| 1. |
- Abeywickrama, K. G. Nilanga B., et al.
(författare)
-
Determination of complex permeability of silicon steel for use in high-frequency modeling of power transformers
- 2008
-
Ingår i: IEEE transactions on magnetics. - : IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC. - 0018-9464 .- 1941-0069. ; 44:4, s. 438-444
-
Tidskriftsartikel (refereegranskat)abstract
- Information about frequency dependence of complex permeability of silicon steel is a vital input parameter in calculations of transformer winding inductance used for modeling. high-frequency behavior (100 Hz-1 MHz). We present two ways of determining small signal complex permeability spectra in frequency domain and compare and discuss the results. The first method is based on an optimization procedure, in which inductance of a winding is measured and calculated by analytical formulas and finite-element modeling. The second method makes use of a single sheet tester. We show that the magnitude of effective permeability of the silicon steel laminations remains significant up to about 100 kHz. We also report on the effect of magnetic viscosity on complex permeability.
|
|
| 2. |
- Abeywickrama, Nilanga, 1976, et al.
(författare)
-
Computation of Parameters of Power Transformer Windings for Use in Frequency Response Analysis
- 2007
-
Ingår i: IEEE Transactions on Magnetics. - 0018-9464. ; 43:5, s. 1983-1990
-
Tidskriftsartikel (refereegranskat)abstract
- We present a 3-D model for calculating magnetic fields in a power transformer and the effective parameters (inductance and resistance)of its windings. The transformer is representative of large transformers with power ratings ranging from hundreds of kilovolt amperes to hundreds of megavolt amperes. The model accounts for anisotropic frequency-dependent properties of the laminated transformercore and eddy currents in the steel sheets. We discuss the results of the calculations performed in the frequency range 10 Hz–10 MHz, and show that the largest variations of both the magnetic field and parameters of the windings take place at frequencies below 10 kHz and, at frequencies higher than 1 MHz, the magnetic core does not significantly affect the variation of the effective parameters.
|
|
| 3. |
|
|
| 4. |
- Abrahamsson, Johan, 1977-, et al.
(författare)
-
A Fully Levitated Cone-Shaped Lorentz-Type Self-Bearing Machine With Skewed Windings
- 2014
-
Ingår i: IEEE transactions on magnetics. - 0018-9464 .- 1941-0069. ; 50:9
-
Tidskriftsartikel (refereegranskat)abstract
- Brushless dc coreless electric machines with double-rotor and single-stator configuration have very low losses, since the return path of the magnetic flux rotates with the permanent magnets. The eddy-current loss in the stator is additionally very small due to the lack of iron, making it ideal for kinetic energy storage. This paper presents a design for self-bearing rotor suspension, achieved by placing the stator windings skewed on a conical surface. A mathematical analysis of the force from a skewed winding confined to the surface of a cone was found. The parametric analytical expressions of the magnitude and direction of force and torque were verified by finite-element method simulations for one specific geometry. A dynamic model using proportional-integral-differential control was implemented in MATLAB/Simulink, and the currents needed for the self-bearing effect were found by solving an underdetermined system of linear equations. External forces, calculated from acceleration measurements from a bus in urban traffic, were added to simulate the dynamic environment of an electrical vehicle.
|
|
| 5. |
- Albertsson, Dagur Ingi, 1993-, et al.
(författare)
-
Compact Macrospin-Based Model of Three-Terminal Spin-Hall Nano Oscillators
- 2019
-
Ingår i: IEEE transactions on magnetics. - : IEEE Press. - 0018-9464 .- 1941-0069. ; 55:10
-
Tidskriftsartikel (refereegranskat)abstract
- Emerging spin-torque nano oscillators (STNOs) and spin-Hall nano oscillators (SHNOs) are potential candidates for microwave applications. Recent advances in three-terminal magnetic tunnel junction (MTJ)-based SHNOs opened the possibility to develop more reliable and well-controlled oscillators, thanks to individual spin Hall-driven precession excitation and read-out paths. To develop hybrid systems by integrating three-terminal SHNOs and CMOS circuits, an electrical model able to capture the analog characteristics of three-terminal SHNOs is needed. This model needs to be compatible with current electric design automation (EDA) tools. This work presents a comprehensive macrospin-based model of three-terminal SHNOs able to describe the dc operating point, frequency modulation, phase noise, and output power. Moreover, the effect of voltage-controlled magnetic anisotropy (VCMA) is included. The model shows good agreement with experimental measurements and could be used in developing hybrid three-terminal SHNO/CMOS systems.
|
|
| 6. |
- Albertsson, D. I., et al.
(författare)
-
Compact Macrospin-Based Model of Three-Terminal Spin-Hall Nano Oscillators
- 2019
-
Ingår i: Ieee Transactions on Magnetics. - : Institute of Electrical and Electronics Engineers (IEEE). - 0018-9464 .- 1941-0069. ; 55:10
-
Tidskriftsartikel (refereegranskat)abstract
- Emerging spin-torque nano oscillators (STNOs) and spin-Hall nano oscillators (SHNOs) are potential candidates for microwave applications. Recent advances in three-terminal magnetic tunnel junction (MTJ)-based SHNOs opened the possibility to develop more reliable and well-controlled oscillators, thanks to individual spin Hall-driven precession excitation and read-out paths. To develop hybrid systems by integrating three-terminal SHNOs and CMOS circuits, an electrical model able to capture the analog characteristics of three-terminal SHNOs is needed. This model needs to be compatible with current electric design automation (EDA) tools. This work presents a comprehensive macrospin-based model of three-terminal SHNOs able to describe the dc operating point, frequency modulation, phase noise, and output power. Moreover, the effect of voltage-controlled magnetic anisotropy (VCMA) is included. The model shows good agreement with experimental measurements and could be used in developing hybrid three-terminal SHNO/CMOS systems.
|
|
| 7. |
- Andersson, Sebastian, et al.
(författare)
-
Thermoelectrically Controlled Spin-Switch
- 2010
-
Ingår i: IEEE transactions on magnetics. - 0018-9464 .- 1941-0069. ; 46:6, s. 2140-2143
-
Tidskriftsartikel (refereegranskat)abstract
- The search for novel spintronic devices brings about new ways to control switching in magnetic thin-films. In this work we experimentally demonstrate a device based on thermoelectrically controlled exchange coupling. The read out signal from a giant magnetoresistance element is controlled by exchange coupling through a weakly ferromagnetic Ni-Cu alloy. This exchange coupling is shown to vary strongly with changes in temperature, and both internal Joule heating and external heating is used to demonstrate magnetic switching. The device shows no degradation upon thermal cycling. Ways to further optimize the device performance are discussed. Our experimental results show a new way to thermoelectrically control magnetic switching in multilayers.
|
|
| 8. |
- Anisimov, AN, et al.
(författare)
-
Magnetic anisotropies of Fe-n/V-m(001) superlattices determined by Ferromagnetic Resonance
- 1998
-
Ingår i: IEEE TRANSACTIONS ON MAGNETICS. - : IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC. - 0018-9464. ; 34:4, s. 873-875
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- The temperature-dependent magnetic anisotropies of Fe-n/V-m(001) superlattices on MgO(001) were determined by Ferromagnetic Resonance (FMR). The re-layer thickness n ranges between 2 and 4 atomic layers. The shape anisotropy dominates, and the easy-axis o
|
|
| 9. |
- Benbouzid, M. E. H., et al.
(författare)
-
Dynamic modelling of giant magnetostriction in Terfenol-D rods by the finite element method
- 1995
-
Ingår i: IEEE transactions on magnetics. - : Institute of Electrical and Electronics Engineers (IEEE). - 0018-9464 .- 1941-0069. ; 31, s. 1821-1824
-
Tidskriftsartikel (refereegranskat)abstract
- As a contribution to the development of methods for the design and the analysis of devices based on giant magnetostrictive materials, a model for the simulation of the dynamic behaviour of the nonlinear magnetoelastic medium is presented. The coupled magnetic, magnetoelastic and mechanical equations that describe the magnetostrictive problem are solved by means of the finite element method. The thin sheets bending principle (surface splines) is used to introduce in the simulation the nonlinear properties of giant magnetostrictive materials, obtained by static characterizations
|
|
| 10. |
- Bergqvist, A., et al.
(författare)
-
A stress-dependent magnetic Preisach hysteresis model
- 1991
-
Ingår i: IEEE transactions on magnetics. - : Institute of Electrical and Electronics Engineers (IEEE). - 0018-9464 .- 1941-0069. ; 27, s. 4796-4798
-
Tidskriftsartikel (refereegranskat)abstract
- The authors present a generalization of the classical Preisach model which handles coupled magnetic and mechanical hysteresis. Magnetostrictive materials are known to have hysteresis with respect to both magnetic field H and mechanical stress lambda;. To test the validity of the model, experiments where the two components H and lambda; have been verified in many different ways have been performed on Terfenol-D and compared to results computed from the model. Some of these results are presented. This stress-dependent model is found to have an accuracy comparable to that of the classical Preisach model
|
|
