SwePub
Sök i LIBRIS databas

  Utökad sökning

id:"swepub:oai:DiVA.org:kth-155001"
 

Sökning: id:"swepub:oai:DiVA.org:kth-155001" > Advanced experiment...

Advanced experimental procedure for in-duct aero-acoustics

Allam, Sabry (författare)
KTH,MWL Marcus Wallenberg Laboratoriet
Åbom, Mats (författare)
KTH,MWL Marcus Wallenberg Laboratoriet
 (creator_code:org_t)
2006
2006
Engelska.
Ingår i: 13th International Congress on Sound and Vibration 2006, ICSV 2006. - 9781627481502 ; , s. 1185-1192
  • Konferensbidrag (refereegranskat)
Abstract Ämnesord
Stäng  
  • The purpose of this paper is to present a method for characterization of in-duct aero-acoustic sources that can be described as active acoustic two-ports. The method is applied to investigate the sound produced from an orifice plate. The motivation is to obtain better data for the development of improved prediction methods for noise from flow singularities, e.g., in HVAC systems on aircrafts. Most of the earlier works fall into two categories; papers modeling the scattering of acoustic waves and papers modeling the sound generation. Concerning the scattering it is possible to obtain estimates of the low frequency behavior from linear perturbations of the steady state equations for the flow. Concerning the sound generation most of the presented work is experimental and follows a paper by Nelson&Morfey, which present a scaling law procedure for the in-duct sound power based on a dipole model of the source. One limitation with the earlier works is that the sound power only was measured on the downstream side. Also data was only obtained in 1/3-octave bands, by measuring the sound radiated from an open duct termination. Assuming plane waves and linear acoustics the flow duct singularity can be completely modeled as an active 2-port. The experimental determination of its properties is done in a two steps procedure. In the first step the passive data, i.e., the scattering matrix S, is determined using external (independent) sources. In the second step the S matrix is used and the source vector is determined by testing the system with known acoustic terminations.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)
TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Rymd- och flygteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Aerospace Engineering (hsv//eng)

Nyckelord

Experimental determination
Experimental procedure
Linear perturbations
Low frequency behavior
Prediction methods
Scattering matrices
Scattering of acoustic waves
Steady state equation
Acoustic generators
Aeroacoustics
Climate control
Scattering parameters
Ducts

Publikations- och innehållstyp

ref (ämneskategori)
kon (ämneskategori)

Hitta via bibliotek

Till lärosätets databas

Hitta mer i SwePub

Av författaren/redakt...
Allam, Sabry
Åbom, Mats
Om ämnet
TEKNIK OCH TEKNOLOGIER
TEKNIK OCH TEKNO ...
och Maskinteknik
och Strömningsmekani ...
TEKNIK OCH TEKNOLOGIER
TEKNIK OCH TEKNO ...
och Maskinteknik
och Rymd och flygtek ...
Artiklar i publikationen
13th Internation ...
Av lärosätet
Kungliga Tekniska Högskolan

Sök utanför SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy