| 1. |
- Jiang, Zheshun, et al.
(författare)
-
Hexavalent chromium still a concern in Sweden : Evidence from a cross-sectional study within the SafeChrom project
- 2024
-
Ingår i: International journal of hygiene and environmental health (Print). - : Elsevier. - 1438-4639 .- 1618-131X. ; 256
-
Tidskriftsartikel (refereegranskat)abstract
- ObjectivesHexavalent chromium (Cr(VI)) is classified as a human carcinogen. Occupational Cr(VI) exposure can occur during different work processes, but the current exposure to Cr(VI) at Swedish workplaces is unknown.MethodsThis cross-sectional study (SafeChrom) recruited non-smoking men and women from 14 companies with potential Cr(VI) exposure (n = 113) and controls from 6 companies without Cr(VI) exposure (n = 72). Inhalable Cr(VI) was measured by personal air sampling (outside of respiratory protection) in exposed workers. Total Cr was measured in urine (pre- and post-shift, density-adjusted) and red blood cells (RBC) (reflecting Cr(VI)) in exposed workers and controls. The Bayesian tool Expostats was used to assess risk and evaluate occupational exposure limit (OEL) compliance.ResultsThe exposed workers performed processing of metal products, steel production, welding, plating, and various chemical processes. The geometric mean concentration of inhalable Cr(VI) in exposed workers was 0.15 μg/m3 (95% confidence interval: 0.11–0.21). Eight of the 113 exposed workers (7%) exceeded the Swedish OEL of 5 μg/m3, and the Bayesian analysis estimated the share of OEL exceedances up to 19.6% for stainless steel welders. Median post-shift urinary (0.60 μg/L, 5th-95th percentile 0.10–3.20) and RBC concentrations (0.73 μg/L, 0.51–2.33) of Cr were significantly higher in the exposed group compared with the controls (urinary 0.10 μg/L, 0.06–0.56 and RBC 0.53 μg/L, 0.42–0.72). Inhalable Cr(VI) correlated with urinary Cr (rS = 0.64) and RBC-Cr (rS = 0.53). Workers within steel production showed the highest concentrations of inhalable, urinary and RBC Cr. Workers with inferred non-acceptable local exhaustion ventilation showed significantly higher inhalable Cr(VI), urinary and RBC Cr concentrations compared with those with inferred acceptable ventilation. Furthermore, workers with inferred correct use of respiratory protection were exposed to significantly higher concentrations of Cr(VI) in air and had higher levels of Cr in urine and RBC than those assessed with incorrect or no use. Based on the Swedish job-exposure-matrix, approximately 17 900 workers were estimated to be occupationally exposed to Cr(VI) today.ConclusionsOur study demonstrates that some workers in Sweden are exposed to high levels of the non-threshold carcinogen Cr(VI). Employers and workers seem aware of Cr(VI) exposure, but more efficient exposure control strategies are required. National strategies aligned with the European strategies are needed in order to eliminate this cause of occupational cancer.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Broberg, Karin, et al.
(författare)
-
Evaluation of 92 cardiovascular proteins in dried blood spots collected under field-conditions : Off-the-shelf affinity-based multiplexed assays work well, allowing for simplified sample collection
- 2021
-
Ingår i: BioEssays. - : Wiley. - 0265-9247 .- 1521-1878. ; 43:9
-
Tidskriftsartikel (refereegranskat)abstract
- Workplace-collected blood spots deposited on filter paper were analysed with multiplexed affinity-based protein assays and found to be suitable for proteomics analysis. The protein extension assay (PEA) was used to characterize 92 proteins using 1.2 mm punches in repeated samples collected from 20 workers. Overall, 97.8% of the samples and 91.3% of the analysed proteins passed quality control. Both within and between spot correlations using six replicates from the same individual were above 0.99, suggesting that comparable levels are obtained from multiple punches from the same spot and from consecutive spots. Protein levels from dried blood and wet serum from the same individuals were compared and the majority of the analysed proteins were found to be significantly correlated. These results open up for simplified sample collection of blood in field conditions for proteomic analysis, but also highlight that not all proteins can be robustly measured from dried whole blood.
|
|
| 7. |
- Broberg, Karin, et al.
(författare)
-
Metodutveckling för blodprovstagning på filterpapper
- 2022
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- Blodprov för metallanalyser tas vanligtvis via prov av venblod från armvecket. Detta är dock eninvasiv metod och provtagningen måste utföras av medicinskt utbildad personal. Ett sätt att erhållablod med en mindre invasiv metod och som ger betydligt mindre blodvolym är att genom ett stick ifingret droppa kapillärblod på ett filterpapper som får torka. Ytterligare fördelar med dennaprovtagningsmetod är att det blir möjligt med ”självprovtagning” och att för en mindre kostnad kanblod samlas in från fler personer.Vi genomförde ett utvecklingsprojekt för att ta fram en metod för att samla in och mäta metallernakadmium, kvicksilver och bly i torkat blod (blodspottar på filterpapper) erhållet via självprovtagninggenom stick i fingret.Vi tog fram en sur tvättmetod för att tvätta bort metaller (bakgrundshalter) i filterpapper innan dekan användas för provtagning. Vi utvecklade en enkel men effektiv alkalisk urlakningsmetod avmetaller i blodspottarna. Vi tog fram ett självprovtagningskit för blodspottar samt instruktionsvideodesignat för att minimera kontaminering av metaller i omgivningsmiljön. Vi jämfördevenblodsprovtagning med självprovstagning för 17 försökspersoner och fann överensstämmelseframförallt för bly. Vi gjorde en inter-laboratoriejämförelse för mätning av metaller i blodspottar frånfem personer och fann överensstämmelse för kvicksilver och bly.Studien visar att det är möjligt att mäta toxiska metaller i små volymer från blodspottar erhållna viasjälvprovtagning. Emellertid skilde sig halterna i venblod och i blodspottar för vissa personer ochframförallt för kadmium. Det beror troligen på att blodspottarna kan kontamineras vid utstansningmed de stansverktyg som finns att köpa på marknaden. Ytterligare metodutveckling via framtagningav adekvat stansverktyg rekommenderas för att kunna mäta kadmium i blodspottar samt att däreftertesta metoden i HÄMI-projekt.
|
|
| 8. |
- Dierschke, Katrin, et al.
(författare)
-
Acute respiratory effects and biomarkers of inflammation due to welding-derived nanoparticle aggregates
- 2017
-
Ingår i: International Archives of Occupational and Environmental Health. - : Springer Science and Business Media LLC. - 0340-0131 .- 1432-1246. ; 90:5, s. 451-463
-
Tidskriftsartikel (refereegranskat)abstract
- Welders are exposed to airborne particles from the welding environment and often develop symptoms work-related from the airways. A large fraction of the particles from welding are in the nano-size range. In this study we investigate if the welders' airways are affected by exposure to particles derived from gas metal arc welding in mild steel in levels corresponding to a normal welding day. In an exposure chamber, 11 welders with and 10 welders without work-related symptoms from the lower airways and 11 non-welders without symptoms, were exposed to welding fumes (1 mg/m(3)) and to filtered air, respectively, in a double-blind manner. Symptoms from eyes and upper and lower airways and lung function were registered. Blood and nasal lavage (NL) were sampled before, immediately after and the morning after exposure for analysis of markers of oxidative stress. Exhaled breath condensate (EBC) for analysis of leukotriene B4 (LT-B4) was sampled before, during and immediately after exposure. No adverse effects of welding exposure were found regarding symptoms and lung function. However, EBC LT-B4 decreased significantly in all participants after welding exposure compared to filtered air. NL IL-6 increased immediately after exposure in the two non-symptomatic groups and blood neutrophils tended to increase in the symptomatic welder group. The morning after, neutrophils and serum IL-8 had decreased in all three groups after welding exposure. Remarkably, the symptomatic welder group had a tenfold higher level of EBC LT-B4 compared to the two groups without symptoms. Despite no clinical adverse effects at welding, changes in inflammatory markers may indicate subclinical effects even at exposure below the present Swedish threshold limit (8 h TWA respirable dust).
|
|
| 9. |
- Gliga, Anda R., et al.
(författare)
-
Exposure to Mild Steel Welding and Changes in Serum Proteins With Putative Neurological Function—A Longitudinal Study
- 2020
-
Ingår i: Frontiers in Public Health. - : Frontiers Media SA. - 2296-2565. ; 8
-
Tidskriftsartikel (refereegranskat)abstract
- Welders are exposed to high levels of metal particles, consisting mainly of iron and manganese (Mn) oxide. Metal particles, especially those containing Mn can be neurotoxic. In this exploratory study, we evaluated associations between welding and expression of 87 putative neurology-related proteins in serum in a longitudinal approach. The study cohort from southern Sweden included welders working with mild steel (n = 56) and controls (n = 67), all male and non-smoking, which were sampled at two timepoints (T1, T2) 6-year apart. Observed associations in the longitudinal analysis (linear mixed models) were further evaluated (linear regression models) in another cross-sectional sample which included welders (n = 102) and controls (n = 89) who were sampled only once (T1 or T2). The median respirable dust levels for welders after adjusting for respiratory protection was at T1 0.6 (5–95 percentile: 0.2–4.2) and at T2 0.5 (0.1–1.8) mg/m3. The adjusted median respirable Mn concentration was at T2 0.049 mg/m3 (0.003–0.314) with a Spearman correlation between adjusted respirable dust and respirable Mn of rS = 0.88. We identified five neurology-related proteins that were differentially expressed in welders vs. controls in the longitudinal sample, of which one (nicotinamide/nicotinic acid mononucleotide adenylyltransferase 1; NMNAT1) was also differentially expressed in the cross-sectional sample. NMNAT1, an axon-protective protein linked to Alzheimers disease, was upregulated in welders compared with controls but no associations were discerned with degree of exposure (welders only: years welding, respirable dust, cumulative exposure). However, we identified five additional proteins that were associated with years welding (GCSF, EFNA4, CTSS, CLM6, VWC2; welders only) both in the longitudinal and in the cross-sectional samples. We also observed several neurology-related proteins that were associated with age and BMI. Our study indicates that low-to-moderate exposure to welding fumes is associated with changes in circulating levels of neurology-related proteins.
|
|
| 10. |
- Gliga, Anda R., et al.
(författare)
-
Mild steel welding is associated with alterations in circulating levels of cancer-related proteins
- 2019
-
Ingår i: Archives of Toxicology. - : Springer Science and Business Media LLC. - 0340-5761 .- 1432-0738. ; 93:12, s. 3535-3547
-
Tidskriftsartikel (refereegranskat)abstract
- Welding fumes were recently classified as carcinogenic to humans and worldwide millions work as welders or perform welding operations. The purpose of this study was to identify new biomarkers of welding-induced carcinogenesis. We evaluated a panel of 91 putative cancer-related proteins in serum in a cohort of welders working with mild steel (n = 77) and controls (n = 94) from southern Sweden sampled on two occasions 6-year apart using a longitudinal analysis (linear mixed models). The significant results from the longitudinal analysis were tested for reproducibility in welders (n = 88) and controls (n = 69) sampled once during the same sampling period as timepoint 1 or timepoint 2 (linear regression models), i.e., in a cross-sectional setting. The models were adjusted for age, body-mass index, and use of snus. All study participants were non-smokers at recruitment. Exposure to welding fumes was assessed using questionnaires and respirable dust measurement in the breathing zone that was adjusted for personal respiratory protection equipment. The median respirable dust in welders was 0.7 (0.2–4.2) and 0.5 (0.1–1.9) mg/m3 at the first and second timepoints, respectively. We identified 14 cancer-related proteins that were differentially expressed in welders versus controls in the longitudinal analysis, out of which three were also differentially expressed in the cross-sectional analysis (cross-sectional group). Namely, syndecan 1 (SDC1), folate receptor 1 (FOLR1), and secreted protein acidic and cysteine rich (SPARC) were downregulated, in welders compared with controls. In addition, FOLR1 was negatively associated with years welding. Disease and function analysis indicated that the top proteins are related to lung cancer as well as cell invasion and migration. Our study indicates that moderate exposure to welding fumes is associated with changes in circulating levels of putative cancer-related proteins, out of which FOLR1 showed a clear dose–response relationship. It is, however, unclear to which extent these changes are adaptive or potential early biomarkers of cancer.
|
|
