| 1. |
|
|
| 2. |
|
|
| 3. |
- Arrhenius, Karine, et al.
(författare)
-
Detection of contaminants in hydrogen fuel for fuel cell electrical vehicles with sensors—available technology, testing protocols and implementation challenges
- 2022
-
Ingår i: Processes. - : MDPI. - 2227-9717. ; 10:1
-
Tidskriftsartikel (refereegranskat)abstract
- Europe’s low-carbon energy policy favors a greater use of fuel cells and technologies based on hydrogen used as a fuel. Hydrogen delivered at the hydrogen refueling station must be compliant with requirements stated in different standards. Currently, the quality control process is performed by offline analysis of the hydrogen fuel. It is, however, beneficial to continuously monitor at least some of the contaminants onsite using chemical sensors. For hydrogen quality control with regard to contaminants, high sensitivity, integration parameters, and low cost are the most important requirements. In this study, we have reviewed the existing sensor technologies to detect contaminants in hydrogen, then discussed the implementation of sensors at a hydrogen refueling stations, described the state-of-art in protocols to perform assessment of these sensor technologies, and, finally, identified the gaps and needs in these areas. It was clear that sensors are not yet commercially available for all gaseous contaminants mentioned in ISO14687:2019. The development of standardized testing protocols is required to go hand in hand with the development of chemical sensors for this application following a similar approach to the one undertaken for air sensors. © 2021 by the authors.
|
|
| 4. |
- Niklasson, Annika, 1977, et al.
(författare)
-
Air Pollutant Concentrations and Atmospheric Corrosion of Organ Pipes in European Church Environments
- 2008
-
Ingår i: Studies in Conservation. - 0039-3630 .- 2047-0584. ; 53:1, s. 24-40
-
Tidskriftsartikel (refereegranskat)abstract
- Abstract: The atmospheric environment inside and outside historical organs in several European regions is reported. In each region, comparisons were made between an instrument suffering organ pipe corrosion and an organ without corrosion problems. Concentrations of acetic acid (ethanoic acid), formic acid (methanoic acid), acetaldehyde (ethanal), formaldehyde (methanal) and other volatile organic compounds in the organ environment were determined using active sampling. Temperature and relative humidity were recorded. In addition, polished metal samples that mimic the material used in the historical organ pipes have been exposed in the organ wind systems for up to 22 months. High concentrations of acetic acid and formic acid vapours are present in the wind system of the corroded organs. Acetaldehyde and formaldehyde are also present in smaller amounts. The main source of acetic acid is the wood from which the wind system is built. In contrast, formic acid is generated in the chruch environment outside the wind system. The results show that the two organic acids play an important role in the atmospheric corrosion of organ pipes. It is suggested that the corrosion of lead pipes in historical organs can be effectively reduced by removing the sources of gaseous acetic acid and formic acid in the wind system and in the chruch environment.
|
|
