SwePub
Sök i LIBRIS databas

  Utökad sökning

id:"swepub:oai:DiVA.org:kth-11675"
 

Sökning: id:"swepub:oai:DiVA.org:kth-11675" > Power Amplifier Beh...

Power Amplifier Behavioral Modeling Performance Comparison of the LSNA and the Modulation-Domain System

Landin, Per N. (författare)
Högskolan i Gävle,KTH,Signalbehandling,Ämnesavdelningen för elektronik
Fager, Christian, 1974 (författare)
Chalmers tekniska högskola,Chalmers University of Technology,Chalmers
Isaksson, Magnus, 1969- (författare)
Högskolan i Gävle,Ämnesavdelningen för elektronik
visa fler...
Andersson, Kristoffer, 1976 (författare)
Chalmers tekniska högskola,Chalmers University of Technology,Chalmers
visa färre...
 (creator_code:org_t)
New York : IEEE, 2008
2008
Engelska.
Ingår i: 72ND ARFTG MICROWAVE MEASUREMENT SYMPOSIUM - TIME DOMAIN AND FREQUENCY DOMAIN MEASUREMENT. - New York : IEEE. - 9781424422999 ; , s. 73-78, s. 73-78
  • Konferensbidrag (refereegranskat)
Abstract Ämnesord
Stäng  
  • The performance of power amplifier behavioral models depends strongly on the performance of the system used to measure the amplifiers. In this study two different systems with nonlinear measurement capability are used to model a commercially available PA. One system is a large-signal network analyzer (LSNA) and the second system is a modulation-domain system (MDS) consisting of a vector signal generator and a vector signal analyzer. The PA was tested with multitone and WCDMA signals and behavioral models were extracted from the measured data. The evaluation criteria normalized mean square error and weighted error spectral power ratio or adjacent channel error power ratio were then computed to compare the performance of the models from the two systems. Cross-validation between the systems, using data from one system to obtain the model and validating its performance with data from the other system, shows that the model performance is mainly affected by the used validation data. Validating the performance of models from the LSNA with data from the MDS indicates that the identified models have almost the same performance as the MDS-identified models, i.e. it does not matter which system is used to identify the models. Cross-validation using a WCDMA-signal and multitone signal from the different systems shows that the normalized mean square error is mainly affected by modeling imperfections introduced by using another signal type. WESPR and ACEPR show a certain difference in performance with somewhat lower values for the MDS. The behavior of the two systems can be explained by different noise levels.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Elektroteknik och elektronik -- Annan elektroteknik och elektronik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Electrical Engineering, Electronic Engineering, Information Engineering -- Other Electrical Engineering, Electronic Engineering, Information Engineering (hsv//eng)
TEKNIK OCH TEKNOLOGIER  -- Elektroteknik och elektronik -- Reglerteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Electrical Engineering, Electronic Engineering, Information Engineering -- Control Engineering (hsv//eng)

Nyckelord

Block codes
Electric network analysis
Heterojunction bipolar transistors
Mean square error
Power amplifiers
Signal generators
Electronics
Elektronik

Publikations- och innehållstyp

ref (ämneskategori)
kon (ämneskategori)

Hitta via bibliotek

Till lärosätets databas

Sök utanför SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy