Experimental studies on dewatering during roll forming of paper

• Pressure and wire position measurements have been performed in an experimental facility, the KTH-Former, which intends to model the roll-forming zone of a paper machine. The measured pressure distributions in the forming zone are shown to have more complex patterns than the simple model p=T/R, which normally is referred to as the nominal pressure. It is also shown that an increase in wire tension has a similar effect as a decrease in flow-rate on the shape of the pressure distribution. This is a consequence of that the flow to a large extent is governed by the relation between the dynamic pressure and the nominal pressure. For the case of partial dewatering the suction peak that appears at the roll-wire separation point has a strong influence on the pressure distribution upstream. Finally, it is shown that the drainage has a stabilizing effect on the dewatering pressure.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering (hsv//eng)

Nyckelord

papermaking

forming

roll dewatering

experimental measurements

Engineering mechanics

Teknisk mekanik

Publikations- och innehållstyp

ref (ämneskategori)

art (ämneskategori)