| 1. |
- Bravo, L, et al.
(författare)
-
- 2021
-
swepub:Mat__t
|
|
| 2. |
- Tabiri, S, et al.
(författare)
-
- 2021
-
swepub:Mat__t
|
|
| 3. |
- Fernandes, C., et al.
(författare)
-
New deep eutectic solvent assisted extraction of highly pure lignin from maritime pine sawdust (Pinus pinaster Ait.)
- 2021
-
Ingår i: International Journal of Biological Macromolecules. - : Elsevier BV. - 0141-8130 .- 1879-0003. ; 177, s. 294-305
-
Tidskriftsartikel (refereegranskat)abstract
- Lignocellulosic biomass is a renewable and sustainable feedstock, mainly composed of cellulose, hemicellulose, and lignin. Lignin, as the most abundant natural aromatic polymer occurring on Earth, has great potential to produce value-added products. However, the isolation of highly pure lignin from biomass requires the use of efficient methods during lignocellulose fractionation. Therefore, in this work, novel acidic deep eutectic solvents (DESs) were prepared, characterized and screened for lignin extraction from maritime pine wood (Pinus pinaster Ait.) sawdust. The use of cosolvents and the development of new DES were also evaluated regarding their extraction and selectivity performance. The results show that an 1 h extraction process at 175 °C, using a novel DES composed of lactic acid, tartaric acid and choline chloride, named Lact:Tart:ChCl, in a molar ratio of 4:1:1, allows the recovery of 95 wt% of the total lignin present in pine biomass with a purity of 89 wt%. Such superior extraction of lignin with remarkable purity using a “green” solvent system makes this process highly appealing for future large-scale applications.
|
|
| 4. |
- Lima, Filipe S., et al.
(författare)
-
Sodium Triflate Decreases Interaggregate Repulsion and Induces Phase Separation in Cationic Micelles
- 2015
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 0743-7463 .- 1520-5827. ; 31:9, s. 2609-2614
-
Tidskriftsartikel (refereegranskat)abstract
- Dodecyltrimethylammonium triflate (DTATf) micelles possess lower degree of counterion dissociation (a), lower hydration, and higher packing of monomers than other micelles of similar structure. Addition of sodium triflate ([NaTf] > 0.05 M) to DTATf solutions promotes phase separation. This phenomenon is commonly observed in oppositely charged surfactant mixtures, but it is rare for ionic surfactants and relatively simple counterions. While the properties of DTATf have already been reported, the driving forces for the observed phase separation with added salt remain unclear. Thus, we propose an interpretation for the observed phase separation in cationic surfactant solutions. Addition of up to 0.03 M NaTf to micellar DTATf solutions led to a limited increase of the aggregation number, to interface dehydration, and to a progressive decrease in a. The viscosity of DTATf solutions of higher concentration ([DTATf] = 0.06 M) reached a maximum with increasing [NaTf], though the aggregation number slightly increased, and no shape change occurred. We hypothesize that this maximum results from a decrease in interaggregate repulsion, as a consequence of increased ion binding. This reduction in micellar repulsion without simultaneous infinite micellar growth is, probably, the major driving force for phase separation at higher [NaTf].
|
|
| 5. |
- Melro, Elodie, et al.
