasing and one way of doingthis is to vary the relative ratio of fuel injected inpilot and main injections. The combustion phasing isalso influenced by the total amount of fuel supplied tothe engine, the combustion phasing is thus affectedwhen the load is changed. This study focuses on thereactions that occur in the highly diluted environmentduring the NVO when load and pilot to main ratio arechanged.To monitor these reactions, planar laser-induced fluorescence(PLIF) from OH radicals was analyzed ina series of experiments with an optical single-cylinderengine, since these radicals are known to be associatedwith high temperature reactions. A series of experimentswas also performed using a multi-cylinderengine with varied NVO timings, which showed thatthe combustion phasing was influenced by both theratio between the pilot and main injection amountsand the total amount of fuel. Data acquired from correspondingoptical analysis showed the occurrenceof OH radicals (and thus high temperature reactions)during the NVO in all tested operating conditions. Theresults also indicate that the extent of the high temperaturereactions was influenced by both varied parameters,since decreasing the relative amount of the pilotinjection and/or increasing the total amount of fuel ledto larger amounts of OH radicals.
|
|
| 9. |
- Berntsson, Andreas, 1978, et al.
(författare)
-
LIF imaging of OH during the Negative Valve Overlap of a HCCI Combustion Engine
- 2007
-
Ingår i: The Spark Ignition Engine of the Future Conference, Strasbourg - INSA 28/11 - 29/11 2007. ; :Code: R-2007-01-22, s. (9)-
-
Konferensbidrag (refereegranskat)abstract
- Future requirements for emission reduction from combustion engines in ground vehicles might be met by using the HCCI combustion concept. In this concept a more or less homogenous air fuel mixture is compressed to auto-ignition. This gives a good fuel economy compared to a normal SI engine and it has a positive impact on exhaust emissions. In the study presented here negative valve overlap (NVO) was used to initiate HCCI combustion by increasing the exhaust gas recirculation (EGR) and thus retaining sufficient thermal energy to reach auto-ignition temperatures, and raising the temperature during the NVO sufficiently to allow reactions to occur when a pilot injection was made prior to the NVO. The focus of the investigation was on the resulting high temperature reactions.Since OH radicals are associated with high temperature reactions, the reactions were followed by monitoring planar laser-induced fluorescence (PLIF) of OH, using a dye laser and an intensified LaVision Dynamight camera. The presence of OH radicals detected during the negative valve overlap indicates that high temperature reactions do occur in the highly diluted environment of the trapped exhaust gases during the NVO. Reactions were identified from 20 CAD prior to TDC (during the NVO) and to around 60 CAD after TDC, with the intensity peak at about TDC.
|
|
| 10. |
|
|
