| 1. |
- Ackermann, Thomas, et al.
(författare)
-
An overview of wind energy-status 2002
- 2002
-
Ingår i: Renewable & sustainable energy reviews. - 1364-0321 .- 1879-0690. ; 6:1-2, s. 67-128
-
Forskningsöversikt (refereegranskat)
|
|
| 2. |
|
|
| 3. |
- Abdalla, A. M., et al.
(författare)
-
Nanomaterials for solid oxide fuel cells: A review
- 2018
-
Ingår i: Renewable and Sustainable Energy Reviews. - : Elsevier BV. - 1879-0690 .- 1364-0321. ; 82, s. 353-368
-
Forskningsöversikt (refereegranskat)abstract
- Nanotechnology is utilized well in the development and improvement of the performance in Solid Oxide Fuel Cells (SOFCs). The high operating temperature of SOFCs (700–900 °C) has resulted in serious demerits regarding their overall performance and durability. Therefore, the operating temperature has been reduced to an intermediate temperature range of approximately 400–700 °C which improved performance and, subsequently, commercialized SOFCs as portable power sources. However, at reduced temperature, challenges such as an increase in internal resistance of the fuel cell components arise. Although, this may not be as serious as problems encountered at high temperature, it still significantly affects the performance of SOFCs. This review paper addresses the work of researchers in the application of nanotechnology in fabricating SOFCs through distinct methods. These methods have successfully omitted or at least reduced the internal resistance and showed considerable improvement in power density of the SOFCs at reduced temperatures.
|
|
| 4. |
- Abolhosseini, Shahrouz, et al.
(författare)
-
The main support mechanisms to finance renewable energy development
- 2014
-
Ingår i: Renewable & sustainable energy reviews. - : Elsevier BV. - 1364-0321 .- 1879-0690. ; 40, s. 876-885
-
Forskningsöversikt (refereegranskat)abstract
- Considering that the major part of greenhouse gases is carbon dioxide, there is a global concern aimed at reducing carbon emissions. In addition, major consumer countries are looking for alternative sources of energy to avoid the impact of higher fossil fuel prices and political instability in the major energy supplying countries. In this regard, different policies could be applied to reduce carbon emissions, such as enhancing renewable energy deployment and encouraging technological innovation and the creation of green jobs. This study compares three main support mechanisms employed by governments to finance renewable energy development programs: feed-in-tariffs, tax incentives, and tradable green certificates. Considering that many of the promising technologies to deploy renewable energy require investment in small-scale energy production systems, these mechanisms could be used to enhance renewable energy development at the desired scale. Employing a carbon emission tax or emission trading mechanism could be considered ideal policies to mitigate emissions at the lowest cost. The comparison of feed-in-tariffs and renewable portfolio standard policies showed that the former is good when a policy to develop renewable energy sources with a low level of risk for investors is considered. However, the latter is an appropriate policy when a market view policy is applied by the government. Finally, considering technological progress and the cost reduction for power generation by renewable energy sources, we suggest that support mechanism policies should be reconsidered from the financial point of view. (C) 2014 Elsevier Ltd. All rights reserved.
|
|
| 5. |
- Adom, Philip Kofi, et al.
(författare)
-
What drives the energy saving role of FDI and industrialization in East Africa?
- 2016
-
Ingår i: Renewable & sustainable energy reviews. - : Elsevier. - 1364-0321 .- 1879-0690. ; 65, s. 925-942
-
Tidskriftsartikel (refereegranskat)abstract
- Analysis of the unconditional impacts of foreign direct inflows (FDIs) and industrialization on energy intensity does not show the hidden roles of some economic conditions such as income and trade openness. In this study, we focused on the conditional impacts of FDIs and industrialization on energy productivity using a panel data consisting of thirteen (13) East African countries covering 1980–2011. The baseline result shows that higher income and a well-integrated economy are pro-energy productive, but FDIs and intense industrialization are anti-energy productive in the sub-region. This result remains robust even when we exclude the high income group and control for income group effects. Income significantly promotes energy productivity more in low income group than middle income group. Intense industrialization and FDIs significantly decreases energy productivity only in low income countries. Trade openness significantly promotes energy productivity only in middle income group. We have shown that FDIs and income, intense industrialization and FDIs, and intense industrialization and globalization are complementary forces that promote energy productivity in East Africa but this is more evident for the middle income group than the low income group in the sub-region. Based on the result, we recommend a quadruplet programme called the “Growth, Industrial, Foreign investment and Trade programme” (GIFTP). Last, our result suggests that unconditional analysis of energy productivity should not be seen as an end in itself but a basis for further analysis.
|
|
| 6. |
- Aftab, A., et al.
