| 1. |
|
|
| 2. |
- Gustafsson, Marcus, 1987-, et al.
(author)
-
Techno-economic analysis of energy renovation measures for a district heated multi-family house
- 2016
-
In: Applied Energy. - : Elsevier BV. - 0306-2619 .- 1872-9118. ; 177, s. 108-116
-
Journal article (peer-reviewed)abstract
- Renovation of existing buildings is important in the work toward increased energy efficiency and reduced environmental impact. The present paper treats energy renovation measures for a Swedish district heated multi-family house, evaluated through dynamic simulation. Insulation of roof and façade, better insulating windows and flow-reducing water taps, in combination with different HVAC systems for recovery of heat from exhaust air, were assessed in terms of life cycle cost, discounted payback period, primary energy consumption, CO2 emissions and non-renewable energy consumption. The HVAC systems were based on the existing district heating substation and included mechanical ventilation with heat recovery and different configurations of exhaust air heat pump.Compared to a renovation without energy saving measures, the combination of new windows, insulation, flow-reducing taps and an exhaust air a heat pump gave up to 24% lower life cycle cost. Adding insulation on roof and façade, the primary energy consumption was reduced by up to 58%, CO2 emissions up to 65% and non-renewable energy consumption up to 56%. Ventilation with heat recovery also reduced the environmental impact but was not economically profitable in the studied cases. With a margin perspective on electricity consumption, the environmental impact of installing heat pumps or air heat recovery in district heated houses is increased. Low-temperature heating improved the seasonal performance factor of the heat pump by up to 11% and reduced the environmental impact.
|
|
| 3. |
- Salehin, Sayedus, et al.
(author)
-
Designing of an emergency energy module for relief and refugee camp situations : Case study for a refugee camp in Chad-Sudan border
- 2011
-
In: 2011 World Congress on Sustainable Technologies. - 9780956426345 ; , s. 9-14
-
Conference paper (peer-reviewed)abstract
- Each year thousands of people get displaced and are forced to live in refugee camps or relief camps because of man-made or natural disasters. These people often lack basic needs such as clean water, lighting, cooling, etc. and many times these camps exist for more than 7-8 years. This paper aims at conceptualizing an Emergency Energy Module (EEM) which provides electrical energy to satisfy the basic needs and that can be deployed as an emergency response in a self-sufficient, self-contained, and highly mobile fashion, to support the energy demand of a refugee or a relief camp and the aid workers for long term. As a case study, a refugee camp near Chad-Sudan border has been investigated. As a preliminary study, electrical demand was determined for the camp. Further, locally available energy resources were studied and assessed based on key design criteria and the technologies were selected to meet the demand. Polycrystalline Solar PV panels, micro wind turbine and biogas polyethylene digester and diesel generator were chosen as the technology to harness selected energy resources. HOMER Software has been used for optimization and techno-economic analysis of the energy system. The selected solution has been, then, analyzed from an operational point of view.
|
|
| 4. |
- Okda, Sherif, et al.
(author)
-
Testing of the Aerodynamic Characteristics of an Inflatable Airfoil Section
- 2020
-
In: Journal of Aerospace Engineering. - 1943-5525 .- 0893-1321. ; 33:5
-
Journal article (peer-reviewed)abstract
- Inflatable structures are characterized by being light and easy to manufacture and deploy. Hence, they find many applications in aerospace and aeronautical engineering. In this paper, an inflatable segment with a The National Advisory Committee for Aeronautics (NACA) 0021 airfoil cross-section is designed, fabricated, and tested. The geometrical accuracy of the manufactured inflatable segment is measured using laser scanning. Measurements show that the average normalized error of the chord length and thickness are 2.97% and 0.554%, respectively. The aerodynamic behavior of the inflatable segment is then tested in a wind tunnel at different wind speeds and angles of attack. Lift forces are measured using a six-component balance, while the drag forces are calculated from the wake measurements. The lift and drag coefficients of the inflatable section are compared to those of a standard NACA 0021 airfoil. Finally, flow visualization is examined at different angles of attack using two methods: smoke and tufts. Both methods show that flow separation starts at 15° and full stall occurs at 25°. Results indicate that inflatables can find more applications in the design and construction of aerodynamic structures, such as wings.
|
|
| 5. |
- Chen, B., et al.
