| 1. |
- Aboulfadl, Hisham, et al.
(författare)
-
Microstructural Characterization of Sulfurization Effects in Cu(In,Ga)Se2 Thin Film Solar Cells
- 2019
-
Ingår i: Microscopy and Microanalysis. - : CAMBRIDGE UNIV PRESS. - 1435-8115 .- 1431-9276. ; 25:2, s. 532-538
-
Tidskriftsartikel (refereegranskat)abstract
- Surface sulfurization of Cu(In,Ga)Se 2 (CIGSe) absorbers is a commonly applied technique to improve the conversion efficiency of the corresponding solar cells, via increasing the bandgap towards the heterojunction. However, the resulting device performance is understood to be highly dependent on the thermodynamic stability of the chalcogenide structure at the upper region of the absorber. The present investigation provides a high-resolution chemical analysis, using energy dispersive X-ray spectrometry and laser-pulsed atom probe tomography, to determine the sulfur incorporation and chemical re-distribution in the absorber material. The post-sulfurization treatment was performed by exposing the CIGSe surface to elemental sulfur vapor for 20 min at 500°C. Two distinct sulfur-rich phases were found at the surface of the absorber exhibiting a layered structure showing In-rich and Ga-rich zones, respectively. Furthermore, sulfur atoms were found to segregate at the absorber grain boundaries showing concentrations up to ∼7 at% with traces of diffusion outwards into the grain interior.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Balmes, Olivier, et al.
(författare)
-
Imaging atomic structure in metal nanoparticles using high-resolution cryo-TEM
- 2006
-
Ingår i: Microscopy and Microanalysis. - 1435-8115. ; 12:2, s. 145-150
-
Tidskriftsartikel (refereegranskat)abstract
- It has been shown, by imaging gold (200) planes, that it is possible to achieve better than 0.20-nm structural resolution in cryo-transmission electron microscopy (cryo-TEM). This has been done using commercially available cryo equipment and using a 300-kV field emission gun (FEG) TEM. The images of 15-nm gold particles embedded in amorphous frozen water clearly show the (111) planes (separated by 0.235 nm) in gold. Fourier transform demonstrates the presence of (200) planes in the image, proving a resolution of better than 0.20 nm. The experimental results are Supported by image simulations using the multislice method. These simulations suggest that it should be possible to achieve the same resolution even in smaller particles and particles of lighter elements. The crucial experimental problem to overcome is keeping the thickness of the amorphous film low and to work at low electron dose conditions.
|
|
| 7. |
- Bhuiyan, Iftekhar Uddin, et al.
(författare)
-
Microstructure of Bentonite in Iron Ore Green Pellets
- 2014
-
Ingår i: Microscopy and Microanalysis. - 1431-9276 .- 1435-8115. ; 20:1, s. 33-41
-
Tidskriftsartikel (refereegranskat)abstract
- Sodium-activated calcium bentonite is used as a binder in iron ore pellets and is known to increase strength of both wet and dry iron ore green pellets. In this article, the microstructure of bentonite in magnetite pellets is revealed for the first time using scanning electron microscopy. The microstructure of bentonite in wet and dry iron ore pellets, as well as in distilled water, was imaged by various imaging techniques (e.g., imaging at low voltage with monochromatic and decelerated beam or low loss backscattered electrons) and cryogenic methods (i.e., high pressure freezing and plunge freezing in liquid ethane). In wet iron ore green pellets, clay tactoids (stacks of parallel primary clay platelets) were very well dispersed and formed a voluminous network occupying the space available between mineral particles. When the pellet was dried, bentonite was drawn to the contact points between the particles and formed solid bridges, which impart strength to the solid compact.
|
|
| 8. |
- Boll, Torben, 1979, et al.
(författare)
-
Interfaces in Oxides Formed on NiAlCr Doped with Y, Hf, Ti, and B
- 2017
-
Ingår i: Microscopy and Microanalysis. - 1435-8115 .- 1431-9276. ; 23:2, s. 396-403
-
Tidskriftsartikel (refereegranskat)abstract
- This study applies atom probe tomography (APT) to analyze the oxide scales formed on model NiAlCr alloys doped with Hf, Y, Ti, and B. Due to its ability to measure small amounts of alloying elements in the oxide matrix and its ability to quantify segregation, the technique offers a possibility for detailed studies of the dopant's fate during high-temperature oxidation. Three model NiAlCr alloys with different additions of Hf, Y, Ti, and B were prepared and oxidized in O2 at 1,100°C for 100 h. All specimens showed an outer region consisting of different spinel oxides with relatively small grains and the protective Al2O3-oxide layer below. APT analyses focused mainly on this protective oxide layer. In all the investigated samples segregation of both Hf and Y to the oxide grain boundaries was observed and quantified. Neither B nor Ti were observed in the alumina grains or at the analyzed interfaces. The processes of formation of oxide scales and segregation of the alloying elements are discussed. The experimental challenges of the oxide analyses by APT are also addressed.
|
|
| 9. |
- Buxhuku, Mika, et al.
(författare)
-
The Determination of Rotation Axis in the Rotation Electron Diffraction Technique
- 2013
-
Ingår i: Microscopy and Microanalysis. - 1431-9276 .- 1435-8115. ; 19:5, s. 1276-1280
-
Tidskriftsartikel (refereegranskat)abstract
- Methods to determine the rotation axis using the rotation electron diffraction technique are described. A combination of rotation axis tilt, beam tilt, and simulated experimental diffraction patterns with nonintegers zone axis has been used. Accurate knowledge of the crystallographic direction of the incident beam for deducing the excitation error of reflections simultaneously near Bragg positions is essential in quantitative electron diffraction. Experimental patterns from CoP3 are used as examples.
|
|
| 10. |
|
|