(författare)
-
Nanoparticles based drilling muds a solution to drill elevated temperature wells : a review
- 2017
-
Ingår i: Renewable & sustainable energy reviews. - : Elsevier. - 1364-0321 .- 1879-0690. ; 76, s. 1301-1313
-
Tidskriftsartikel (refereegranskat)abstract
- Demand of the oil and gas energy is increasing very drastically. Conventional hydrocarbon reservoirs contain below the sealing cap rock (shale) and easily move towards wellbore are at the depletion stage. Therefore, drilling engineers in collaboration with mud engineers, geologists and geophysicists are looking for innovative materials to drill unconventional hydrocarbons reservoir which are distributed at the basin scale and cannot approach easily. Geo-thermal energy wells and most of unconventional reservoirs are occurred at high pressure high temperature (HPHT) conditions. Conventional micro-macro organic drilling mud additives with heat insulator in nature can minimize efficiency while drilling HPHT wells. Oil-based muds (OBM) are strictly restricted due to high toxic level and poor emulsion stability at HT. However, this review suggests that addition of macro size organic particles and inorganic nanoparticles can enhance rheological performance, reduce filtrate loss volume and improve shale inhibition characteristics of environmental friendly water-based mud (WBM). Despite an impressive amount of experimental work has been done over drilling additives and their effect over rheological and shale inhibition, taking into account their literature review are rare. In addition, there is no review work of the knowledge gained to date. This work will hope fully trigger further development and new research topics in the area of drilling muds system.
|
|
| 7. |
- Aghaali, Habib, 1981-, et al.
(författare)
-
A review of turbocompounding as a waste heat recovery system for internal combustion engines
- 2015
-
Ingår i: Renewable & sustainable energy reviews. - : Elsevier BV. - 1364-0321 .- 1879-0690. ; 49, s. 813-824
-
Tidskriftsartikel (refereegranskat)abstract
- Internal combustion engines waste a large amount of fuel energy through their exhausts. Various technologies have been developed for waste heat recovery such as turbocompounds, Rankine bottoming cycles, and thermoelectric generators that reduce fuel consumption and CO2 emissions. Turbocompounding is still not widely applied to vehicular use despite the improved fuel economy, lower cost, volume, and complexity higher exhaust gas recirculation driving capability and improved transient response. This paper comprehensively reviews the latest developments and research on turbocompounding to discover important variables and provide insights into the implementation of a high-efficiency turbocompound engine. Attention should be paid to the optimization of turbocompound engines and their configurations because the major drawback of this technology is additional exhaust back-pressure, which leads to higher pumping loss in the engines. Applying different technologies and concepts on turbocompound engines makes the exhaust energy recovery more efficient and provides more freedom in the design and optimization of the engines. Turbine efficiency plays an important role in the recovery of the wasted heat so turbine design is a crucial issue in turbocompounding. In addition, variability in geometry and rotational speed of power turbines allows for more efficient turbocompound engines in different operating conditions. The conclusion drawn from this review is that turbocompounding is a promising technology for reducing fuel consumption in the coming decades in both light- and heavy-duty engines.
|
|
| 8. |
- Ahlborg, Helene, 1980, et al.
