| 1. |
- Aghaeipour, Mahtab
(författare)
-
Tailoring the Optical Response of III-V Nanowire Arrays
- 2017
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Semiconductor nanowires show a great deal of promise for applications in a wide range of important fields, including photovoltaics, biomedicine, and information technology. Developing these exciting applications is strongly dependent on understanding the fundamental properties of nanowires, such as their optical resonances and absorption spectra. In this thesis we explore optical absorption spectra of arrays of vertical III-V nanowires with a special emphasis on structures optimized to enhance absorption in the solar spectrum. First, we analyze experimentally determined absorption spectra of both indium phosphide (InP) and gallium phosphide (GaP) nanowire arrays. The study provides an intuitive understanding of how the observed absorption resonances in the nanowires may be tuned as a function of their geometrical parameters and crystal structure. As a consequence, the spectral position of absorption resonances can be precisely controlled through the nanowire diameter. However, the results highlight how the blue-shift in the optical absorption resonances as the diameter of the nanowires decreases comes to a halt at low diameters. The stop point is related to the behavior of the refractive indices of the nanowires. The wavelength of the stop is different for nanowire polytypes of similar dimensions due to differences in their refractive indices. We then present a theoretical argument that it is important to consider symmetry properties when tailoring the optical modes excited in the nanowires for enhanced absorption. We show that absorption spectra may be enhanced compared to vertical nanowires at normal incidence by tilting the nanowires with normal incidence light, or by using off-normal incidence with vertical nanowires. This is because additional optical modes inside the nanowires are excited when the symmetry is broken. Looking forward to omnidirectional applications, we consider branched nanowires as a way to enhance the absorption spectra at normal incidence by taking advantage of simultaneous excitation of the spectrally different optical modes in the branches and the stems. Third, we describe in theoretical terms how integrating distributed Bragg reflectors (DBRs) with the nanowires can improve absorption spectra compared to conventional nanowires. DBRs provide a way to employ light trapping mechanisms which increases the optical path length of the excited modes and thereby improves the absorption of the excited modes. At normal incidence, DBR-nanowires improve the absorption efficiency to 78%, compared to 72% for conventional nanowires. We show that the efficiency is increased to 85% for an off-normal incident angle of 50˚. Overall, our results show that studies of optical resonances in nanowires that take the light-matter interaction into account provide opportunities to develop novel optical and optoelectronic functionalities in nanoscience and nanotechnology.
|
|
| 2. |
- Berg, Alexander, et al.
(författare)
-
Radial Nanowire Light-Emitting Diodes in the (AlxGa1-x)yIn1-yP Material System
- 2016
-
Ingår i: Nano letters (Print). - Washington, DC : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 16:1, s. 656-662
-
Tidskriftsartikel (refereegranskat)abstract
- Nanowires have the potential to play an important role for next-generation light-emitting diodes. In this work, we present a growth scheme for radial nanowire quantum-well structures in the AlGaInP material system using a GaInP nanowire core as a template for radial growth with GaInP as the active layer for emission and AlGaInP as charge carrier barriers. The different layers were analyzed by X-ray diffraction to ensure lattice-matched radial structures. Furthermore, we evaluated the material composition and heterojunction interface sharpness by scanning transmission electron microscopy energy dispersive X-ray spectroscopy. The electro-optical properties were investigated by injection luminescence measurements. The presented results can be a valuable track toward radial nanowire light-emitting diodes in the AlGaInP material system in the red/orange/yellow color spectrum. © 2015 American Chemical Society.
|
|
| 3. |
- Bordag, Michael, et al.
(författare)
-
Shear stress measurements on InAs nanowires by AFM manipulation
- 2007
-
Ingår i: Small. - Weinheim : Wiley-VCH Verlagsgesellschaft. - 1613-6810 .- 1613-6829. ; 3:8, s. 1398-1401
-
Tidskriftsartikel (refereegranskat)abstract
- On an upward curve? The curvature of an elastically deformed nanowire pinned to a flat surface contains information about the maximum static friction force, and hence the shear stress, between the nanowire and the surface. Here, InAs nanowires are bent in a controlled manner using the tip of an atomic force microscope (see image). The shear stress can be obtained from a simple analysis according to the standard theory of elasticity.
|
|
| 4. |
- Borschel, Christian, et al.
(författare)
-
A New Route toward Semiconductor Nanospintronics : Highly Mn-Doped GaAs Nanowires Realized by Ion-Implantation under Dynamic Annealing Conditions
- 2011
-
Ingår i: Nano letters (Print). - Washington : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 11:9, s. 3935-3940
-
Tidskriftsartikel (refereegranskat)abstract
- We report on highly Mn-doped GaAs nanowires (NWs) of high crystalline quality fabricated by ion beam implantation, a technique that allows doping concentrations beyond the equilibrium solubility limit. We studied two approaches for the preparation of Mn-doped GaAs NWs: First, ion implantation at room temperature with subsequent annealing resulted in polycrystalline NWs and phase segregation of MnAs and GaAs. The second approach was ion implantation at elevated temperatures. In this case, the single-crystallinity of the GaAs NWs was maintained, and crystalline, highly Mn-doped GaAs NWs were obtained. The electrical resistance of such NWs dropped with increasing temperature (activation energy about 70 meV). Corresponding magnetoresistance measurements showed a decrease at low temperatures, indicating paramagnetism. Our findings suggest possibilities for future applications where dense arrays of GaMnAs nanowires may be used as a new kind of magnetic material system.
|
|
| 5. |
- Conache, Gabriela, et al.
(författare)
-
AFM-based manipulation of InAs nanowires
- 2008
-
Ingår i: Proceedings of the IVC-17 (17th International Vacuum Congress) [also] ICSS-13 (13th International Conference on Surface Science) [also] ICN+T-2007 (International Conference on Nanoscience and Technology). - Bristol : Institute of Physics (IOP). ; 100, s. 052051-052051
-
Konferensbidrag (refereegranskat)abstract
- A controlled method of manipulation of nanowires was found using the tip of an Atomic Force Microscope (AFM). Manipulation is done in the ‘Retrace Lift’ mode, where feedback is turned off for the reverse scan and the tip follows a nominal path. The effective manipulation force during the reverse scan can be changed by varying an offset in the height of the tip over the surface. Using this method, we have studied InAs nanowires on different substrates. We have also investigated interactions between wires and with gold features patterned onto the substrates.
|
|
| 6. |
- Conache, Gabriela, et al.
(författare)
-
Bias-controlled friction of InAs nanowires on a silicon nitride layer studied by atomic force microscopy
- 2010
-
Ingår i: Physical Review B Condensed Matter. - College Park, Md. : American Physical Society. - 0163-1829 .- 1095-3795. ; 82:3
-
Tidskriftsartikel (refereegranskat)abstract
- By studying how nanowires lying on a surface bend when pushed by an atomic force microscopy tip we are able to measure the friction between them and the substrate. Here, we show how the friction between InAs nanowires and an insulating silicon nitride layer varies when a dc voltage is applied to the tip during manipulation. The bias charges the capacitor formed by the wire and the grounded silicon back contact. Electrostatic forces increase the contact pressure and allow us to tune the friction between the wire and the silicon nitride surface. Using nanowires of about 40-70 nm diameter and a few microns in length we have applied biases in the range +12 to -12 V. A monotonic increase of the sliding friction with voltage was observed. This increase in friction with the normal force implies that the mesoscopic nanowire-surface system behaves like a macroscopic contact, despite the nanometer size of the contact in the direction of motion. The demonstrated bias-controlled friction has potential applications in MEMS/NEMS devices.
|
|
| 7. |
- Conache, Gabriela, et al.
(författare)
-
Comparative friction measurements of InAs nanowires on three substrates
- 2010
-
Ingår i: Journal of Applied Physics. - College Park, MD : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 108:9
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated friction between InAs nanowires and three different substrates: SiO2, fluorosilanized SiO2, and Si3N4. The nanowires were pushed laterally with the tip of an atomic force microscope and the friction force per unit length for both static and sliding friction was deduced from the equilibrium shape of the bent wires. On all three substrates, thick wires showed a difference between sliding and static friction of up to three orders of magnitude. Furthermore, all substrates display a transition to stick-slip motion for nanowires with a diameter of less than about 40 nm. Hydrophobic and hydrophilic substrates display similar friction behavior suggesting that a condensed water layer does not strongly influence our results. The patterns and trends in the friction data are similar for all three substrates, which indicates that they are more fundamental in character and not specific to a single substrate. ©2010 American Institute of Physics.
|
|
| 8. |
- Conache, Gabriela, et al.
(författare)
-
Friction measurements of InAs nanowires on Silicon nitride by AFM manipulation
- 2009
-
Ingår i: Small. - Weinheim, Germany : Wiley-VCH Verlagsgesellschaft. - 1613-6810 .- 1613-6829. ; 5:2, s. 203-207
-
Tidskriftsartikel (refereegranskat)abstract
- A study was conducted to perform friction measurements of InAs nanowires (NW) on silicon nitride (Si 3N 4) through atomic force microscopy (AFM) manipulation. The investigations revealed the friction force per unit length for sliding and static friction over a range of nanowire diameters. It was found that there is a significant difference between the coefficients of the two sliding modes for large wires. It was also found that the difference between the two sliding modes disappears at smaller diameters and the sliding friction becomes equal with the static friction. The AFM investigations were performed on a Nanoscope IIIa Dimension 3100, using rectangular cantilevers, with a nominal spring constant of 30 N m -1. The nanowires were manipulated, using the 'Retrace Lift' mode of the AFM controller. The friction force per unit length was gathered from the local curvature of the NWs, using standard elasticity theory.
|
|
| 9. |
- Hussain, Laiq, et al.
(författare)
-
Defect-induced infrared electroluminescence from radial GaInP/AlGaInP quantum well nanowire array light- emitting diodes
- 2017
-
Ingår i: Nanotechnology. - Bristol : IOP Publishing. - 0957-4484 .- 1361-6528. ; 28:48
-
Tidskriftsartikel (refereegranskat)abstract
- Radial GaInP/AlGaInP nanowire array light-emitting diodes (LEDs) are promising candidates for novel high-efficiency solid state lighting due to their potentially large strain-free active emission volumes compared to planar LEDs. Moreover, by proper tuning of the diameter of the nanowires, the fraction of emitted light extracted can be significantly enhanced compared to that of planar LEDs. Reports so far on radial growth of nanowire LED structures, however, still point to significant challenges related to obtaining defect-free radial heterostructures. In this work, we present evidence of optically active growth-induced defects in a fairly broad energy range in vertically processed radial GaInP/AlGaInP quantum well nanowire array LEDs using a variety of complementary experimental techniques. In particular, we demonstrate strong infrared electroluminescence in a spectral range centred around 1 eV (1.2 μm) in addition to the expected red light emission from the quantum well. Spatially resolved cathodoluminescence studies reveal a patchy red light emission with clear spectral features along the NWs, most likely induced by variations in QW thickness, composition and barriers. Dark areas are attributed to infrared emission generated by competing defect-assisted radiative transitions, or to trapping mechanisms involving non-radiative recombination processes. Possible origins of the defects are discussed.
|
|
| 10. |
- Jafari Jam, R., et al.
(författare)
-
Embedded sacrificial AlAs segments in GaAs nanowires for substrate reuse
- 2020
-
Ingår i: Nanotechnology. - Bristol : Institute of Physics Publishing (IOPP). - 0957-4484 .- 1361-6528. ; 31:20
-
Tidskriftsartikel (refereegranskat)abstract
- We report on the use of a sacrificial AlAs segment to enable substrate reuse for nanowire synthesis. A silicon nitride template was deposited on a p-type GaAs substrate. Then a pattern was transferred to the substrate by nanoimprint lithography and reactive ion etching. Thermal evaporation was used to define Au seed particles. Metalorganic vapour phase epitaxy was used to grow AlAs-GaAs NWs in the vapour-liquid-solid growth mode. The yield of synthesised nanowires, compared to the number expected from the patterned template, was more than 80%. After growth, the nanowires were embedded in a polymer and mechanically removed from the parent substrate. The parent substrate was then immersed in an HCl:H2O (1:1) mixture to dissolve the remaining stub of the sacrificial AlAs segment. The pattern fidelity was preserved after peeling off the nanowires and cleaning, and the semiconductor surface was flat and ready for reuse. Au seed particles were then deposited on the substrate by use of pulse electrodeposition, which was selective to the openings in the growth template, and then nanowires were regrown. The yield of regrowth was less optimal compared to the first growth but the pattern was preserved. Our results show a promising approach to reduce the final cost of III-V nanowire based solar cells. © 2020 The Author(s). Published by IOP Publishing Ltd.
|
|
