SwePub
Sök i LIBRIS databas

  Utökad sökning

id:"swepub:oai:research.chalmers.se:7f1d1d35-9604-43bd-a600-6e7580f5e281"
 

Sökning: id:"swepub:oai:research.chalmers.se:7f1d1d35-9604-43bd-a600-6e7580f5e281" > Improved Interopera...

Improved Interoperability Evaluation Method for Wireless Charging Systems Based on Interface Impedance

Yang, Guang (författare)
Harbin Institute of Technology
Song, Kai (författare)
Harbin Institute of Technology
Huang, Xiaoliang, 1985 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
visa fler...
Wang, Chao (författare)
Harbin Institute of Technology
Huang, Xiaohua (författare)
Li, Jin (författare)
Zhu, Chunbo (författare)
Harbin Institute of Technology
visa färre...
 (creator_code:org_t)
2021
2021
Engelska.
Ingår i: IEEE Transactions on Power Electronics. - 0885-8993 .- 1941-0107. ; 36:8, s. 8588-8592
  • Tidskriftsartikel (refereegranskat)
Abstract Ämnesord
Stäng  
  • The interoperability between the vehicle assembly (VA) and ground assembly (GA) of wireless charging systems has been specified in international standards. SAE J2954 first proposed an interoperability evaluation method based on interface impedance. However, the impedance measurement is challenging at high frequency since the phase difference between the voltage and current is not easy to measure accurately, especially when it is close to 90. Small errors in phase angle measurement are amplified in impedance calculation due to the sine/cosine function. This letter proposes an impedance measurement method using the power decomposition algorithm. By decomposing the input power into two orthogonal components, the impedance angle can be calculated without directly measuring the phase difference between the voltage and current. Thus, the measurement results of the impedance angle do not introduce errors. With the proposal, the high-cost probe or complex high-precision phase difference measurement circuit is not needed. The experimental results show that the conventional methods maximum relative error reaches 80%, making interoperability hard to determine. Reversely, with the proposed method, the relative error of impedance measurement is reduced to less than 10%.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Medicinteknik -- Medicinsk laboratorie- och mätteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Medical Engineering -- Medical Laboratory and Measurements Technologies (hsv//eng)
TEKNIK OCH TEKNOLOGIER  -- Elektroteknik och elektronik -- Signalbehandling (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Electrical Engineering, Electronic Engineering, Information Engineering -- Signal Processing (hsv//eng)
TEKNIK OCH TEKNOLOGIER  -- Elektroteknik och elektronik -- Annan elektroteknik och elektronik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Electrical Engineering, Electronic Engineering, Information Engineering -- Other Electrical Engineering, Electronic Engineering, Information Engineering (hsv//eng)

Nyckelord

power decomposition
Phase measurement
impedance measurement
wireless charging
Current measurement
Interoperability
Interoperability
Impedance measurement
interface impedance
Voltage measurement
Power measurement
Impedance

Publikations- och innehållstyp

art (ämneskategori)
ref (ämneskategori)

Hitta via bibliotek

Till lärosätets databas

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy