| 1. |
|
|
| 2. |
- Maurina Morais, Eduardo, 1989, et al.
(författare)
-
Solvent-free synthesis of protic ionic liquids. Synthesis, characterization and computational studies of triazolium based ionic liquids
- 2022
-
Ingår i: Journal of Molecular Liquids. - : Elsevier BV. - 0167-7322. ; 360
-
Tidskriftsartikel (refereegranskat)abstract
- A series of triazolium and imidazolium based protic ionic liquids were synthesized using a solvent-free method designed to address several limitations encountered with other commonly used methods. Using this method, pure (98–99% m/m) and dry (128–553 ppm of water) protic ionic liquids were synthesized (in a laboratory scale) without the need for purification methods that require heating the ionic liquid, hence avoiding the common issue of thermal decomposition. This method was also designed to allow for the accurate measurement of acid and base, and for the controlled mixing of both compounds, which is essential to avoid producing impure protic ionic liquids with excess of either acid or base. The system is constructed of only glass and chemically resistant polymer (PTFE and PVDF) parts, which avoid other contaminants that can result from unwanted reactions involving the reagents with common laboratory tools (metallic objects, paper, plastic, etc.). This process is described in detail in the paper as well as in a video. The resulting ionic liquids were carefully analyzed by spectroscopic and thermal methods designed to avoid water absorption, which is known to affect their properties. To complement this experimental characterization, computational chemistry tools were used to assess the ionic liquids’ properties, as well as to assign vibrational modes.
|
|
| 3. |
- Sauer, Christopher, 1993
(författare)
-
Green Aromatics: Catalytic Valorisation of bio-derived 2,5-dimethylfuran over Zeolites and Zeotypes
- 2022
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- This thesis discusses the use of biomass as a potentially green feedstock for the chemical industry in the urgent shift away from fossil resources. I elaborate on reasons why we cannot afford to burn virgin biomass for energy production, among them a variety of ecosystem services that forests and other lands provide. In addition, the utilisation of biomass should be focused on products that sequester and lock away carbon for more extended periods, e.g. timber, materials and chemicals. In particular, biomass can be used as an alternative "carbon neutral" feedstock for the chemical industry, where we can preserve the already existing chemical complexity in the bio-based molecules. One example is the upgrading of furans to benzene, toluene and xylene (BTX) aromatics with the help of zeolite catalysis. These aromatics are important commodity chemicals, where the shift to a bio-based resource could make use of already existing knowledge, catalyst and production infrastructure. However, research is necessary to understand these new feedstock molecules and their interaction with the catalysts and to enable the design of applicable catalysts. In order to study the interaction of the furans, in particular 2,5-dimethylfuran (2,5-dmf), I describe and discuss the development of an analytical methodology that utilises infrared spectroscopy and mass spectrometry for the on-line identification and quantification of product molecules during catalytic reactions. This on-line analysis method is then applied to the catalytic conversion of 2,5-dmf to aromatics over a range of zeolite and zeotype catalysts. In-depth studies with ammonia as a probe molecule of the catalytic active acid sites, as well as temperature programmed experiments with ammonia and 2,5-dmf give insights into product distribution, selectivity changes and deactivation of the catalyst. For example, olefins and aromatics are initially preferred products, while with increasing time on stream, the isomerisation of 2,5-dmf becomes dominant. The incorporation of Ga into the zeotype framework, resulting in a Ga-Silicate, shows how targeted catalyst design can increase overall aromatics production. This catalyst is also suitable for selective isomerisation of 2,5-dmf to 2,4-dimethylfuran, which has a rare substitution pattern. Finally, itwas found that the most valuable of BTX, p -xylene, can be produced more selectively when 2,5-dmf is pre-adsorbed onto zeolite ZSM-5 and then released during a temperature programmed product desorption.
|
|
| 4. |
|
|
| 5. |
- Guo, Y., et al.
