| 1. |
- Almeida, Cristiane G., et al.
(författare)
-
Photocatalytic hydrogen production with visible light over Mo and Cr-doped BiNb(Ta)O-4
- 2014
-
Ingår i: International journal of hydrogen energy. - : Elsevier BV. - 0360-3199 .- 1879-3487. ; 39:3, s. 1220-1227
-
Tidskriftsartikel (refereegranskat)abstract
- In the present work, we prepared pure and Cr(III) and Mo(V)-doped BiNbO4 and BiTaO4 by the citrate method. Pure BiNbO4 and BiTaO4 were obtained in triclinic phase at 600 degrees C and 800 degrees C, respectively. The metal doping influenced strongly the crystal structure as well as the photocatalytic activity of the oxides. The XRD data could prove that the Mo(V) doping induces the orthorhombic phase, while the Cr(III) doping favors the triclinic phase for both oxides. Metal doping also modified the photosensitivity of the oxides, extending the absorption toward the visible light region. The photocatalytic activity in water splitting under visible light irradiation was evaluated by monitoring the H-2, CO2 and CO evolution. The results showed that Cr(III)-doped BiTaO4 and BiNbO4, in general, are more selective for hydrogen production, while Mo(V)-doped materials are more selective for CO2 generation. Comparing the photocatalytic activity of BiTaO4 and BiNbO4, the former shows higher activity for hydrogen production as well as for CO2 generation, specially when the concentration was 2% in Cr(III) and Mo(V), respectively. Those results are in agreement with the computational study to access the effect of doping on the electronic structure. For Mo(V)-doped materials a negligible change of conduction band minimum potential was found, indicating that there might be no improvement on the reduction power of the material following the substitutional doping. In Cr(III)-doped BiNbO4 there is a slight shift of the CBM potential increasing a little bit the reduction power. However, the effect is much stronger in the Cr(III)-doped BiTaO4.
|
|
| 2. |
- Triana, Carlos A., et al.
(författare)
-
Disentangling the intricate atomic short-range order and electronic properties in amorphous transition metal oxides
- 2017
-
Ingår i: Scientific Reports. - : Nature Publishing Group. - 2045-2322. ; 7
-
Tidskriftsartikel (refereegranskat)abstract
- Solid state materials with crystalline order have been well-known and characterized for almost a century while the description of disordered materials still bears significant challenges. Among these are the atomic short-range order and electronic properties of amorphous transition metal oxides [aTMOs], that have emerged as novel multifunctional materials due to their optical switching properties and high-capacity to intercalate alkali metal ions at low voltages. For decades, research on aTMOs has dealt with technological optimization. However, it remains challenging to unveil their intricate atomic short-range order. Currently, no systematic and broadly applicable methods exist to assess atomic-size structure, and since electronic localization is structure-dependent, still there are not well-established optical and electronic mechanisms for modelling the properties of aTMOs. We present state-of-the-art systematic procedures involving theory and experiment in a self-consistent computational framework to unveil the atomic short-range order and its role for the electronic properties. The scheme is applied to amorphous tungsten trioxide aWO(3), which is the most studied electrochromic aTMO in spite of its unidentified atomic-size structure. Our approach provides a one-to-one matching of experimental data and corresponding model structure from which electronic properties can be directly calculated in agreement with the electronic transitions observed in the XANES spectra.
|
|
| 3. |
- Triana, Carlos A, et al.
(författare)
-
Modeling of Electronic Properties of Amorphous Oxides
- 2018
-
Ingår i: Encyclopedia of Interfacial Chemistry. - : Elsevier. - 9780128097397 - 9780128098943 ; , s. 319-331
-
Bokkapitel (refereegranskat)abstract
- Amorphous transition metal oxides (aTMOs) are used as multifunctional materials in many technological applications. A detailed understanding of the electronic density of states is a necessary prerequisite for modeling their functional properties. The electronic properties, however, are structure-dependent making the description of the electronic structure of disordered and amorphous materials challenging. Here we present a scheme based on obtaining atomic model structures from simulations of experimental X-ray-Absorption spectra, together with first principles electronic structure calculations. This approach provides a self-consistent framework to assess fundamental electronic processes in aTMOs and can be applied to the study of disordered and amorphous materials in general.
|
|
| 4. |
- Acker, Pascal, et al.
(författare)
-
π-Conjugation Enables Ultra-High Rate Capabilities and Cycling Stabilities in Phenothiazine Copolymers as Cathode-Active Battery Materials
- 2019
-
Ingår i: Advanced Functional Materials. - : John Wiley & Sons. - 1616-301X .- 1616-3028. ; 29:45
-
Tidskriftsartikel (refereegranskat)abstract
- In recent years, organic battery cathode materials have emerged as an attractive alternative to metal oxide–based cathodes. Organic redox polymers that can be reversibly oxidized are particularly promising. A drawback, however, often is their limited cycling stability and rate performance in a high voltage range of more than 3.4 V versus Li/Li+. Herein, a conjugated copolymer design with phenothiazine as a redox‐active group and a bithiophene co‐monomer is presented, enabling ultra‐high rate capability and cycling stability. After 30 000 cycles at a 100C rate, >97% of the initial capacity is retained. The composite electrodes feature defined discharge potentials at 3.6 V versus Li/Li+ due to the presence of separated phenothiazine redox centers. The semiconducting nature of the polymer allows for fast charge transport in the composite electrode at a high mass loading of 60 wt%. A comparison with three structurally related polymers demonstrates that changing the size, amount, or nature of the side groups leads to a reduced cell performance. This conjugated copolymer design can be used in the development of advanced redox polymers for batteries.
