| 1. |
- Abat, E., et al.
(författare)
-
Study of the response of the ATLAS central calorimeter to pions of energies from 3 to 9 GeV
- 2009
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002 .- 1872-9576. ; 607:2, s. 372-386
-
Tidskriftsartikel (refereegranskat)abstract
- A fully instrumented slice of the ATLAS central detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. in this paper, the response of the central calorimeters to pions with energies in the range between 3 and 9 GeV is presented. The linearity and the resolution of the combined calorimetry (electromagnetic and hadronic calorimeters) was measured and compared to the prediction of a detector simulation program using the toolkit Geant 4. (C) 2009 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Anghinolfi, F., et al.
(författare)
-
Hadron beam test of a scintillating fibre tracker system for elastic scattering and luminosity measurement in ATLAS
- 2007
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 2
-
Tidskriftsartikel (refereegranskat)abstract
- A scintillating fibre tracker is proposed to measure elastic proton scattering at very small angles in the ATLAS experiment at CERN. The tracker will be located in so-called Roman Pot units at a distance of 240 m on each side of the ATLAS interaction point. An initial validation of the design choices was achieved in a beam test at DESY in a relatively low energy electron beam and using slow off-the-shelf electronics. Here we report on the results from a second beam test experiment carried out at CERN, where new detector prototypes were tested in a high energy hadron beam, using the first version of the custom designed front-end electronics. With a spatial resolution of 25 mu m an adequate tracking performance was obtained, under conditions which are similar to the situation at the LHC. In addition, the alignment method using so-called overlap detectors was studied and shown to have the expected precision.
|
|
| 3. |
- Mapelli, A., et al.
(författare)
-
Development of a detector (ALFA) to measure the absolute LHC luminosity at ATLAS
- 2008
-
Ingår i: Astroparticle, Particle and Space Physics, Detectors and Medical Physics Applications - Proceedings of the 10th Conference. - 9812819088 - 9789812819086 ; , s. 984-988
-
Konferensbidrag (refereegranskat)abstract
- The ATLAS collaboration plans to determine the absolute luminosity of the CERN LHC at Interaction Point 1 by measuring the trajectory of protons elastically scattered at very small angles (μrad). A scintillating fibre tracker system called ALFA (Absolute Luminosity For ATLAS) is proposed for this measurement. Detector modules will be placed above and below the LHC beam axis in roman pot units at a distance of 240 m on cach side of the ATLAS interaction point. They allow the detectors to approach the beam axis to millimeter distance. Overlap detectors also based on the scintillating fibre technology, will measure the precise relative position of the two detector modules, Results obtained during beam tests at DESY and at CERN validate the detectors design and demonstrate the achievable resolution. We also report about radiation hardness studies of the scintillating fibres to estimate the lifetime of the ALFA system at different operating conditions of the LHC.
|
|
| 4. |
|
|