(author)
-
Pathways for sustainable energy transition
- 2019
-
In: Journal of Cleaner Production. - : Elsevier Ltd. - 0959-6526 .- 1879-1786. ; 228, s. 1564-1571
-
Journal article (peer-reviewed)abstract
- Energy transitions are ongoing processes all over the world. While sustainable solutions are envisioned for the future, many societies are still under high-carbon and high-pollution energy regime borne by fossil fuels. How to design pathways towards sustainable energy transition has attracted worldwide concerns. Understanding the possible transition pathways of the energy system requires the integration of new energy technologies, environmental sciences, economics and management. This Special Issue of Journal of Cleaner Production targets to collect the latest research results on sustainable energy systems, discover innovative avenues and inspiring models and share knowledge on energy system modelling and management. In this paper, we identify 4 themes on sustainable energy transition pathways including: (1)Sustainable energy economics and management; (2)Renewable energy generation and consumption; (3)Environmental impacts of energy systems; and (4)Electric vehicle and energy storage. Theories, technologies, innovative models, and successful experiences are discussed accordingly. It is suggested that creative, robust and audacious strategies in governance, management and education are needed to boost sustainable energy transition across various scales and sectors.
|
|
| 6. |
- von Platten, Jenny, et al.
(author)
-
Renovating on unequal premises : A normative framework for a just renovation wave in swedish multifamily housing
- 2021
-
In: Energies. - : MDPI. - 1996-1073. ; 14:19
-
Journal article (peer-reviewed)abstract
- While the energy transition of the EU housing stock is now being intensified with the launch of the Renovation Wave, economic inequalities are increasing in many OECD countries, which has effects on housing-related inequalities and the demand of affordable housing. The Renovation Wave is thus an opportunity to improve housing quality for low-income households, but also entails risks for increased rents. In Sweden, the standard of housing is relatively high and energy poverty in multifamily housing is rare, meaning that there are limited social benefits to be achieved from extensive energy retrofitting; moreover, Sweden lacks a social housing sector, which limits protection of the worst-off residents. This paper thus explores whether the limited social benefits of the Renovation Wave weigh up against the risks that it entails for the worst-off in the Swedish context. This is done within a normative framework for just energy transitioning that is developed within the context of the Renovation Wave and increasing economic inequalities, consisting of four ordered principles: (1) The equal treatment principle; (2) The priority principle; (3) The efficiency principle; and (4) The principle of procedural fairness. Analysis showed that to be considered just according to our framework, the Swedish energy transition of housing should, in contradistinction to what is suggested in the Renovation Wave, limit the imposition of extensive energy retrofitting in low-income areas. Finally, having identified a mismatch between the most effective approaches in terms of energy savings and the most acceptable approaches in terms of social justice, we offer policy recommendations on how to bridge this mismatch in a Swedish context. © 2021 by the authors.
|
|
| 7. |
- Mathern, Alexandre, 1986, et al.
(author)
-
Concrete Support Structures for Offshore Wind Turbines: Current Status, Challenges, and Future Trends
- 2021
-
In: Energies. - : MDPI AG. - 1996-1073 .- 1996-1073. ; 14:7
-
Research review (peer-reviewed)abstract
- Today’s offshore wind turbine support structures market is largely dominated by steel structures, since steel monopiles account for the vast majority of installations in the last decade and new types of multi-leg steel structures have been developed in recent years. However, as wind turbines become bigger, and potential sites for offshore wind farms are located in ever deeper waters and ever further from the shore, the conditions for the design, transport, and installation of support structures are changing. In light of these facts, this paper identifies and categorizes the challenges and future trends related to the use of concrete for support structures of future offshore wind projects. To do so, recent advances and technologies still under development for both bottom-fixed and floating concrete support structures have been reviewed. It was found that these new developments meet the challenges associated with the use of concrete support structures, as they will allow the production costs to be lowered and transport and installation to be facilitated. New technologies for concrete support structures used at medium and great water depths are also being developed and are expected to become more common in future offshore wind installations. Therefore, the new developments identified in this paper show the likelihood of an increase in the use of concrete support structures in future offshore wind farms. These developments also indicate that the complexity of future support structures will increase due to the development of hybrid structures combining steel and concrete. These evolutions call for new knowledge and technical know-how in order to allow reliable structures to be built and risk-free offshore installation to be executed.
|
|
| 8. |
- Herre, Lars, 1990-, et al.
