SwePub
Sök i LIBRIS databas

  Utökad sökning

id:"swepub:oai:research.chalmers.se:1bb789d7-8a6b-479f-b0b1-2f1b27d8f7e5"
 

Sökning: id:"swepub:oai:research.chalmers.se:1bb789d7-8a6b-479f-b0b1-2f1b27d8f7e5" > Chemical-Looping Us...

Chemical-Looping Using Combined Iron/Manganese/Silica Oxygen Carriers

Hanning, Malin, 1987 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
Rydén, Magnus, 1975 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
Lyngfelt, Anders, 1955 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
visa fler...
Mattisson, Tobias, 1970 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
visa färre...
 (creator_code:org_t)
2014
2014
Engelska.
Ingår i: 3rd International Conference on Chemical Looping, 9-11 September 2014, Göteborg.
  • Konferensbidrag (övrigt vetenskapligt/konstnärligt)
Abstract Ämnesord
Stäng  
  • Combined oxides of iron, manganese and silica have been used as oxygen carriers for chemical-looping combustion. Three materials with varying composition of iron, manganese and silica have been evaluated in oxygen release experiments and during continuous operation with syngas and natural gas as fuel. The concentration of oxygen released increased as a function of temperature and the highest concentrations of oxygen were measured with the material with the highest fraction of manganese. It was also this material which gave the best conversion of both syngas and natural gas; essentially full conversion of syngas and above 95% conversion of natural gas above 900°C. The other two materials showed similar performance, albeit with higher syngas conversion for the material with the lowest manganese fraction and the lowest conversion of natural gas for the same material. The materials lasted for 10-14 h of operation with fuel addition before circulation disruption occurred, which was likely caused by particle attrition in all three cases. A phase diagram of the iron-manganese-silica system was constructed and the possible relevant phase transitions were identified. This analysis showed that more phase transitions could be expected for the materials with higher manganese content which could explain the superior performance of the material with the highest manganese content. This could possibly also explain the much higher oxygen release of this material. It should however be noted that this material was operated with the highest fuel reactor inventory per thermal power which could also be a contributing factor to the better performance of this material.The study shows that it is possible to achieve very high fuel conversion with combined oxides of iron, manganese and silica as oxygen carrier. The mechanical stability of the particles was rather poor though and would need to be improved. On the other hand the findings relating to material stability is not necessary valid for natural materials containing a number of additional elements. The results are also of interest as an indication of how natural materials with similar composition, i.e. manganese ores, would perform as oxygen carriers.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Energiteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Energy Engineering (hsv//eng)

Publikations- och innehållstyp

kon (ämneskategori)
vet (ämneskategori)

Till lärosätets databas

Hitta mer i SwePub

Av författaren/redakt...
Hanning, Malin, ...
Rydén, Magnus, 1 ...
Lyngfelt, Anders ...
Mattisson, Tobia ...
Om ämnet
TEKNIK OCH TEKNOLOGIER
TEKNIK OCH TEKNO ...
och Maskinteknik
och Energiteknik
Artiklar i publikationen
Av lärosätet
Chalmers tekniska högskola

Sök utanför SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy