1. |
- Abramson, Nils H.
(författare)
-
Elliptic visualizing optical resolution and kinetic energy
- 2017
-
Ingår i: Applied Optics. - : Optical Society of America. - 1559-128X .- 2155-3165. ; 56:5, s. 1413-1416
-
Tidskriftsartikel (refereegranskat)abstract
- Diffraction limited resolution as introduced by Abbe is well established, but interference limited resolution was not well known until holographic interferometry was introduced. The holodiagram is used to simplify holography and in a new way visualize the distribution, ratio, and relation among resolutions of different optical techniques, including relativistic phenomena. Resolution, when measured by optical methods based on the number of wavelengths of light, is defined in the following as the minimum distance between resolvable points, or the largest object needed to be resolved. Everywhere in the diagram this resolution is represented by two orthogonal diagonals of rhombs.
|
|
2. |
- Abramson, Nils H.
(författare)
-
Holodiagram : elliptic visualizing interferometry, relativity, and light-in-flight
- 2014
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 53:11, s. 2398-2404
-
Tidskriftsartikel (refereegranskat)abstract
- In holographic interferometry, there is usually a static distance separating the point of illumination and the point of observation. In Special Relativity, this separation is dynamic and is caused by the velocity of the observer. The corrections needed to compensate for these separations are similar in the two fields. We use the ellipsoids of the holodiagram for measurement and in a graphic way to explain and evaluate optical resolution, gated viewing, radar, holography, three-dimensional interferometry, Special Relativity, and light-in-flight recordings. Lorentz contraction together with time dilation is explained as the result of the eccentricity of the measuring ellipsoid, caused by its velocity. The extremely thin ellipsoid of the very first light appears as a beam aimed directly at the observer, which might explain the wave or ray duality of light and entanglement. Finally, we introduce the concept of ellipsoids of observation.
|
|
3. |
- Abramson, Nils H.
(författare)
-
Optical resolution and the duality of light
- 2008
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 47:19, s. D1-D5
-
Tidskriftsartikel (refereegranskat)abstract
- For 15 years, lensless microscopes have been constructed based on the use of holography, a digital CCD detector, and a computer for image reconstruction by use of, e.g., Fourier transformation. Thus, no lens is involved and therefore the conventional resolution limit of half the wavelength no longer applies. Instead of being limited by the wavelength, the resolution is in this case limited by how exact one can measure the phases of the light. It is remarkable that the interference-limited resolution is approximately 0.01X, whereas the diffraction-limited resolution is only of the order of 0.5X. It is my hope that by combining these two techniques it will be possible to increase the magnification in optical systems by at least an order of magnitude. The calculations at so indicate that information does not necessarily decrease with distance.
|
|
4. |
- Amer, Eynas, et al.
(författare)
-
Single-shot polarization digital holography for recording stimulated Raman scattering signal for time-resolved measurement of gaseous species
- 2017
-
Ingår i: Applied Optics. - : Optical Society of America. - 1559-128X .- 2155-3165. ; 56:36, s. 10016-10023
-
Tidskriftsartikel (refereegranskat)abstract
- The stimulated Raman scattering (SRS) process is sensitive to the relation between the polarization direction of the two laser beams (the pump and the Stokes) that generate it. In this paper, we made use of the polarization sensitivity of the SRS process and used polarization-resolved pulsed digital holography to record the signal from one single-shot hologram. The pump beam polarization was kept vertical, while the Stokes beam polarization was 45 deg. The two polarization components of the Stokes beam were recorded in a single hologram by blending the Stokes beam with two reference beams with orthogonal polarization on the detector. The two components of the Stokes beam were separated in the Fourier domain, and the corresponding intensity maps were calculated. The vertically polarized component of the Stokes beam was amplified due to the SRS process, while the horizontal component experienced no gain. The difference between the vertically and horizontally polarized intensity maps, respectively, was calculated and Fourier transformed to separate the gain signal in the spatial frequency domain. The method was demonstrated on methane (CH4) gas at a pressure of 12 bars. Results show that SRS polarization holography is a promising technique for recording the SRS signal from one single-shot hologram for time-resolved monitoring of specific species.
|
|
5. |
- Amer, Eynas, et al.
(författare)
-
Stimulated Raman scattering holography for time-resolved imaging of methane gas
- 2016
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 55:13, s. 3429-3434
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, pulsed digital holographic detection is coupled to the stimulated Raman scattering (SRS) process for imaging gases. A Q-switched Nd-YAG laser (532 nm) has been used to pump methane gas (CH4) at pressures up to 12 bars. The frequency-tripled (355 nm) beam from the same laser was used to pump an optical parametric oscillator (OPO). The Stokes beam (from the OPO) has been tuned to 629.93 nm so that the frequency difference between the pump (532 nm) and the Stokes beams fits a Raman active vibrational mode of the methane molecule (2922 cm(-1)). The pump beam has been spatially modulated with fringes produced in a Michelson interferometer. The pump and the Stokes beams were overlapped in time, space, and polarization on the gas molecules, resulting in a stimulated Raman gain of the Stokes beam and a corresponding loss of the pump beam through the SRS process. The resulting gain of the Stokes beam has been detected using pulsed digital holography by blending it with a reference beam on the detector. Two holograms of the Stokes beam, without and with the pump beam fringes present, were recorded. Intensity maps calculated from the recorded digital holograms showed amplification of the Stokes beam at the position of overlap with the pump beam fringes and the gas molecules. The gain of the Stokes beam has been separated from the background in the Fourier domain. A gain of about 4.5% at a pump beam average intensity of 4 MW/cm(2) and a Stokes beam intensity of 0.16 MW/cm(2) have been recorded at a gas pressure of 12 bars. The gain decreased linearly with decreasing gas pressure. The results show that SRS holography is a promising technique to pinpoint a specific species and record its spatial and temporal distribution
|
|
6. |
- Amer, Eynas, et al.
(författare)
-
Stimulated Raman scattering signals recorded by the use of an optical imaging technique
- 2015
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 54:20, s. 6377-6385
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, stimulated Raman scattering (SRS) signals have been recorded by an optical imaging technique that is based on spatial modulation. A frequency doubled Q-switched Nd:YAG laser (532 nm) was used to pump a polymethyl methacrylate (PMMA) target. The frequency tripled (355 nm) beam from the same laser was used to pump an optical parametric oscillator (OPO). The Stokes beam (from the OPO) was tuned to 631.27 nm so that the frequency difference between the pump and the Stokes beams fit the Raman active vibrational mode of the PMMA molecule (2956 cm(-1)). The pump beam has been spatially modulated with fringes produced in a Michelson interferometer. The pump and the Stokes beams were overlapped on the target resulting in a gain of the Stokes beam of roughly 2.5% and a corresponding loss of the pump beam through the SRS process. To demodulate the SRS signal, two images of the Stokes beam without and with the pump beam fringes present were recorded. The difference between these two images was calculated and Fourier transformed. Then, the gain of the Stokes beam was separated from the background in the Fourier domain. The results show that spatial modulation of the pump beam is a promising method to separate the weak SRS signal from the background.
|
|
7. |
- Andersson, Angelica, et al.
(författare)
-
Digital speckle-pattern interferometry: fringe retrieval for large in-plane deformations with digital speckle photography
- 1999
-
Ingår i: Applied Optics. - : Optical Society of America. - 1559-128X .- 2155-3165. ; 38:25, s. 5408-5412
-
Tidskriftsartikel (refereegranskat)abstract
- The compensation of large in-plane motions in digital speckle-pattern interferometry (DSPI) with the use of digital speckle photography (DSP) is demonstrated. Ordinary recordings of DSPI are recombined and analyzed with DSP. The DSP result is used to compensate for the bulk speckle motion prior to calculation of the phase map. This results in a high fringe contrast even for deformations of several speckle diameters. In addition, for the case of an in-plane deformation, it is shown that the absolute phase change in each pixel may be unwrapped by use of the DSP result as an initial guess. The principles of this method and experiments showing the in-plane rotation of a plate and the encounter of two rounded plates are presented
|
|
8. |
- Andersson, Angelica, et al.
(författare)
-
TV shearography : quantitative measurement of shear-magnitude fields by use of digital speckle photography
- 2000
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 39:16, s. 2565-2568
-
Tidskriftsartikel (refereegranskat)abstract
- Digital speckle photography combined with TV shearography is developed for precise measurement of the magnitude of the shear field in a linear shear configuration. As an application the method is implemented to determine the slope-change variations of a three-dimensional object with TV shearography in which the shear magnitude is obtained with the digital speckle photography technique
|
|
9. |
- Arndt, Christoph, et al.
(författare)
-
Laser Applications to Chemical, Security, and Environmental Analysis : introduction to the feature issue
- 2023
-
Ingår i: Applied Optics. - 1559-128X. ; 62:6, s. 1-3
-
Tidskriftsartikel (refereegranskat)abstract
- The eighteenth topical meeting on Laser Applications to Chemical, Security, and Environmental Analysis (LACSEA) was held in Vancouver, Canada from 11–15 July 2022, as part of the Optica Optical Sensors and Sensing Congress in a hybrid format allowing on-site and online attendance. The meeting featured a broad range of distinguished papers focusing on recent advances in laser and optical spectroscopy. A total of 52 contributed and invited papers were presented during the meeting, including topics such as photo-acoustic spectroscopy, imaging, non-linear technologies, frequency combs, remote sensing, environmental monitoring, aerosols, combustion diagnostics, hypersonic flow diagnostics, nuclear diagnostics, fs/ps applications, and machine learning and computational sensing.
|
|
10. |
- Bajt, Sasa, et al.
(författare)
-
Camera for coherent diffractive imaging and holography with a soft-x-ray free-electron laser
- 2008
-
Ingår i: Applied Optics. - 1559-128X .- 2155-3165. ; 47:10, s. 1673-1683
-
Tidskriftsartikel (refereegranskat)abstract
- We describe a camera to record coherent scattering patterns with a soft-x-ray free-electron laser (FEL). The camera consists of a laterally graded multilayer mirror, which reflects the diffraction pattern onto a CCD detector. The mirror acts as a bandpass filter for both the wavelength and the angle, which isolates the desired scattering pattern from nonsample scattering or incoherent emission from the sample. The mirror also solves the particular problem of the extreme intensity of the FEL pulses, which are focused to greater than 10(14) W/cm2. The strong undiffracted pulse passes through a hole in the mirror and propagates onto a beam dump at a distance behind the instrument rather than interacting with a beam stop placed near the CCD. The camera concept is extendable for the full range of the fundamental wavelength of the free electron laser in Hamburg (FLASH) FEL (i.e., between 6 and 60 nm) and into the water window. We have fabricated and tested various multilayer mirrors for wavelengths of 32, 16, 13.5, and 4.5 nm. At the shorter wavelengths mirror roughness must be minimized to reduce scattering from the mirror. We have recorded over 30,000 diffraction patterns at the FLASH FEL with no observable mirror damage or degradation of performance.
|
|