Sökning: id:"swepub:oai:DiVA.org:hv-11940" >
Multilayered suspen...
Multilayered suspension plasma sprayed thermal barrier coatings for high temperature gas turbine applications
-
- Gupta, Mohit Kumar, 1986- (författare)
- Högskolan Väst,Avdelningen för avverkande och additativa tillverkningsprocesser (AAT),PTW
-
- Markocsan, Nicolaie, 1967- (författare)
- Högskolan Väst,Avdelningen för avverkande och additativa tillverkningsprocesser (AAT),PTW
-
- Rocchio-Heller, Riston (författare)
- Oerlikon Metco, Westbury, USA
-
visa fler...
-
- Liu, Jing (författare)
- Oerlikon Metco, Westbury, USA
-
- Li, Xin-Hai (författare)
- Siemens Industrial Turbomachinery, Fingspång, Sweden
-
- Östergren, Lars (författare)
- GKN Aerospace, Trollhättan, Sweden
-
visa färre...
-
(creator_code:org_t)
- New York : Curran Associates, Inc, 2017
- 2017
- Engelska.
-
Ingår i: Proceedings of the International Thermal Spray Conference & Exposition (ITSC 2017). - New York : Curran Associates, Inc. - 9781510858220 ; , s. 382-387
- Relaterad länk:
-
http://www.proceedin...
-
visa fler...
-
https://urn.kb.se/re...
-
visa färre...
Abstract
Ämnesord
Stäng
- Improvement in the performance of thermal barrier coating systems (TBCs) is one of the key objectives for further development of gas turbine applications. The material most commonly used as TBC topcoat is yttria stabilised zirconia (YSZ). However, the usage of YSZ is limited by the operating temperature range which in turn restricts the engine efficiency. Materials such as pyrochlores, perovskites, rare earth garnets, etc. are suitable candidates which could replace YSZ as they exhibit lower thermal conductivity and higher phase stability at elevated temperatures.The objective of this work was to investigate different multi-layered TBCs consisting of advanced topcoat materials fabricated by Suspension Plasma Spraying (SPS). The investigated topcoat materials were YSZ, dysprosia stabilised zirconia, gadolinium zirconiate, cerium doped YSZ and yttria fully stabilised zirconia. All topcoats were deposited with TriplexPro-210 plasma spray gun and radial injection of suspension. Lifetime of these samples was examined by thermal cyclic fatigue and thermal shock testing. Microstructure analysis of as-sprayed and failed specimens was performed with scanning electron microscope. The failure mechanisms in each case have been discussed in this article. The results show that SPS could be a promising route to produce multilayered TBCs for high temperature applications.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik -- Bearbetnings-, yt- och fogningsteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering -- Manufacturing, Surface and Joining Technology (hsv//eng)
Nyckelord
- Manufacturing and materials engineering
- Produktions- och materialteknik
- Production Technology
- Produktionsteknik
Publikations- och innehållstyp
- ref (ämneskategori)
- kon (ämneskategori)
Hitta via bibliotek
Till lärosätets databas