| 1. |
- Zhang, Bing, 1982, et al.
(författare)
-
Attempt of the Metallic 3D Printing Technology for Millimeter-Wave Antenna Implementations
- 2016
-
Ingår i: Asia-Pacific Microwave Conference, APMC 2015. ; 2
-
Konferensbidrag (refereegranskat)abstract
- 3D metallic printing technology is attempted to implement millimeter-wave (mmWave) antennas. Based on laser beam melting (LBM) technology, the cost and turnaround time of metallic horn antenna fabrication is effectively reduced compared with traditional milling and injection moulding. A conical and a pyramidal horn antenna are printed in 316L stainless steel, both of which demonstrate satisfactory performance compared with simulation, as well as comparable performance with commercial horn antennas. Surface roughness of the printed horn antennas are measured and analyzed, showing improvement upon former designs. The 3D printing technology proves its great potential for further exploration.
|
|
| 2. |
- Zhang, Bing, 1982, et al.
(författare)
-
Metallic 3-D Printed Antennas for Millimeter- and Submillimeter Wave Applications
- 2016
-
Ingår i: IEEE Transactions on Terahertz Science and Technology. - : Institute of Electrical and Electronics Engineers (IEEE). - 2156-342X .- 2156-3446. ; 6:4, s. 592-600
-
Tidskriftsartikel (refereegranskat)abstract
- This paper presents a study to use the metallic three dimensional (3-D) printing technology for antenna implementations up to 325 GHz. Two different printing technologies and materials are used, namely binder jetting/sintering on 316L stainless steel and selective laser melting (SLM) on Cu-15Sn. Phases, microstructure, and surface roughness are investigated on different materials. Balancing between the cost and performance, the manually polished Cu-15Sn is selected to develop a series of conical horn antennas at the E-(60-90 GHz), D-(110-170 GHz), and H-band (220-325 GHz). Good agreement is observed between the simulated and measured antenna performance. The antennas' impedance bandwidth (vertical bar S-11 vertical bar < -20 dB) cover the whole operational band, with in-band gain of > 22.5, > 22, and > 21.5 dBi for the E-, D-, and H-band antennas, respectively. Compared with the traditional injection molding and micromachining for metallic horn antenna implementation, the 3-D printed metallic horn antenna features environmental friendliness, low cost, and short turn-around time. Compared with the nonmetallic 3-D printed antennas, they feature process simplicity and mechanical robustness. It proves great potential of the metallic 3-D printing technology for both industrial mass production and prototyping.
|
|