(författare)
-
Reversible Structural Isomerization of Nature's Water Oxidation Catalyst Prior to O-O Bond Formation
- 2022
-
Ingår i: Journal of the American Chemical Society. - : American Chemical Society (ACS). - 0002-7863 .- 1520-5126. ; 144:26, s. 11736-11747
-
Tidskriftsartikel (refereegranskat)abstract
- Photosynthetic water oxidation is catalyzed by a manganese-calcium oxide cluster, which experiences five "S-states" during a light-driven reaction cycle. The unique "distorted chair"-like geometry of the Mn4CaO5(6)cluster shows structural flexibility that has been frequently proposed to involve "open" and "closed"-cubane forms from the S1 to S3states. The isomers are interconvertible in the S1 and S2states, while in the S3state, the open-cubane structure is observed to dominate inThermosynechococcus elongatus (cyanobacteria) samples. In this work, using density functional theory calculations, we go beyond the S3+Yzstate to the S3nYz•→ S4+Yzstep, and report for the first time that the reversible isomerism, which is suppressed in the S3+Yzstate, is fully recovered in the ensuing S3nYz•state due to the proton release from a manganese-bound water ligand. The altered coordination strength of the manganese-ligand facilitates formation of the closed-cubane form, in a dynamic equilibrium with the open-cubane form. This tautomerism immediately preceding dioxygen formation may constitute the rate limiting step for O2formation, and exert a significant influence on the water oxidation mechanism in photosystem II.
|
|
| 6. |
- Artemenko, A., et al.
(författare)
-
Reference XPS spectra of amino acids
- 2021
-
Konferensbidrag (refereegranskat)abstract
- In this report we present XPS data for five amino acids (AAs) (tryptophan, methionine, glutamine, glutamic acid, and arginine) with different side chain groups measured in solid state (powder form). The theoretically and experimentally obtained chemical structure of AAs are compared. Here, we analyse and discuss C 1 s, N 1 s, O 1s and S 2p core level binding energies, FWHMs, atomic concentrations of the functional groups in AAs. The experimentally obtained and theoretically calculated ratio of atomic concentrations are compared. The zwitterionic nature of methionine and glutamine in solid state was determined from protonated amino groups in N 1s peak and deprotonated carboxylic groups in the C 1s spectrum. The obtained XPS results for AAs well correspond with previously reported data.
|
|
| 7. |
- Barišić, Antun, et al.
(författare)
-
Experimental Data Contributing to the Elusive Surface Charge of Inert Materials in Contact with Aqueous Media
- 2021
-
Ingår i: Colloids and interfaces. - : MDPI. - 2504-5377. ; 5:1
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- We studied the charging of inert surfaces (polytetrafluoroethylene, i.e., PTFE; graphite; graphene; and hydrophobic silica) using classical colloid chemistry approaches. Potentiometric titrations showed that these surfaces acquired less charge from proton-related reactions than oxide minerals. The data from batch-type titrations for PTFE powder did not show an effect of ionic strength, which was also in contrast with results for classical colloids. In agreement with classical colloids, the electrokinetic results for inert surfaces showed the typical salt level dependence. In some cases, the point of zero net proton charge as determined from mass and tentatively from acid–base titration differed from isoelectric points, which has also been previously observed, for example by Chibowski and co-workers for ice electrolyte interfaces. Finally, we found no evidence for surface contaminations of our PTFE particles before and after immersion in aqueous solutions. Only in the presence of NaCl-containing solutions did cryo-XPS detect oxygen from water. We believe that our low isoelectric points for PTFE were not due to impurities. Moreover, the measured buffering at pH 3 could not be explained by sub-micromolar concentrations of contaminants. The most comprehensive explanation for the various sets of data is that hydroxide ion accumulation occurred at the interfaces between inert surfaces and aqueous solutions.
|
|
| 8. |
- Brinck, Tore, et al.
(författare)
-
Green Energetic Materials, Chapter 2: "Theoretical Design of Green Energetic Materials: Predicting Stability, Detection, Synthesis and Performance"
- 2014
-
Ingår i: Green Energetic Materials. - 9781119941293 ; , s. 15-44
-
Bokkapitel (övrigt vetenskapligt/konstnärligt)abstract
- Since the end of the 20th century it has been increasingly realised that the use, or production, of many energetic materials leads to the release of substances which are harmful to both humans and the environment. To address this, the principles of green chemistry can be applied to the design of new products and their manufacturing processes, to create green energetic materials that are virtually free of environmental hazards and toxicity issues during manufacturing, storage, use and disposal. Active research is underway to develop new ingredients and formulations, green synthetic methods and non-polluting manufacturing processes.Green Energetic Materials provides a detailed account of the most recent research and developments in the field, including green pyrotechnics, explosives and propellants. From theoretical modelling and design of new materials, to the development of sustainable manufacturing processes, this book addresses materials already on the production line, as well as considering future developments in this evolving field.Topics covered include:Theoretical design of green energetic materialsDevelopment of green pyrotechnicsGreen primary and secondary explosivesOxidisers and binder materials for green propellantsEnvironmentally sustainable manufacturing technologies for energetic materialsElectrochemical methods for synthesis of energetic materials and waste remediationGreen Energetic Materials is a valuable resource for academic, industrial and governmental researchers working on the development of energetic materials, for both military and civilian applications.
|
|
| 9. |
- Brinck, T, et al.
