Sökning: id:"swepub:oai:lup.lub.lu.se:f5eabc52-3bc4-428a-8748-b4fb9c2f6b8d" >
Experimental study ...
Experimental study of pressure drop and heat transfer in a U bend channel with various guide vanes and ribs
-
Cimina, Susanna (författare)
-
- Wang, Chenglong (författare)
- Lund University,Lunds universitet,Värmeöverföring,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Heat Transfer,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Wang, Lei (författare)
- Lund University,Lunds universitet,Värmeöverföring,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Heat Transfer,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa fler...
-
Niro, Alfonso (författare)
-
- Sundén, Bengt (författare)
- Lund University,Lunds universitet,Värmeöverföring,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Heat Transfer,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- 2015
- 2015
- Engelska.
-
Ingår i: Journal of Enhanced Heat Transfer. - 1563-5074. ; 22:1, s. 29-45
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://lup.lub.lu.s...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- An experimental study was conducted to investigate pressure drop and heat transfer in a U-bend section with various configurations of guide vanes and two kinds of rib shapes on the outer wall. Ten guide vane types were tested. Results highlight that the use of special guide vanes can reduce the pressure drop penalty up to a maximum of 31%. However, guide vanes are usually associated with heat transfer reduction. To further enhance heat transfer, transverse and V-shaped ribs were attached on the outer wall. Thermal performance evaluation showed that the 45 degrees V-shaped downstream-pointing ribs coupled with guide vane configuration 5 give the best thermal performance. The results of this study can be employed to improve the internal design of modern gas turbine blade cooling systems.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Energiteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Energy Engineering (hsv//eng)
Nyckelord
- rough surfaces
- structured roughness
- single-phase flow
- bend duct
- geometry
- guide vanes
- liquid crystal thermography
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas