| 11. |
- Gustavsson, Eva, et al.
(author)
-
Evaluation of Aerodynamic Particle Sizer and Electrical Low-Pressure Impactor for Unimodal and Bimodal Mass-Weighted Size Distributions
- 2005
-
In: Aerosol Science and Technology. - : Taylor and Francis Ltd. - 0278-6826 .- 1521-7388. ; 39:9, s. 871-887
-
Journal article (peer-reviewed)abstract
- The objective of this study was to investigate the feasibility of the Aerodynamic Particle Sizer (APS) and the Electrical Low-Pressure Impactor (ELPI) to study mass weighted particle size distributions. Unimodal and bimodal liquid test aerosols were produced to a small chamber. Simultaneous measurements were performed with an APS 3320, an APS 3321, an ELPI and a Dekati Low-Pressure Impactor (DLPI) analyzed gravimetrically. ELPI current and mass responses were simulated for lognormal size distributions using a parameterization of the impactor kernel functions. In experiments with a single coarse mode, the mass ratio to the DLPI was between 0.75 and 1.15 for both APS models up to 5 µ m and for the ELPI up to 3 µ m. For larger sizes the ELPI and APS 3320 overestimated and the APS 3321 underestimated the concentration. In experiments with a single fine mode, submicrometer ELPI and DLPI results were in good agreement. However, in contrast to the DLPI all three spectrometers showed a significant mass fraction above 1 µ m. In experiments with a bimodal size distribution, the mass ratios were altered compared to single coarse mode experiments. Simulations showed that uncertainties in ELPI measurements of larger particles occur when concentrations of small particles are high. Several mechanisms that may bias ELPI and APS measurements are described. With knowledge of these, ELPI and APS 3321 can, under many circumstances give accurate time-resolved mass size distributions for particles smaller than 3 and 5 µm, respectively.
|
|
| 12. |
- Isaxon, Christina, et al.
(author)
-
Characteristics of Welding Fume Aerosol Investigated in Three Swedish Workshops
- 2009
-
In: Inhaled Particles X. - : IOP Publishing. - 1742-6596 .- 1742-6588. ; 151
-
Conference paper (peer-reviewed)abstract
- Potentially high human exposures to nanometer sized airborne particles occur due to welding and other thermal processes in industrial environments. Detailed field measurements of physical and chemical particle characteristics were performed in three work-shops in Sweden. Measurements were performed both in the plume 5-20 cm above the welding point and in the background air (more than 5 m away from the nearest known particle source). Particle number and mass concentrations were measured on-line. A low pressure impactor was used for size-resolved chemical particle composition. The in-plume measurements generated the chemical signatures for different welding processes. These signatures were then used to identify contributions from various processes to the particle concentrations in different size classes. The background number and mass concentrations increased by more than an order of magnitude during intense activities in the work-shops compared to low activities during breaks.
|
|
| 13. |
|
|
| 14. |
|
|
| 15. |
- Khalizov, Alexei F., et al.
(author)
-
Formation of highly hygroscopic soot aerosols upon internal mixing with sulfuric acid vapor
- 2009
-
In: Journal of Geophysical Research. - 2156-2202. ; 114
-
Journal article (peer-reviewed)abstract
- The hygroscopic properties of submicron soot particles during internal mixing with gaseous sulfuric acid have been investigated using a combined tandem differential mobility analyzer (TDMA) and differential mobility analyzer-aerosol particle mass analyzer (DMA-APM) technique. Fresh particles exhibit no change in mobility size and mass at subsaturated conditions, whereas particles exposed to gaseous sulfuric acid (10(9)-10(10) molecule cm(-3), 12 s contact time) experience significant mobility size and mass changes with increasing relative humidity (RH). The DMA-APM measurements reveal that particles of all sizes exposed to H2SO4 vapor gain mass with increasing RH because of absorption of water by sulfuric acid coating. However, on the basis of mobility size measurements using TDMA, upon humidification H2SO4-coated soot agglomerates display distinct hygroscopic growth patterns depending on their initial size and the mass fraction of condensed sulfuric acid. While small particles experience an increase in their mobility sizes, larger particles exhibit a marked shrinkage due to compaction. We suggest that determination of the hygroscopic properties of soot particles using a TDMA alone can be inconclusive. Restructuring of the soot agglomerates and filling of the voids that accompany the condensation of water-soluble materials and subsequent water absorption lead to little or no observable changes in particle mobility size at subsaturated RH even for particles that contain aqueous coatings. Extrapolation of our experimental results to the urban atmosphere indicates that initially hydrophobic soot particles acquire sufficient sulfate coating to become efficient CCN (cloud condensation nuclei) within a time period ranging from a few hours to a few days, dependent on the ambient H2SO4 level. The results imply that internal mixing with sulfuric acid through H2SO4 vapor condensation likely represents a common aging process for a variety of atmospheric aerosols. The variations in the size and hygroscopicity of soot particles during atmospheric processing influence their optical properties, cloud-forming potential, and human health effects.
|
|
| 16. |
- Löndahl, Jakob, et al.
(author)
-
A set-up for field studies of respiratory tract deposition of fine and ultrafine particles in humans
- 2006
-
In: Journal of Aerosol Science. - : Elsevier BV. - 0021-8502. ; 37:9, s. 1152-1163
-
Journal article (peer-reviewed)abstract
- Respiratory tract deposition data of ultrafine aerosol particles, hygroscopic particles and ambient particles in general are scarce. Measurements are associated with several difficulties. The objective of this work was to design a method for fast determination of highly size-resolved fine and ultrafine particle deposition, to be used on larger groups of human subjects in exposure studies and in typical ambient and indoor environments. The particle size distributions in dried samples of the inhaled and exhaled air are characterised with an electrical mobility spectrometer. A particle counter desmearing procedure reduces the spectrometer scan time. The precision and sensitivity of the method was tested for hygroscopic sodium chloride (NaCl) and hydrophobic Di-Ethyl-Hexyl-Sebacate (DEHS) aerosols in repeated identical experiments and experiments with different breathing frequencies on a single subject. The accuracy of the method was estimated by comparing results from three subjects with previous data obtained with monodisperse particles and with the well-established International Commission on Radiological Protection model (1994). Potential errors due to size shifts between the inhaled and exhaled samples and coagulation were simulated. The system has low losses in the studied particle size range (10-475 nm), typically 10% or less of the fraction deposited in the respiratory tract. Coagulation is noticeable at 10(5) cm(-3) but can be corrected for up to 5 x 10(5) cm(-3). The precision in the determined deposited fraction is 0.02-0.08. The method is sensitive enough to quantify differences between breathing patterns and differences between hygroscopic and hydrophobic aerosols. Our results for NaCl and DEHS are in agreement with the ICRP 66 model [International Commission on Radiological Protection. (1994). Human respiratory tract model for radiological protection (ICRP Publication 66). Oxford, UK: Elsevier Science], and also suggest that the relative humidity in the respiratory tract is close to 99.5%. A respiratory tract deposition measurement can be done in 15-30 min. Recommendations are given for field applications of the method. (C) 2005 Elsevier Ltd. All rights reserved.
|
|
| 17. |
|
|
| 18. |
- Löndahl, Jakob, et al.
(author)
-
Deposition of biomass combustion aerosol particles in the human respiratory tract.
- 2008
-
In: Inhalation Toxicology. - : Informa UK Limited. - 0895-8378 .- 1091-7691. ; 20:10, s. 923-933
-
Journal article (peer-reviewed)abstract
- Smoke from biomass combustion has been identified as a major environmental risk factor associated with adverse health effects globally. Deposition of the smoke particles in the lungs is a crucial factor for toxicological effects, but has not previously been studied experimentally. We investigated the size-dependent respiratory-tract deposition of aerosol particles from wood combustion in humans. Two combustion conditions were studied in a wood pellet burner: efficient ("complete") combustion and low-temperature (incomplete) combustion simulating "wood smoke." The size-dependent deposition fraction of 15-to 680-nm particles was measured for 10 healthy subjects with a novel setup. Both aerosols were extensively characterized with regard to chemical and physical particle properties. The deposition was additionally estimated with the ICRP model, modified for the determined aerosol properties, in order to validate the experiments and allow a generalization of the results. The measured total deposited fraction of particles from both efficient combustion and low-temperature combustion was 0.21-0.24 by number, surface, and mass. The deposition behavior can be explained by the size distributions of the particles and by their ability to grow by water uptake in the lungs, where the relative humidity is close to saturation. The experiments were in basic agreement with the model calculations. Our findings illustrate: (1) that particles from biomass combustion obtain a size in the respiratory tract at which the deposition probability is close to its minimum, (2) that particle water absorption has substantial impact on deposition, and (3) that deposition is markedly influenced by individual factors.
|
|
| 19. |
|
|
| 20. |
|
|
