| 1. |
- Aabel, Lise, et al.
(författare)
-
A TDD Distributed MIMO Testbed Using a 1-bit Radio-Over-Fiber Fronthaul Architecture
- 2024
-
Ingår i: IEEE Transactions on Microwave Theory and Techniques. - 0018-9480 .- 1557-9670. ; In Press
-
Tidskriftsartikel (refereegranskat)abstract
- We present the uplink and downlink of a time-division duplex distributed multiple-input multiple-output (D-MIMO) testbed, based on a 1-bit radio-over-fiber architecture, which is low cost and scalable. The proposed architecture involves a central unit (CU) that is equipped with 1-bit digital-to-analog and analog-to-digital converters, operating at 10 GS/s. The CU is connected to multiple single-antenna remote radio heads (RRHs) via optical fibers, over which a binary radio frequency (RF) waveform is transmitted. In the uplink, a binary RF waveform is generated at the RRHs by a comparator, whose inputs are the received RF signal and a suitably designed dither signal. In the downlink, a binary RF waveform is generated at the CU via bandpass sigma-delta modulation. Our measurement results show that low error-vector magnitude (EVM) can be achieved in both the uplink and the downlink, despite 1-bit sampling at the CU. Specifically, for point-to-point over-cable transmission between a single user equipment (UE) and a CU equipped with a single RRH, we report, for a 10-MBd signal using single-carrier (SC) 16 quadratic-amplitude modulation (QAM) modulation, an EVM of 3.3% in the downlink, and of 4.5% in the uplink. We then consider a CU connected to three RRHs serving over the air two UEs, and show that, after over-the-air reciprocity calibration, a downlink zero-forcing precoder designed on the basis of uplink channel estimates at the CU achieves an EVM of 6.4% and 10.9% at UE 1 and UE 2, respectively. Finally, we investigate the ability of the proposed architecture to support orthogonal frequency-division multiplexing (OFDM) waveforms, and its robustness against both in-band and out-of-band interference.
|
|
| 2. |
- Aabel, Lise, 1992, et al.
(författare)
-
Distributed Massive MIMO via all-Digital Radio Over Fiber
- 2020
-
Ingår i: Conference Record - Asilomar Conference on Signals, Systems and Computers. - 1058-6393. ; 2020-November, s. 319-323
-
Konferensbidrag (refereegranskat)abstract
- A crucial challenge in the implementation of distributed massive multiple-input multiple-output (MIMO) architectures is to provide phase coherence while, at the same time, limit the complexity of the remote-radio heads (RRHs), which is important for cost-efficient scalability. To address this challenge, we present in this paper a phase-coherent distributed MIMO architecture, based on off-the-shelf, low-cost components. In the proposed architecture, up- and down-conversion are carried out at the central unit (CU). The RRHs are connected to the CU by means of optical fibers carrying oversampled radio-frequency (RF) 1-bit signals. In the downlink, the 1-bit signal is generated via sigma-delta modulation. At the RRH, the RF signal is recovered from the 1-bit signal through a bandpass filter and a power amplifier, and then fed to an antenna. In the uplink, the 1-bit signal is generated by a comparator whose inputs are the low-noise-amplified received RF signal and a suitably designed dither signal. The performance of the proposed architecture is evaluated with satisfactory results both via simulation and measurements from a testbed.
|
|
| 3. |
- Hu, Anzhong, et al.
(författare)
-
EVM Analysis of Distributed Massive MIMO with 1-Bit Radio-Over-Fiber Fronthaul
- 2024
-
Ingår i: IEEE Transactions on Communications. - 0090-6778 .- 1558-0857. ; In Press
-
Tidskriftsartikel (refereegranskat)abstract
- We analyze the uplink performance of a distributed massive multiple-input multiple-output (MIMO) architecture in which the remotely located access points (APs) are connected to a central processing unit via a fiber-optical fronthaul carrying a dithered and 1-bit quantized version of the received radio-frequency (RF) signal. The innovative feature of the proposed architecture is that no down-conversion is performed at the APs. This eliminates the need to equip the APs with local oscillators, which may be difficult to synchronize. Under the assumption that a constraint is imposed on the amount of data that can be exchanged across the fiber-optical fronthaul, we investigate the tradeoff between spatial oversampling, defined in terms of the total number of APs, and temporal oversampling, defined in terms of the oversampling factor selected at the central processing unit, to facilitate the recovery of the transmitted signal from 1-bit samples of the RF received signal. Using the so-called error-vector magnitude (EVM) as performance metric, we shed light on the optimal design of the dither signal, and quantify, for a given number of APs, the minimum fronthaul rate required for our proposed distributed massive MIMO architecture to outperform a standard co-located massive MIMO architecture in terms of EVM.
|
|
| 4. |
- Jacobsson, Sven, 1990, et al.
(författare)
-
Massive MU-MIMO-OFDM uplink with direct RF-sampling and 1-Bit ADCs
- 2019
-
Ingår i: 2019 IEEE Globecom Workshops, GC Wkshps 2019 - Proceedings.
-
Konferensbidrag (refereegranskat)abstract
- Advances in analog-to-digital converter (ADC) technology have opened up the possibility to directly digitize wideband radio frequency (RF) signals, avoiding the need for analog down- conversion. In this work, we consider an orthogonal frequency- division multiplexing (OFDM)-based massive multi-user (MU) multiple-input multiple-output (MIMO) uplink system that relies on direct RF-sampling at the base station and digitizes the received RF signals with 1-bit ADCs. Using Bussgang's theorem, we provide an analytical expression for the error-vector magnitude (EVM) achieved by digital down-conversion and zero-forcing combining. Our results demonstrate that direct RF-sampling 1-bit ADCs enables low EVM and supports high-order constellations in the massive MU-MIMO- OFDM uplink.
|
|
| 5. |
|
|
| 6. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
All-Digital, Radio-over-Fiber, Communication Link Architecture for Time-Division Duplex Distributed Antenna Systems
- 2021
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 39:9, s. 2769-2779
-
Tidskriftsartikel (refereegranskat)abstract
- Radio-over-fiber is a popular technique to establish communication links between a central location and many remote antenna units. Many different architectures are available for the downlink, i.e., for the communication link from the central unit to the remote antennas. On the contrary, the low-cost and low-complexity requirement of the remote units makes it difficult to devise architectures suitable for the uplink, i.e., for the communication link from the remote antennas to the central unit. In this paper, we address this and propose a low-complexity, all-digital, time-division-duplex communication architecture. For the downlink, a band-pass sigma-delta-over-fiber is employed. In the receive mode, the uplink includes an all-digital pulse-width-modulation technique. The received radio frequency (RF) signal is quantized into a binary stream through comparison with a tailored reference signal provided by the central unit. The direct quantization of the RF signal eliminates any need for local-oscillator and mixer stages at the remote units. The performance of the proposed architecture is investigated through extensive simulations and measurements. For instance, the all-digital, time-division duplex communication link provides -30.0 dB and -25.5 dB normalized mean square error signal quality through downlink and uplink communication with 20-MHz, 64-quadrature amplitude modulation signals centered at 2.365-GHz, respectively.
|
|
