| 1. |
- Arwin, Hans, 1950-, et al.
(författare)
-
Total internal reflection ellipsometry : principles and applications
- 2004
-
Ingår i: Applied Optics. - 0003-6935 .- 1539-4522. ; 43:15, s. 3028-3036
-
Tidskriftsartikel (refereegranskat)abstract
- A concept for a measurement technique based on ellipsometry in conditions of total internal reflection is presented. When combined with surface plasmon resonance (SPR) effects, this technique becomes powerful for monitoring and analyzing adsorption and desorption on thin semitransparent metal films as well as for analyzing the semitransparent films themselves. We call this technique total internal reflection ellipsometry (TIRE). The theory of ellipsometry under total internal reflection combined with SPR is discussed for some simple cases. For more advanced cases and to prove the concept, simulations are performed with the Fresnel formalism. The use of TIRE is exemplified by applications in protein adsorption, corrosion monitoring, and adsorption from opaque liquids on metal surfaces. Simulations and experiments show greatly enhanced thin-film sensitivity compared with ordinary ellipsometry.
|
|
| 2. |
- Askebjer, P., et al.
(författare)
-
Optical properties of deep ice at the South Pole : Absorption
- 1997
-
Ingår i: Applied Optics. - : Optical Society of America. - 0003-6935 .- 1539-4522. ; 36:18, s. 4168-4180
-
Tidskriftsartikel (refereegranskat)abstract
- We discuss recent measurements of the wavelength-dependent absorption coefficients in deep South Pole ice. The method uses transit-time distributions of pulses from a variable-frequency laser sent between emitters and receivers embedded in the ice. At depths of 800-1000 m scattering is dominated by residual air bubbles, whereas absorption occurs both in ice itself and in insoluble impurities. The absorption coefficient increases approximately exponentially with wavelength in the measured interval 410-610 nm. At the shortest wavelength our value is approximately a factor 20 below previous values obtained for laboratory ice and lake ice; with increasing wavelength the discrepancy with previous measurements decreases. At ∼415 to ∼500 nm the experimental uncertainties are small enough for us to resolve an extrinsic contribution to absorption in ice: submicrometer dust particles contribute by an amount that increases with depth and corresponds well with the expected increase seen near the Last Glacial Maximum in Vostok and Dome C ice cores. The laser pulse method allows remote mapping of gross structure in dust concentration as a function of depth in glacial ice.
|
|
| 3. |
- Askebjer, P, et al.
(författare)
-
Optical properties of deep ice at the South Pole: Absorption
- 1997
-
Ingår i: APPLIED OPTICS. - : OPTICAL SOC AMER. - 0003-6935. ; 36:18, s. 4168-4180
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- We discuss recent measurements of the wavelength-dependent absorption coefficients in deep South Pole ice. The method uses transit-time distributions of pulses from a variable-frequency laser sent between emitters and receivers embedded in the ice. At dep
|
|
| 4. |
- Bennett, J. M., et al.
(författare)
-
Test of Opticlean strip coating material for removing surface contamination
- 2000
-
Ingår i: Applied Optics. - 0003-6935 .- 1539-4522. ; 39:16, s. 2737-2739
-
Tidskriftsartikel (refereegranskat)abstract
- The strip coating material, Opticlean, which has been reformulated, has been shown to remove 1-5-mu m-diameter particles as well as contamination remaining from previous drag wipe cleaning on a used silicon wafer. In addition, no residue that produced scattering was found on a fresh silicon wafer when Opticlean was applied and then stripped off. The total integrated scattering technique used for the measurements could measure scattering levels of He-Ne laser light as low as a few ppm (parts in 106), corresponding to a surface roughness of <1 Angstrom rms.
|
|
| 5. |
|
|
| 6. |
- Bergström, Per, et al.
(författare)
-
Dual-wavelength digital holography : single-shot shape evaluation using speckle displacements and regularization
- 2014
-
Ingår i: Applied Optics. - : Optical Society of America. - 1559-128X .- 2155-3165 .- 0003-6935 .- 1539-4522. ; 53:1, s. 123-131
-
Tidskriftsartikel (refereegranskat)abstract
- This paper discusses the possibility of evaluating the shape of a free-form object in comparison with its shape prescribed by a CAD model. Measurements are made based on a single-shot recording using dual-wavelength holography with a synthetic wavelength of 1.4 mm. Each hologram is numerically propagated to different focus planes and correlated. The result is a vector field of speckle displacements that is linearly dependent on the local distance between the measured surface and the focus plane. From these speckle displacements, a gradient field of the measured surface is extracted through a proportional relationship. The gradient field obtained from the measurement is then aligned to the shape of the CAD model using the iterative closest point (ICP) algorithm and regularization. Deviations between the measured shape and the CAD model are found from the phase difference field, giving a high precision shape evaluation. The phase differences and the CAD model are also used to find a representation of the measured shape. The standard deviation of the measured shape relative the CAD model varies between 7 and 19 μm, depending on the slope.
|
|
| 7. |
- Carlsson, Torgny E., et al.
(författare)
-
Method for fringe enhancement in holographic interferometry for measurement of in-plane displacements
- 1998
-
Ingår i: Applied Optics. - : Optical Society of America. - 0003-6935 .- 1539-4522. ; 37:10, s. 1845-1848
-
Tidskriftsartikel (refereegranskat)abstract
- Theoretical background along with experimental results are given for a simple method for in-plane fringe enhancement in dual-beam illumination holographic interferometry. In this method, the fringes representing in-plane displacements arise as a moirépattern between two interferograms. To distinguish the in-plane displacement, a sequence of images is recorded while the reference mirror is continuously tilted at random. The in-plane fringes arethen found as the maximum contrast of the out-of-plane fringes in the image sequence. The resulting fringe quality is close to the quality of the out-of-plane fringes.
|
|
| 8. |
- Enejder, Annika, 1969, et al.
(författare)
-
Influence of cell shape and aggregate formation on the optical properties of flowing whole blood
- 2003
-
Ingår i: Applied Optics. - : The Optical Society. - 2155-3165 .- 0003-6935 .- 1539-4522. ; 42:7, s. 1384-1394
-
Tidskriftsartikel (refereegranskat)abstract
- We studied the influence of shape and secondary, or intercellular, organization on the absorption and scattering properties of red blood cells to determine whether these properties are of any practical significance for optical evaluation of whole blood and its constituents. A series of measurements of transmittance and reflectance of light from bovine blood in a flow cuvette was conducted with a 650-900-nm integrating sphere at shear rates of 0-1600 s(-1), from which the influence of cell orientation, elongation, and aggregate formation on the absorption (mu(a)) and the reduced scattering coefficients could be quantified. Aggregation was accompanied by a decrease of 4% in mu(s)' compared with the value in randomly oriented single cells. Increasing the degree of cell alignment and elongation as a result of increasing shear rate reduced mu(s)' by 6% and mu(a) by 3%, evaluated at a shear rate of 1600 s(-1). Comparison with T-matrix computations for oblate- and prolate-shaped cells with corresponding elongation and orientation indicates that the optical properties of whole blood are determined by those of its individual cells, though influenced by a collective scattering factor that depends on the cell-to-cell organization. We demonstrate that cell morphological changes must be taken into consideration when one is conducting whole blood spectroscopy. (C) 2003 Optical Society of America.
|
|
| 9. |
|
|
| 10. |
|
|