(author)
-
Simplified model of integrated paper mill for optimal bidding in energy and reserve markets
- 2020
-
In: Applied Energy. - : Elsevier Ltd. - 0306-2619 .- 1872-9118. ; 279
-
Journal article (peer-reviewed)abstract
- Due to the increased use of variable renewable energy sources, more capacity for reserves is required. Non-generating resources such as large industrial consumers can arbitrage energy prices and provide reserve capacity by exploiting the inherent flexibility in selected industrial processes. A large enough industrial consumer can capitalize on this flexibility through optimized bidding in electricity markets. In this work, the day-ahead cost minimization of a risk-averse pulp and paper mill is formulated as a two-stage stochastic problem, considering thermodynamic and electrical constraints. The bids in the energy and reserve markets are jointly optimized subject to price uncertainty as well as uncertainty of frequency realization. The results of a case study in Sweden display a significant economic benefit in exploiting the flexibility of integrated pulp and paper mills with electric boilers. The expected cost of the pulp and paper mill resulting from different strategies are compared and the risk-aversion of the pulp and paper mill is investigated. Reserve offers are mainly facilitated by fast-acting electric boilers and supported by flexibility in the steam network. We show that reserve offers can significantly improve the profitability of the pulp and paper mill.
|
|
| 9. |
- Lv, Zhihan, Dr. 1984-, et al.
(author)
-
Towards carbon Neutrality : Prediction of wave energy based on improved GRU in Maritime transportation
- 2023
-
In: Applied Energy. - : Elsevier. - 0306-2619 .- 1872-9118. ; 331
-
Journal article (peer-reviewed)abstract
- Efficient use of renewable energy is one of the critical measures to achieve carbon neutrality. Countries have introduced policies to put carbon neutrality on the agenda to achieve relatively zero emissions of greenhouse gases and to cope with the crisis brought about by global warming. This work analyzes the wave energy with high energy density and wide distribution based on understanding of various renewable energy sources. This study provides a wave energy prediction model for energy harvesting. At the same time, the Gated Recurrent Unit network (GRU), Bayesian optimization algorithm, and attention mechanism are introduced to improve the model's performance. Bayesian optimization methods are used to optimize hyperparameters throughout the model training, and attention mechanisms are used to assign different weights to features to increase the prediction accuracy. Finally, the 1-hour and 6-hour forecasts are made using the data from China's NJI and BSG observatories, and the system performance is analyzed. The results show that, compared with mainstream prediction algorithms, GRU based on Bayesian optimization and attention mechanism has the highest prediction accuracy, with the lowest MAE of 0.3686 and 0.8204, and the highest R2 of 0.9127 and 0.6436, respectively. Therefore, the prediction model proposed here can provide support and reference for the navigation of ships powered by wave energy.
|
|
| 10. |
- Lindroth [formerly Tyrberg], Simon, 1979-
(author)
-
Buoy and Generator Interaction with Ocean Waves : Studies of a Wave Energy Conversion System
- 2011
-
Doctoral thesis (other academic/artistic)abstract
- On March 13th, 2006, the Division of Electricity at Uppsala University deployed its first wave energy converter, L1, in the ocean southwest of Lysekil. L1 consisted of a buoy at the surface, connected through a line to a linear generator on the seabed. Since the deployment, continuous investigations of how L1 works in the waves have been conducted, and several additional wave energy converters have been deployed. This thesis is based on ten publications, which focus on different aspects of the interaction between wave, buoy, and generator. In order to evaluate different measurement systems, the motion of the buoy was measured optically and using accelerometers, and compared to measurements of the motion of the movable part of the generator - the translator. These measurements were found to correlate well. Simulations of buoy and translator motion were found to match the measured values. The variation of performance of L1 with changing water levels, wave heights, and spectral shapes was also investigated. Performance is here defined as the ratio of absorbed power to incoming power. It was found that the performance decreases for large wave heights. This is in accordance with the theoretical predictions, since the area for which the stator and the translator overlap decreases for large translator motions. Shifting water levels were predicted to have the same effect, but this could not be seen as clearly. The width of the wave energy spectrum has been proposed by some as a factor that also affects the performance of a wave energy converter, for a set wave height and period. Therefore the relation between performance and several different parameters for spectral width was investigated. It was found that some of the parameters were in fact correlated to performance, but that the correlation was not very strong. As a background on ocean measurements in wave energy, a thorough literature review was conducted. It turns out that the Lysekil project is one of quite few projects that have published descriptions of on-site wave energy measurements.
|
|
