| 1. |
- Andersson, Christer, 1982, et al.
(författare)
-
Decade bandwidth high efficiency GaN HEMT power amplifier designed with resistive harmonic loading
- 2012
-
Ingår i: IEEE MTT-S International Microwave Symposium Digest. - 0149-645X. - 9781467310871
-
Konferensbidrag (refereegranskat)abstract
- The use of resistive loading at higher harmonics in wideband power amplifier design is proposed. Although the theoretical efficiency of such operation is lower than other classes the significantly simplified load network design potentially allows for multi-octave realizations. A decade bandwidth (0.4-4.1 GHz) GaN HEMT power amplifier was thereby designed, delivering more than 40 dBm output power with 10-15 dB gain and 40-62% drain efficiency. Linearized modulated signal amplification was then successfully demonstrated at multiple frequencies (0.9 to 3.5 GHz), using various downlink signals (LTE, WCDMA, WiMAX), with resulting ACLR lower than 46 dBc.
|
|
| 2. |
- Andersson, J. Christer, 1974-
(författare)
-
Rock Mass Response to Coupled Mechanical Thermal Loading : Äspö Pillar Stability Experiment, Sweden
- 2007
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The geological disposal of nuclear waste, in underground openings and the long-term performance of these openings demand a detailed understanding of fundamental rock mechanics. A full scale field experiment: Äspö Pillar Stability Experiment was conducted at a depth of 450 m in sparsely fractured granitic rock to examine the rock mass response between two deposition holes. An oval shaped tunnel was excavated parallel to the σ3 direction to provide access to the experiment and also provide elevated stress magnitudes in the floor. In the tunnel floor two 1.75-m diameter 6-m deep boreholes were excavated so that a 1-m thick pillar was created between them. In one of the holes a confinement pressure of 700 kPa was applied and in the other displacement transducers were installed. The pillar volume was monitored by an Acoustic Emission System. Spatially distributed thermocouples were used to monitor the temperature development as the pillar was heated by electrical heaters. The excavation-induced stress together with the thermal-induced stress was sufficient to cause the wall of the open borehole to yield. The temperature-induced stress was increased slowly to enable detailed studies of the rock mass yielding process. Once the rock mass loading response was observed, the rock mass was unloaded using a de-stress slotting technique.This thesis focuses on the in-situ study of the rock mass response to coupled mechanical thermal loading and thermal-mechanical unloading. The experiment, its design, monitoring and observations are thoroughly described. An estimate of the yielding strength of the rock mass is presented and compared with laboratory test and results from other rock mass conditions reported elsewhere in the open literature. General conclusions about the effect of the confining pressure and the observations from the unloading of the pillar are also presented.Important findings are that the yielding strength of the rock mass has been successfully determined, low confinement pressures significantly affects the onset of yielding, the primary mode of fracture initiation and propagation is extensional, no significant time dependency of the yielding process was observed. The unloading studies also indicated that what appeared to be shear bands likely was a propagating zone of extensile failure that weakened the rock so that displacements in the shear direction could occur.
|
|
