| 1. |
- Azad, A. K., et al.
(författare)
-
Crystallographic and Magnetic Properties of the Spinel-type Ferrites ZnxCo1-xFe2O4 (0.0
- 2015
-
Ingår i: AIP Conference Proceedings. - : AIP Publishing LLC. - 1551-7616 .- 0094-243X. - 9780735413047 ; 1660
-
Konferensbidrag (refereegranskat)abstract
- Ultrahigh frequencies (UHF) have applications in signal and power electronics to minimize product sizes, increase production quantity and lower manufacturing cost. In the UHF range of 300 MHz to 3 GHz, ferrimagnetic iron oxides (ferrites) are especially useful because they combine the properties of a magnetic material with that of an electrical insulator. Ferrites have much higher electrical resistivity than metallic ferromagnetic materials, resulting in minimization of the eddy current losses, and total penetration of the electromagnetic (EM) field. Hence ferrites are frequently applied as circuit elements, magnetic storage media like read/write heads, phase shifters and Faraday rotators. The electromagnetic properties of ferrites are affected by operating conditions such as field strength, temperature and frequency. The spinel system ZnxCo1-xFe2O4 (x= 0.0, 0.25, 0.50 and 0.75) has been prepared by the standard solid state sintering method. X-ray and neutron powder diffraction measurements were performed at room temperature. Neutron diffraction data analysis confirms the cubic symmetry corresponding to the space group Fd3m. The distribution of three cations Zn2+, Co2+ and Fe3+ over the spinel lattice and other crystallographic parameters like lattice constant, oxygen position parameter, overall temperature factor and occupancies of different ions in different lattice sites for the samples have been determined from the analysis of neutron diffraction data. The lattice constant increases with increasing Zn content in the system. The magnetic structure was found to be ferrimagnetic for the samples with x
|
|
| 2. |
- Hossain, S., et al.
(författare)
-
Highly dense and chemically stable proton conducting electrolyte sintered at 1200 °C
- 2018
-
Ingår i: International Journal of Hydrogen Energy. - : Elsevier BV. - 0360-3199. ; 43:2, s. 894-907
-
Tidskriftsartikel (refereegranskat)abstract
- The BaCe 0.7 Zr 0.1 Y 0.2−x Zn x O 3−δ (x = 0.05, 0.10, 0.15, 0.20) has been synthesized by the conventional solid state reaction method for application in protonic solid oxide fuel cell. The phase purity and lattice parameters of the materials have been studied by the room temperature X-ray diffraction (XRD). Scanning electron microscopy (SEM) has been done for check the morphology and grain growth of the samples. The chemical and mechanical stabilities have been done using thermogravimetric analysis (TGA) in pure CO 2 environment and thermomechanical analysis (TMA) in Argon atmosphere. The XRD of the materials show the orthorhombic crystal symmetry with Pbnm space group. The SEM images of the pellets show that the samples sintered at 1200 °C are highly dense. The XRD after TGA in CO 2 and thermal expansion measurements confirm the stability. The particles of the samples are in micrometer ranges and increasing Zn content decreases the size. The conductivity measurements have been done in 5% H 2 with Ar in dry and wet atmospheres. All the materials show high proton conductivity in the intermediate temperature range (400–700 °C). The maximum proton conductivity was found to be 1.0 × 10 −2 S cm −1 at 700 °C in wet atmosphere for x = 0.10. From our study, 10 wt % of Zn seems to be optimum at the B-site of the perovskite structure. All the properties studied here suggest it can be a promising candidate of electrolyte for IT-SOFCs.
|
|
| 3. |
- Zakaria, A.K.M., Asgar, M.A., Ahmed, F.U., Yunus, S.M., Azad, A.K., Paranjpe, S.K., Das, A.
(författare)
-
Studies of Mn0.5Cr0.5Fe2O4 ferrite by neutron diffraction at different temperatures in the range 768K ³ T ³ 13K
- 2002
-
Ingår i: Indian Journal of Pure & Applied Physics. ; 40, s. 46-53
-
Tidskriftsartikel (refereegranskat)
|
|
| 4. |
|
|
| 5. |
- Zakaria, A. K. M., et al.
(författare)
-
Synthesis, cation distribution and crystal structure of the spinel oxides MnGaxFe1-xCrO4 by neutron diffraction
- 2006
-
Ingår i: Physica. B, Condensed matter. - : Elsevier BV. - 0921-4526 .- 1873-2135. ; 385, s. 106-109
-
Tidskriftsartikel (refereegranskat)abstract
- The spinel system MnGaxFe1-xCrO4 (x = 0-0, 0.25, 0.50, 0.75 and 1.0) was prepared by the solid state sintering method in air at 1523 K. X-ray and neutron powder diffraction measurements were performed on the samples at 295 K for structural characterization. Rietveld refinement of the neutron diffraction data revealed that all the samples of the series possessed cubic symmetry corresponding to the space group Fd3m. The distributions of the four cations Mn, Ga, Fe and Cr over the two sublattices and other crystallographic parameters were found. The lattice constant showed a decrease with increasing Ga content in the system. The magnetic structure at room temperature was found to be ferrimagnetic in the composition range x <= 0.50.
|
|
| 6. |
- Abdalla, A. M., et al.
