| 1. |
- Berglund, Christer, et al.
(författare)
-
A note on inter-country differences in waste paper recovery and utilization
- 2002
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 34:3, s. 175-191
-
Tidskriftsartikel (refereegranskat)abstract
- Countries worldwide express waste paper recycling targets in terms of recovery and utilization rates. The main purpose of this paper is to identify and analyze the most important determinants of inter-country differences in these waste paper rates. By employing two regression models and using data for 89 and 81 countries, respectively, the paper concludes that relative waste paper recovery and use are largely market-determined, and depend thus on long-standing economic factors such as population intensity and competitiveness in the world market for paper and board products. We also find evidence that supports the conjecture that rich countries tend to recover relatively more waste paper than is the case in low-income countries, reflecting the higher demand for waste management and environmental policies in more developed economies. As recovery and utilization rates are determined largely by long-standing economic and demographic characteristics the degree of policy flexibility in affecting these rates may be limited. In particular, an ambitious utilization rate target may be very costly to enforce as it can conflict with existing trade patterns of paper and board products as well as with other environmental goals. Additional policy targets may, therefore, be desirable, especially since paper recycling is motivated primarily by environmental concerns and seldom is a benign activity in itself.
|
|
| 2. |
- Dalemo, Magnus, et al.
(författare)
-
Effects of including nitrogen emissions from soil in environmental systems analysis of waste management strategies
- 1998
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 24, s. 363-381
-
Tidskriftsartikel (refereegranskat)abstract
- The environmental impacts of nitrogen emissions from soil resulting from the use of organic fertilizers, such as manure, are large compared with the corresponding impacts of mineral fertilizers. However, soil emissions are rarely included in systems analysis of waste management strategies. This study examines whether the inclusion of soil emissions can affect the environmental ranking of systems for managing solid biodegradable waste. Waste management scenarios based on incineration, anaerobic digestion and composting, respectively, were compared. The scenarios were analysed using the organic waste research (ORWARE) simulation model. A simplified model for calculating nitrogen availability and emissions was also constructed. Life-cycle analysis methodology was used for choosing system boundaries and evaluating the results. Global warming, acidification and eutrophication were the impact categories considered. The results indicate the vital importance of considering nitrogen emissions from soil when comparing biological waste management systems with other waste management methods, especially with regard to eutrophication effects. Soil emissions are also important when comparing the environmental impacts of anaerobic digestion and composting systems. However, the variation in nitrogen emissions from soil is large and depends on the spreading technique used, climate, drainage and soil texture
|
|
| 3. |
- Dalemo, M., et al.
(författare)
-
ORWARE – A simulation model for organic waste handling systems. : Part 1: Model description
- 1997
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 21:1, s. 17-37
-
Tidskriftsartikel (refereegranskat)abstract
- A simulation model, ORWARE (ORganic WAste REsearch), for the handling of organic waste in urban areas has been constructed. The model provides a comprehensive view of the environmental effects, plant nutrient utilisation and energy turnover for this large and complex system. The ORWARE model consists of several sub-models; sewage plant, incineration, landfill, compost, anaerobic digestion, truck transport, transport by sewers, residue transport and spreading of residues on arable land. The model is intended for simulating different scenarios, and the results are: emissions to air and water, energy turnover and the amount of residues returned to arable land. All results are presented, both as the gross figure for the entire system and figures for each process. Throughout the model all physical flows are described by the same variable vector, consisting of 43 substances. This extensive vector facilitates a thorough analysis of the results, but involves some difficulties in acquiring relevant data. In this paper, the model is described. Results from a hypothetical case study are presented in a companion paper.
|
|
| 4. |
- Eriksson, Ola, et al.
(författare)
-
ORWARE : a simulation tool for waste management
- 2002
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 36:4, s. 287-307
-
Tidskriftsartikel (refereegranskat)abstract
- A simulation model, ORWARE (ORganic WAste REsearch) is described. The model is mainly used as a tool for researchers in environmental systems analysis of waste management. It is a computer-based model for calculation of substance flows, environmental impacts, and costs of waste management. The model covers, despite the name, both organic and inorganic fractions in municipal waste. The model consists of a number of separate submodels, which describes a process in a real waste management system. The submodels may be combined to design a complete waste management system. Based on principles from life cycle assessment the model also comprises compensatory processes for conventional production of e.g. electricity, district heating and fertiliser. The compensatory system is included in order to fulfil the functional units, i.e. benefits from the waste management that are kept constant in the evaluation of different scenarios. ORWARE generates data on emissions, which are aggregated into different environmental impact categories, e.g. the greenhouse effect, acidification and eutrophication. Throughout the model all physical flows are described by the same variable vector, consisting of up to 50 substances. The extensive vector facilitates a thorough analysis of the results, but involves some difficulties in acquiring relevant data. Scientists have used ORWARE for 8 years in different case studies for model testing and practical application in the society. The aims have e.g. been to evaluate waste management plans and to optimise energy recovery from waste.
|
|
| 5. |
- Klang, Anders, et al.
(författare)
-
Sustainable management of demolition waste : an integrated model for the evaluation of environmental, economic and social aspect
- 2003
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 38:4, s. 317-334
-
Tidskriftsartikel (refereegranskat)abstract
- A model is presented for evaluating waste management systems for their contribution to a sustainable development, including environmental, economic and social aspects. The model was tested in a case-study, where groups of long term unemployed people were offered both education on environmental issues and practical work with the recovery and recycling of building and demolition waste as a form of vocational development. Application of the suggested model revealed the overall effects on sustainability of different methods of waste management. In addition, negative aspects of the systems analysed were identified, which led to discussions about possible improved practices within the waste management systems. Two of the waste management systems investigated (the recycling of steel and re-use of sanitary porcelain) showed a potential contribution to sustainable development in all of the aspects studied. Preparing bricks for re-use showed the largest potential for eco-efficiency, but had negative effects on sustainability from the social perspective of health and the working environment. The possibility of further use of the model and the remaining obstacles to such analyses are discussed. One observation is that the data collection needed to perform this kind of sustainability analysis is resource-demanding, and that it would therefore be better to identify a smaller number of key indicators.
|
|
| 6. |
- Lundmark, Robert
(författare)
-
Choice of location for investments in the European paper industry: the impact of wastepaper
- 2001
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 33:3, s. 167-180
-
Tidskriftsartikel (refereegranskat)abstract
- This paper identifies and estimates the relative impact that factor input prices, output market size and agglomeration effects have on the choice of location for investment projects in the European pulp and paper industry, with special focus on the price of waste paper A conditional logit model was developed to fit investment projects across 16 European countries for the period 1985-95. The results suggest that factor input prices, in general, and the price for waste paper in particular, are neither a statistical nor an economic significant location determinant for a paper manufacturer. Furthermore, the results suggest that market size and agglomeration effects are considered more important than the price of raw material when an investment site is chosen.
|
|
| 7. |
- Menad, Nourreddine
(författare)
-
Cathode ray tube recycling
- 1999
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 26:3-4, s. 143-154
-
Tidskriftsartikel (refereegranskat)abstract
- Lead and polybrominated flame retardants are the two hazardous materials that can be found in electronic appliances. Particularly, cathode ray tubes (CRT) contain leaded glasses. In a computer monitor, over 98% of the lead is in the CRT. This material is generally not accepted for reuse as a component; only those from televisions can be reused. However, this currently represents only a very small market. Envirocycle (a US company) has developed a process to recycle all glasses contained in CRTs; this process includes cleaning and sorting glass. The product obtained is used for the manufacture of new CRT glass. Some industries have used pulverized glass from CRTs in smelting processes as slagging material instead of sand or slag. In this paper, some environmental issues related to the recycling of computers and television sets, and CRTs from computers are presented and discussed. Different processes used to recycle CRTs are described along with an economic analysis.
|
|
| 8. |
- Menad, Nourreddine, et al.
(författare)
-
Combustion of plastics contained in electric and electronic scrap
- 1998
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 24:1, s. 65-85
-
Tidskriftsartikel (refereegranskat)abstract
- Plastic materials have been associated with electric and electronic applications since the early days of the electrical industry. Plastics can amount up to 30% of the scrap mass. Generally, they contains flame retardants such as halogenated compounds which can lead to the formation of different toxic products. Recycling, incineration and landfilling are the current methods used to treat these plastics. They also can be used as combustibles in some metallurgical processes. However, during their combustion, halogenated flame retardants can produce dibenzop-dioxins and dibenzo-furans.
|
|
| 9. |
- Menad, Nourreddine, et al.
(författare)
-
Polyvinyl chloride used as a chlorinating and a reducing agent
- 1998
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 24:3-4, s. 257-274
-
Tidskriftsartikel (refereegranskat)abstract
- Polyvinyl chloride (PVC) or vinyl is a recyclable material. It can be used as a chlorinating and a reducing agent. Two tests of chlorination and reduction of two different samples of jarosite and hematite were realized using PVC, results are presented in this paper. The chlorination test shows that the HCl gas produced from PVC and heated at ≈250°C can be used as a chlorine source to recover as chlorinated compounds the valuable metals such as Zn, Pb contained in jarosite. The XRD reveals the presence of lead and zinc chlorides in the condensates obtained. The second test of reduction was conducted using a mixture of PVC and hematite treated in a nitrogen atmosphere between 200 and 1000°C. The results show that at low temperature, PVC produces HCl and with kinetic consideration, no reactions can be observed with hematite. However, at high temperature, the weight of the hematite sample decreases by ≈15%, due to the reduction of hematite to iron metal.
|
|
| 10. |
- Menad, Nourreddine, et al.
(författare)
-
Thermal treatments of industrial wastes in controlled atmospheres for the elimination of As, Hg, Cd, Se and the concentration of Pb, Cu and Zn
- 1999
-
Ingår i: Resources, Conservation and Recycling. - 0921-3449 .- 1879-0658. ; 25:3-4, s. 233-254
-
Tidskriftsartikel (refereegranskat)abstract
- Thermal treatments of five different types of non-ferrous metallurgical wastes, under a controlled atmosphere, were carried out at temperatures lower than 800°C for the separation of their toxic compounds and the concentration of valuable metals in the treatments residues. The best results were obtained by the treatments in air or hydrogen, or both successively. Simple treatments, using air or hydrogen, of three samples allowed the elimination of more than 95% of their toxic elements and almost doubled their valuable metals concentration. For the rest of the samples, a combined treatment was necessary for their efficient decontamination. In this case, the valuable metals content in the treatment's residue was increased to a reasonable value. Most of the solids issuing from these treatments can be recycled in current non-ferrous metallurgical processes.
|
|