(författare)
-
Thirty-five years of research on energy and power: A landscape analysis
- 2024
-
Ingår i: Renewable and Sustainable Energy Reviews. - 1879-0690 .- 1364-0321. ; 199
-
Forskningsöversikt (refereegranskat)abstract
- The urgent need to mitigate climate change and decarbonise the energy sector brings the risk that wider social and environmental concerns about the sustainability of energy systems are neglected. Countries may achieve decarbonization goals while reproducing or worsening the unequal distribution of access, opportunities, costs and burdens that is inherent to current energy systems. This study is motivated by the tension between visions for change towards sustainable energy systems and historic and contemporary inequities on the ground. The study contributes a quantitative, global-scope overview of existing research that places energy users and their lives at the centre of analysis for inclusive and equitable transitions. It further identifies the themes, concepts and perspectives that dominate scholarly debate and analyses the presence and relative influence of work that explicitly considers relations of power. The stepwise review uses the Scopus database and multiple bibliometric tools, covering the period until June 2022. It adopts a novel approach to identify dominant and marginal topics, geographical contexts and theoretical lenses employed including the uptake of critical social science approaches. The results indicate that dominant studies fail to engage critically with relationships of power. Even within the debate on “energy poverty”, work based in critical theory approaches account for less than seven percentages of the total body of work. For work on “energy justice” and users, four percentages of publications account for gender. The dominant language is technical and depoliticized. The study identifies research gaps and promising avenues for further research.
|
|
| 9. |
- Akhlaghi, Shahin, et al.
(författare)
-
Deterioration of automotive rubbers in liquid biofuels : A review
- 2015
-
Ingår i: Renewable & sustainable energy reviews. - : Elsevier BV. - 1364-0321 .- 1879-0690. ; 43, s. 1238-1248
-
Forskningsöversikt (refereegranskat)abstract
- Concerns over the fast depletion of fossil fuels, environmental issues and stringent legislation associated with petroleum-based fuels have triggered a shift to bio-based fuels, as an alternative to meet the growing energy demand in the transportation sector. However, since conventional automobile fuel systems are adapted to petroleum-based fuels, switching to biofuels causes a severe deterioration in the performance of currently used rubber components. The degradation of the rubber materials in biofuels is complicated by the presence of different additives in biofuels and rubber compounds, by oxidation of biofuels and by the effects of thermomechanical loadings in the engine. This paper presents a comprehensive review of the effects of different types of biofuels, particularly biodiesel and bioethanol, on the physical, mechanical, morphological and thermal properties of elastomers under different exposure conditions. In addition, the literature data available on the variation of rubbers' resistance to biofuels with the changes in their monomer type and composition, cure system and additives content was also studied. The review essentially focuses on the compatibility of biofuels with acrylonitrile butadiene rubber, fluoroelastomers, polychloroprene rubber and silicon rubber, as the most commonly used automotive rubbers coming into contact with fuels during their service. The knowledge summarized in this study can help to develop a guideline on the selection of rubber for automotive parts designed to withstand biofuels.
|
|
| 10. |
- Allard, Ingrid, et al.
(författare)
-
Methods for energy analysis of residential buildings in Nordic countries
- 2013
-
Ingår i: Renewable & sustainable energy reviews. - : Pergamon-Elsevier Science. - 1364-0321 .- 1879-0690. ; 22, s. 306-318
-
Forskningsöversikt (refereegranskat)abstract
- To meet the goals of the directive 2010/31/EU on the energy performance of buildings, the building sector in Europe now faces a transition towards more energy efficient buildings. Research and development of new energy solutions and technology will be necessary for the transition and the importance of analyzing building energy performance increases. This paper aims to review and evaluate different methods that are commonly used to analyze energy performance in residential buildings in Nordic countries, primarily in Sweden, Norway and Finland. A short international review of regulations is also included. The goal is to find commonly used methods and possibilities for the future. The introduced methods are summarized, categorized and compared based on their advantages and disadvantages. Although the three Nordic countries have similar climate conditions and building traditions, the review shows relatively large variations in the definitions of energy performance for residential buildings, as well as variations in how measurements and calculations are used in the methods for energy performance analysis. In the conducted review, methods, or parts of methods, are also found to be used. The methods used to analyze energy performance are found to be more similar than the concepts of energy performance itself in the three countries. These aspects may be considered in further work to develop an international policy practice for energy performance of residential buildings in cold climate.
|
|