|
|
| 5. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Disorder-induced Room Temperature Ferromagnetism in Glassy Chromites
- 2014
-
Ingår i: Scientific Reports. - : Springer Science and Business Media LLC. - 2045-2322. ; 4, s. 4686-
-
Tidskriftsartikel (refereegranskat)abstract
- We report an unusual robust ferromagnetic order above room temperature upon amorphization of perovskite [YCrO3] in pulsed laser deposited thin films. This is contrary to the usual expected formation of a spin glass magnetic state in the resulting disordered structure. To understand the underlying physics of this phenomenon, we combine advanced spectroscopic techniques and first-principles calculations. We find that the observed order-disorder transformation is accompanied by an insulator-metal transition arising from a wide distribution of Cr-O-Cr bond angles and the consequent metallization through free carriers. Similar results also found in YbCrO3-films suggest that the observed phenomenon is more general and should, in principle, apply to a wider range of oxide systems. The ability to tailor ferromagnetic order above room temperature in oxide materials opens up many possibilities for novel technological applications of this counter intuitive effect.
|
|
| 6. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Electronic and optical properties of MgH2: a first-principle GW investigation
- 2005
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 98:9, s. 096106-
-
Tidskriftsartikel (refereegranskat)abstract
- The electronic structure of MgH2 is studied using the state of the art all-electron projector-augmented-wave GW approximation. Both the ground-state and the high-pressure transformations are considered in this investigation. We have found an indirect (direct) band-gap of 5.58 eV (6.52 eV) for α-MgH2, which has a good agreement with the experimental findings. For the γ- and β-phases, we have found indirect (direct) band-gap values of 5.24 eV (5.33 eV) and 3.90 eV (4.72 eV), respectively. The optical properties are investigated by means of the complex dielectric function, which is calculated within the framework of a full-potential linearized augmented plane wave method and corrected by scissor operators. All phases are found to be color neutral insulators.
|
|
| 7. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Electronic and optical properties of pressure induced phases of MgH2
- 2005
-
Ingår i: Journal of Alloys and Compounds. - 0925-8388. ; 404:16, s. 220-
-
Tidskriftsartikel (refereegranskat)abstract
- The electronic and optical properties of pressure-induced phases of MgH2 are investigated using the full-potential linearized augmented plane wave method. The absorption features are investigated by means of the calculated complex dielectric function and the analysis are made based on the electronic structure. The phases as a whole exhibit a color neutral insulator behavior. The calculated band gap are in good agreement with earlier theoretical investigations. The absorption edges corrected by scissor operation matched quite well the experimental findings. The optical anisotropy has also been evaluated.
|
|
| 8. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Pressure-induced structural phase transition in NaBH4
- 2005
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 72:5, s. 054125-
-
Tidskriftsartikel (refereegranskat)abstract
- We present a combined experimental and theoretical study of the technologically important NaBH4 compound under high pressure. Using Raman spectroscopy at room temperature, we have found that NaBH4 undergoes a structural phase transformation starting at 10.0 GPa with the pure high-pressure phase being established above 15.0 GPa. In order to compare the Raman data recorded under high pressure with the low-temperature tetragonal phase of NaBH4, we have also performed a cooling experiment. The known order-disorder transition from the fcc to the tetragonal structure was then observed. However, the new high pressure phase does not correspond to this low-temperature structure. Using first-principle calculations based on the density functional theory, we show that the high-pressure phase corresponds to the alpha-LiAlH4–type structure. We have found a good agreement between the measured and calculated transition pressures. Additionally, we present the electronic structure of both the fcc and the high-pressure phases.
|
|
| 9. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Role of titanium in hydrogen desorption in crystalline sodium alanate
- 2005
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 86:25
-
Tidskriftsartikel (refereegranskat)abstract
- The role of Ti in improving the thermodynamics of hydrogen desorption in crystalline sodium alanate (NaAlH4) has been investigated by using the density functional theory. The total energy calculations reveal that Ti prefers to occupy the Na site over that of the Al site when the atomic energies are used as the reference. However, the use of the cohesive energies of Al, Na, and Ti leads to the Al site being the least unfavourable site. Irrespective of whether Ti occupies the Na or the Al site, the energy necessary to remove a hydrogen atom from Ti substituted sodium alanate is significantly lowered from that of the pure alanate. The understanding gained here may help in designing hydrogen storage materials suitable for industrial applications.
|
|
| 10. |
- Araujo, Carlos Moyses, et al.
(författare)
-
Vacancy Mediated Hydrogen Desorption in NaAlH4
- 2005
-
Ingår i: Physical Review B. - 1098-0121. ; 72:16, s. 165101-
-
Tidskriftsartikel (refereegranskat)abstract
- First principles calculations based on density functional theory are carried out to understand the mechanisms responsible for hydrogen desorption from Ti doped sodium-alanate (NaAlH4). While the energy needed to remove a hydrogen atom from NaAlH4 with Ti substituted either at the Na site or at Al site is found to be significantly lower than that from the pristine NaAlH4, the presence of Na-vacancies is shown to play an even larger role: It is not only an order of magnitude smaller than that from Ti doped sodium alanate, but the removal of hydrogen associated with a Na-vacancy is exothermic with respect to formation of H2 molecule. Furthermore, we show that the unusual stabilization of the magic AlH3 cluster in the vacancy containing sodium-alanate is responsible for this diminished value of hydrogen removal energy. It is suggested that this role of vacancy can be exploited in the design and synthesis of complex light metal hydrides suitable for hydrogen storage.
|
|