(författare)
-
Green Energetic Materials, Chapter 7: "Green propellants Based on Dinitramide Salts: Mastering Stability and Chemical Compatibility Issues"
- 2014
-
Ingår i: Green Energetic Materials, kapitel 7. - 9781119941293 ; , s. 179-204
-
Bokkapitel (övrigt vetenskapligt/konstnärligt)abstract
- Since the end of the 20th century it has been increasingly realised that the use, or production, of many energetic materials leads to the release of substances which are harmful to both humans and the environment. To address this, the principles of green chemistry can be applied to the design of new products and their manufacturing processes, to create green energetic materials that are virtually free of environmental hazards and toxicity issues during manufacturing, storage, use and disposal. Active research is underway to develop new ingredients and formulations, green synthetic methods and non-polluting manufacturing processes.Green Energetic Materials provides a detailed account of the most recent research and developments in the field, including green pyrotechnics, explosives and propellants. From theoretical modelling and design of new materials, to the development of sustainable manufacturing processes, this book addresses materials already on the production line, as well as considering future developments in this evolving field.Topics covered include:Theoretical design of green energetic materialsDevelopment of green pyrotechnicsGreen primary and secondary explosivesOxidisers and binder materials for green propellantsEnvironmentally sustainable manufacturing technologies for energetic materialsElectrochemical methods for synthesis of energetic materials and waste remediationGreen Energetic Materials is a valuable resource for academic, industrial and governmental researchers working on the development of energetic materials, for both military and civilian applications.
|
|
| 10. |
- Nyström-Larsson, Ingalill, 1969, et al.
(författare)
-
Materialanalys av sydsvenskt bonadsmåleri
- 2007
-
Ingår i: Rapport: Sammanfattning av Riksantikvarieämbetets seminarieserie 2007 kring pågående FoU-projekt. ; , s. 23-24
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- Bonadsmåleriet hade sin storhetstid 1750-1850, och var influerat av medeltida kalkmåleri och bildvävnad i kyrkorna. Bonaderna var temporära och prydde stugorna till fest. Motiven kan vara både bibliska och profana. Materialet är tyger (återanvända och hopfogade) och senare även papper. Mot slutet av perioden övergår hantverket i massproduktion. Tidigare har bonaderna framför allt studerats inom humaniora (exempelvis etnologi) och ett naturvetenskapligt perspektiv har saknats. Därför finns mycket knapphändiga uppgifter om materialet. Syftet med projektet är att: • Kartlägga materialanvändningen • Tolka och förstå materialutvecklingen • Klarlägga innehållet i de otydliga trivialnamnen • Bygga upp ett referensmaterial Genomförande Ett antal frågeställningar har satts upp inför studiet: • Vilka materialval har man gjort? • Skiljer måleriteknik, färg, materialval mellan bonader, och går det att urskilja geografiska skillnader eller är det en tidsmässig utveckling? • Kan bonader attribueras utifrån materialval och färgval? • Vad är det för pigment som döljs i trivialnamnen? Skriftliga källor räcker inte för att svara på dessa frågor utan måste komplet-teras med naturvetenskapliga analyser. Diskussion kring RÄA-seminariets specifika frågeställningar På vad sätt bidrar ert projekt till kunskapsuppbyggnaden inom ert område? • Projektet är också ett pilotprojekt och den kunskap som vinns kan också appliceras på annat än bonadsmåleri. Utifrån resultaten kan man också gå vidare och titta på handelsvägar, infrastruktur etc. • En referensdatabas byggs upp och kan kanske också användas för an-nat material. På vilket sätt skulle resultaten från ert projekt kunna tillämpas mer konkret inom kulturmiljösektorn? • Ett viktigt mål är att hitta analysmetoder som inte förstör materialet, och som helst kan göras på plats så att materialet inte behöver flyttas (Raman spektroskopi). • Som konstaterades ovan kan resultaten från den kemiska analysen visa att en sådan kan komplettera traditionella historiska metoder också inom andra områden än bonadsmåleri. Frågor och öppen diskussion • Ännu har man inte hittat några speciella pigment eller färger, men analysen är inte klar. • Analysmaterialet som valts ut är signerade bonader. • Eftersom uppbyggandet av referensdatabaser är centralt i konserva-torns arbete är det viktigt att sprida resultaten av projektet.
|
|