(författare)
-
Dissolution of kraft lignin in alkaline solutions
- 2020
-
Ingår i: International Journal of Biological Macromolecules. - : Elsevier BV. - 0141-8130 .- 1879-0003. ; 148, s. 688-695
-
Tidskriftsartikel (refereegranskat)abstract
- Lignins are among the most abundant renewable resources on the planet. However, their application is limited by the lack of efficient dissolution and extraction methodologies. In this work, a systematic and quantitative analysis of the dissolution efficiency of different alkaline-based aqueous systems (i.e. lithium hydroxide, LiOH; sodium hydroxide, NaOH; potassium hydroxide, KOH; cuprammonium hydroxide, CuAOH; tetrapropylammonium hydroxide, TPAOH and tetrabutylammonium hydroxide, TBAOH) is reported, for the first time, for kraft lignin. Phase maps were determined for all systems and lignin solubility was found to decrease in the following order: LiOH > NaOH > KOH > CuAOH > TPAOH > TBAOH, thus suggesting that the size of the cation plays an important role on its solubility. The π∗ parameter has an opposite trend to the solubility, supporting the idea that cations of smaller size favor lignin solubility. Dissolution was observed to increase exponentially above pH 9–10 being the LiOH system the most efficient. The soluble and insoluble fractions of lignin in 0.1 M NaOH were collected and analyzed by several techniques. Overall, data suggests a greater amount of simple aromatic compounds, preferentially containing sulfur, in the soluble fraction while the insoluble fraction is very similar to the native kraft lignin.
|
|
| 6. |
- Melro, Elodie, et al.
(författare)
-
Levulinic acid : A novel sustainable solvent for lignin dissolution
- 2020
-
Ingår i: International Journal of Biological Macromolecules. - : Elsevier BV. - 0141-8130 .- 1879-0003. ; 164, s. 3454-3461
-
Tidskriftsartikel (refereegranskat)abstract
- Lignin is a natural, renewable resource with potential to be used in biomaterials. Due to its complex structure, its efficient dissolution is still challenging, which hinders its applicability at large scale. This challenge become harder considering the current need of sustainable and environmentally friendly solvents. To the best of our knowledge, this work reports for the first time the dissolution of kraft lignin in levulinic acid, a “green” solvent, and compares its efficiency with common carboxylic acids and sulfuric acid. It has been found that levulinic acid has a high capacity to dissolve kraft lignin at room temperature (40 wt% solubility), and it efficiency is not compromised when diluting the acid with water (up to 40 wt% water content). The Kamlet-Taft π⁎ parameter of the different acidic solvents was estimated and found to correlate well with their solubility performance. Lignins previously dissolved in levulinic and formic acids were selected to be regenerated and minor differences were found in thermal stability and morphological structure, when compared to native kraft lignin. However, an increase in the content of the carbonyl groups in the regenerated lignin material was observed.
|
|
| 7. |
- Melro, Elodie, et al.
(författare)
-
Levulinic Acid-Based "Green" Solvents for Lignocellulose Fractionation : On the Superior Extraction Yield and Selectivity toward Lignin
- 2023
-
Ingår i: Biomacromolecules. - : American Chemical Society (ACS). - 1525-7797 .- 1526-4602. ; 24:7, s. 3094-3104
-
Tidskriftsartikel (refereegranskat)abstract
- The high potential use of lignin in novel biomaterialsand chemicalsrepresents an important opportunity for the valorization of the mostabundant natural resource of aromatic molecules. From an environmentalperspective, it is highly desirable replacing the hazardous methodscurrently used to extract lignin from lignocellulosic biomass anddevelop more sustainable and environmentally friendly approaches.Therefore, in this work, levulinic acid (a "green" solventobtained from biomass) was successfully used, for the first time,to selectively extract high-quality lignin from pine wood sawdustresidues at 200 degrees C for 6 h (at atmospheric pressure). Moreover,the addition of catalytic concentrations of inorganic acids (i.e.,H2SO4 or HCl) was found to substantially reducethe temperature and reaction times needed (i.e., 140 degrees C, 2 h)for complete lignin extraction without compromising its purity. NMRdata suggests that condensed OH structures and acidic groups are presentin the lignin following extraction. Levulinic acid can be easily recycledand efficiently reused several times without affecting its performance.Furthermore, excellent solvent reusability and performance of extractionof other wood residues has been successfully demonstrated, thus makingthe developed levulinic acid-based procedure highly appealing andpromising to replace the traditional less sustainable methodologies.
|
|
| 8. |
- Alves, Luis, et al.
