Polymer Actuators for Micro Robotic Applications

• In this thesis a multilayer actuator structure is developed for the I-SWARM project. In order to build an energy efficient and low voltage actuator system for the 3x3x3 mm3 robot, the resonance drive mode in combination with a ten layer multilayer structure build upon the most suitable substrate material was used. Two different sizes of the locomotion module were built. The first one is five times larger than the small version. It has five active layers and is simpler to work with and to test. The small module has three 2x0.4 mm can-tilevers on a 3x3mm body and ten active layers. The multilayer process involve easily defined flexible printed circuit (FPC) board as substrate material, spin coating piezoelectric poly(vinylidenefluoride- tetrafluoroethylene) P(VDF-TrFE) as active stack material, and evaporated aluminum electrodes on each active polymer layer. By using different shadow masks for each electrode layer, special inter con-tact areas can be contacted from above after the polymer has been removed by an Inductively Coupled Plasma (ICP) etch. The contours of the locomo-tion module was etched in a Reactive Ion Etch (RIE) equipment. Both the cupper layer in the FPC and the electrode layers of the active stack, were used as etch mask. The deflections of the cantilevers were measured at low voltages to ensure as realistic drive voltage as possible for the I-SWARM robot. The large struc-ture showed a 250 µm deflection at 4 V and 170 Hz resulting in a Q-value of 19. The deflection of the small structure was 8 µm at 3.3 V and 5000 Hz and the measured Q-value was 31.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Materialteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Materials Engineering (hsv//eng)

Nyckelord

Micro actuator

PVDF-TrFE

I-SWARM

Multilayer actuator

Materials science

Teknisk materialvetenskap

Publikations- och innehållstyp

vet (ämneskategori)

lic (ämneskategori)