| 1. |
- Charalampakis, Georgios, et al.
(författare)
-
Effect of cleansing of biofilm formed on titanium discs.
- 2015
-
Ingår i: Clinical oral implants research. - : Wiley. - 1600-0501 .- 0905-7161. ; 26:8
-
Tidskriftsartikel (refereegranskat)abstract
- To study the combined effect of mechanical and chemical cleansing on a 4-day biofilm grown intra-orally on titanium discs with different surface characteristics.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Abrahamsson, Ingemar, 1953, et al.
(författare)
-
Early bone formation adjacent to rough and turned endosseous implant surfaces. An experimental study in the dog
- 2004
-
Ingår i: Clinical Oral Implants Research. - : Wiley. - 0905-7161 .- 1600-0501. ; 15:4, s. 381-92
-
Tidskriftsartikel (refereegranskat)abstract
- OBJECTIVE: To validate a proposed model (Berglundh et al. 2003) and to evaluate the rate and degree of osseointegration at turned (T) and sand blasted and acid etched (SLA) implant surfaces during early phases of healing. MATERIAL AND METHODS: The devices used for the study of early healing had a geometry that corresponded to that of a solid screw implant with either a SLA or a T surface configuration. A circumferential trough had been prepared within the thread region (intra-osseous portion) that established a geometrically well-defined wound chamber. Twenty Labrador dogs received totally 160 experimental devices to allow the evaluation of healing between 2 h and 12 weeks. Both ground and decalcified sections were prepared from mesial/distal and buccal/lingual device sites. Histometric and morphometric analyses of the ground sections and morphometric analysis of the tissue components in decalcified sections were performed. RESULTS: The ground sections provided an overview of the various phases of tissue formation, while the decalcified, thin sections enabled a more detailed study of events involved in bone tissue modeling and remodeling for both SLA and T surfaces. The initially empty wound chamber became occupied with a coagulum and a granulation tissue that was replaced by a provisional matrix. The process of bone formation started already during the first week. The newly formed bone present at the lateral border of the cut bony bed appeared to be continuous with the parent bone, but on the SLA surface woven bone was also found at a distance from the parent bone. Parallel-fibered and/or lamellar bone as well as bone marrow replaced this primary bone after 4 weeks. In the SLA chambers, more bone-to-device contact, more initial woven bone and earlier lamellar bone formation was found than in the T chambers. CONCLUSION: Osseointegration represents a dynamic process both during its establishment and its maintenance. While healing showed similar characteristics with resorptive and appositional events for both SLA and T surfaces, the rate and degree of osseointegration were superior for the SLA compared with the T chambers.
|
|
| 6. |
- Abrahamsson, Ingemar, 1953, et al.
(författare)
-
Early bone healing to implants with different surface characteristics. A pre-clinical in vivo study
- 2023
-
Ingår i: Clinical Oral Implants Research. - : Wiley. - 0905-7161 .- 1600-0501. ; 34:4, s. 312-9
-
Tidskriftsartikel (refereegranskat)abstract
- AimTo examine early bone healing around implants with non-modified and modified surfaces. Material & MethodsFour implants with 4 different surface characteristics were installed in one side of the mandible following tooth extraction in 6 dogs. Implants in group A had a non-modified, turned surface, while implants in group B had a surface modification consisting of TiO-blasting and sequential acid-etching in oxalic and hydrofluoric acid. The surface modification of implants in group C was confined to sequential acid-etching in oxalic and hydrofluoric acid and Group D implants had a surface modification of TiO-blasting and acid-etching in hydrofluoric acid. The implant installation procedures were repeated in the opposite side of the mandible 4 weeks later. Biopsies were obtained and prepared for histological analysis 2 weeks later. ResultsB and C implants had a higher degree of bone-to-implant contact (BIC%) than A and D implants at 2 weeks of healing. At 6 weeks of healing, the BIC% was higher at B than at A, C and D implants, and higher at C implants than at A implants. The amount of newly formed bone in contact with the implant within the defect area at 2 weeks was higher at implants with modified surfaces (groups B, C and D) than at implants with a non-modified surface (group A). Corresponding results at 6 weeks were superior at B implants. ConclusionIt is suggested that an implant surface modification with acid-etching in oxalic and hydrofluoric acid promotes early formation of bone-to-implant contact.
|
|
| 7. |
|
|
| 8. |
- Abrahamsson, Ingemar, 1953, et al.
(författare)
-
Healing at fluoride-modified implants placed in wide marginal defects: an experimental study in dogs.
- 2008
-
Ingår i: Clinical oral implants research. - : Wiley. - 0905-7161 .- 1600-0501. ; 19:2, s. 153-9
-
Tidskriftsartikel (refereegranskat)abstract
- Objective: To study the healing at fluoride-modified implants placed in wide circumferential defects. Material and methods: Six mongrel dogs were used. The mandibular premolars and first molars were extracted. Three months later four implants were placed in one side of the mandible of each dog. The control implants (MicroThread(trade mark)) had a TiOblast surface, while the test implants (OsseoSpeed(trade mark)) had a fluoride-modified surface. Two implants of each type were placed. The marginal 50% of the prepared canal was widened using step drills. Following installation a 1 mm wide gap occurred between the implant surface and the bone wall in the defect. All implants were submerged. The installation procedure was repeated in the opposite side of the mandible 4 weeks after the first implant surgery. Two weeks later the animals were euthanized and block biopsies containing the implant and surrounding tissues were prepared for histological analysis. Results: The histological analysis revealed that a significantly larger area of osseointegration was established within the defect at fluoride-modified implants than at implants with a TiOblast surface after 6 weeks of healing. Further, the degree of bone-to-implant contact within the defect area was larger at fluoride-modified implants than at the TiOblast implants. Conclusion: It is suggested that the fluoride-modified implant surface promotes bone formation and osseointegration.
|
|
| 9. |
- Abrahamsson, Ingemar, 1953, et al.
(författare)
-
Healing at Implants Placed in an Alveolar Ridge with a Sloped Configuration: An Experimental Study in Dogs.
- 2014
-
Ingår i: Clinical implant dentistry and related research. - : Wiley. - 1708-8208 .- 1523-0899. ; 16:1
-
Tidskriftsartikel (refereegranskat)abstract
- Purpose: To study healing around implants placed in an alveolar ridge with a sloped lingual-buccal configuration. Materials and Methods: Six Labrador dogs were used. Buccal bone defects were prepared in the mandible after extraction of premolars. Three months later, two test implants with a sloped marginal design and two control implants were placed in the chronic defect area with a sloped lingual-buccal configuration of each premolar region. The test implants were placed in such a way that the buccal margin of the implant coincided with the buccal bone crest. The lingual margin of the control implants was placed to a similar depth as the lingual margin of the test implants. Abutments were connected to the implants in the right mandibular premolar region and flaps were sutured around the neck of the abutments. In the left side of the mandible, cover screws were placed and the flaps were sutured to cover the implants. Biopsies were obtained 4 months later and prepared for histological examination. Results: It was demonstrated that healing around implants placed in an alveolar ridge with a sloped lingual-buccal configuration resulted in the preservation of a vertical discrepancy between the lingual and buccal marginal bone levels around implants with either a regular cylindrical outline or a modified marginal portion that matched the slope of the alveolar ridge. Conclusion: As the marginal buccal portion of the control implants with a regular design had no bone support, it is suggested that implants with a modified marginal portion may be considered in recipient sites with a sloped lingual-buccal configuration.
|
|
| 10. |
|
|