(författare)
-
Dissolution state of cellulose in aqueous systems. 1. Alkaline solvents
- 2016
-
Ingår i: Cellulose. - : Springer Science and Business Media LLC. - 0969-0239 .- 1572-882X. ; 23:1, s. 247-258
-
Tidskriftsartikel (refereegranskat)abstract
- The understanding of the state of dissolution of cellulose in a certain solvent is a critical step forward in the development of new efficient solvent systems for cellulose. Nevertheless, obtaining such information is not trivial. Recently, polarization transfer solid-state NMR (PTssNMR) was shown to be a very promising technique regarding an efficient and robust characterization of the solution state of cellulose. In the present study, combining PTssNMR, microscopic techniques and X-ray diffraction, a set of alkaline aqueous systems are investigated. The addition of specific additives, such as urea or thiourea, to aqueous NaOH based systems as well as the use of an amphiphilic organic cation, is found to have pronounced effects on the dissolution efficiency of cellulose. Additionally, the characteristics of the regenerated material are strongly dependent on the dissolution system; typically less crystalline materials, presenting smoother morphologies, are obtained when amphiphilic solvents or additives are used.
|
|
| 9. |
- Alves, Luis, et al.
(författare)
-
Dissolution state of cellulose in aqueous systems. 2. Acidic solvents
- 2016
-
Ingår i: Carbohydrate Polymers. - : Elsevier BV. - 0144-8617 .- 1879-1344. ; 151, s. 707-715
-
Tidskriftsartikel (refereegranskat)abstract
- Cellulose is insoluble in water but can be dissolved in strong acidic or alkaline conditions. How well dissolved cellulose is in solution and how it organizes are key questions often neglected in literature. The typical low pH required for dissolving cellulose in acidic solvents limits the use of typical characterization techniques. In this respect, Polarization Transfer Solid State NMR (PT ssNMR) emerges as a reliable alternative. In this work, combining PT ssNMR, microscopic techniques and X-ray diffraction, a set of different acidic systems (phosphoric acid/water, sulfuric acid/glycerol and zinc chloride/water) is investigated. The studied solvent systems are capable to efficiently dissolve cellulose, although degradation occurs to some extent. PT ssNMR is capable to identify the liquid and solid fractions of cellulose, the degradation products and it is also sensitive to gelation. The materials regenerated from the acidic dopes were found to be highly sensitive to the solvent system and to the presence of amphiphilic additives in solution.
|
|
| 10. |
- Alves, Luis, et al.
(författare)
-
On the rheology of mixed systems of hydrophobically modified polyacrylate microgels and surfactants : Role of the surfactant architecture
- 2018
-
Ingår i: Journal of Colloid and Interface Science. - : Elsevier BV. - 0021-9797 .- 1095-7103. ; 513, s. 489-496
-
Tidskriftsartikel (refereegranskat)abstract
- Hypothesis The rheological control of suspensions is of key interest in the formulation design. A chemically cross-linked hydrophobically modified poly(acrylic acid) (HMCL-PAA), used as rheology modifier, is pH sensitive and shows swelling behavior above a critical pH due to the ionization of the acrylic acid groups. At low pH, HMCL-PAA suspensions are liquid and turbid. The binding of surfactants to HMCL-PAA, at low pH conditions, can result in significant changes on rheology and transparency of the polymeric suspensions, due to the swelling of the microgel particles. Experiments The influence of surfactants addition on the rheological properties and transparency of HMCL-PAA suspensions was determined. A systematic study was performed using different types of surfactants (ionic, non-ionic and zwitterionic). Findings The gelation efficiency of HMCL-PAA suspensions at low pH is strongly dependent on surfactant architecture: ionic surfactants are found to be much more efficient than non-ionic or zwitterionic surfactants. Ionic surfactants lead to a liquid-to-gel transition accompanied by an increase of transparency of the suspensions. Among the ionic surfactants, anionics show stronger interactions with the polymer. Also the surfactant hydrophobicity is relevant; the more hydrophobic the surfactant, the stronger is the binding to the polymer and thus the larger the particle swelling.
|
|