(författare)
-
Nanomaterials for solid oxide fuel cells: A review
- 2018
-
Ingår i: Renewable and Sustainable Energy Reviews. - : Elsevier BV. - 1879-0690 .- 1364-0321. ; 82, s. 353-368
-
Forskningsöversikt (refereegranskat)abstract
- Nanotechnology is utilized well in the development and improvement of the performance in Solid Oxide Fuel Cells (SOFCs). The high operating temperature of SOFCs (700–900 °C) has resulted in serious demerits regarding their overall performance and durability. Therefore, the operating temperature has been reduced to an intermediate temperature range of approximately 400–700 °C which improved performance and, subsequently, commercialized SOFCs as portable power sources. However, at reduced temperature, challenges such as an increase in internal resistance of the fuel cell components arise. Although, this may not be as serious as problems encountered at high temperature, it still significantly affects the performance of SOFCs. This review paper addresses the work of researchers in the application of nanotechnology in fabricating SOFCs through distinct methods. These methods have successfully omitted or at least reduced the internal resistance and showed considerable improvement in power density of the SOFCs at reduced temperatures.
|
|
| 7. |
- Afif, A., et al.
(författare)
-
Advanced materials and technologies for hybrid supercapacitors for energy storage – A review
- 2019
-
Ingår i: Journal of Energy Storage. - : Elsevier BV. - 2352-152X. ; 25:October 2019
-
Forskningsöversikt (refereegranskat)abstract
- Supercapacitors have become the most significant energy conversion and storage system in recent renewable and sustainable nanotechnology. Due to its large energy capacity and supply with relatively short time and longer lifetime, supercapacitors breakthrough in advance energy applications. This review presents a comparative study of different materials, working principles, analysis, applications, advantages and disadvantages of various technologies available for supercapacitors. The aim of this article is to discuss the possibility of hybrid supercapacitor for the next generation of energy technology. The development of composite materials containing a wide range of active constituents (e.g., graphene, activated carbon, transition metals, metal oxides, perovskites and conducting polymers) by in-situ hybridization and ex-situ recombination is also discussed. This review consecrated largely the contribution of combining all materials (electrode and electrolyte) and their synthesis process and electrochemical performance. Enduringly, the potential issues and the perspectives for future research based on hybrid supercapacitors in energy applications are also presented.
|
|
| 8. |
- Abdalla, A. M., et al.
(författare)
-
NdBaMn2O5+delta layered perovskite as an active cathode material for solid oxide fuel cells
- 2017
-
Ingår i: Ceramics International. - : Elsevier BV. - 0272-8842. ; 43:17, s. 15932-15938
-
Tidskriftsartikel (refereegranskat)abstract
- A layered perovskite, NdBaMn2O5+delta (NBMO), was synthesized by solid state reaction method in air. Rietveld analysis of X-Ray Diffraction (XRD) data showed the material crystallizing in orthorhombic symmetry (Pmmm space group). Scanning electron microscopy (SEM) was used to check the morphology and, the analysis of the micrographs exhibited a porous structure with in-situ growth of nanoparticles. Electrochemical Impedance Spectroscopy (EIS) measurements from 600 degrees C to 800 degrees C shows the highest conductivity value of 1.17 x 10(-1) S/cm obtained at 800 degrees C with low activation energy (Ea) of 0.3 eV in air. In 5% H-2/Ar gas mixture, the conductivity and activation energy values were 1.97 x 10(-2) S/cm and 0.4 eV, respectively at 800 degrees C. The DC conductivity measurements also showed that this material is highly conductive in air with a conductivity value of 0.75 S/cm at 850 degrees C. Dual chamber fuel cell measurements on Ni-YSZ/YSZ/NBMO cell using 5% H-2/Ar as fuel (from 700 degrees C to 800 degrees C) showed a maximum power density of 0.202 W/cm(2) at 800 degrees C. The relatively high conductivity of the material in air and low activation energy makes it a potential candidate as cathode for solid oxide fuel cells.
|
|
| 9. |
- Abdalla, Abdalla M., et al.
(författare)
-
Synthesis and characterization of Sm1-xZrxFe1-yMgyO3 (x, y = 0.5, 0.7, 0.9) as possible electrolytes for SOFCs
- 2018
-
Ingår i: Key Engineering Materials. - 1013-9826 .- 1662-9795. ; 765 KEM, s. 49-53
-
Konferensbidrag (refereegranskat)abstract
- The novel perovskite oxide series of Sm 1-x Zr x Fe 1-y Mg y O 3 (x,y = 0.5, 0.7, 0.9) were synthesized by solid state reaction method. X-ray diffraction (XRD), Rietveld refinement, scanning electron microscopy (SEM), electrochemical impedance spectroscopy (EIS) and conductivity analysis were carried out. XRD patterns of sintered materials revealed the shifted Bragg reflection to higher angle for the higher content of Zr and Mg. This is related to the ionic size of the dopant elements. Rietveld refinement showed that all compounds crystallized in cubic space group of Fm-3m. SEM images showed that the grains were well defined with highly dense surfaces makes it potential as an electrolyte material in solid oxide fuel cells (SOFCs) or gases sensors. Impedance spectroscopy at 550-800 °C shows that conductivity is higher at higher temperature. Sm 0.5 Zr 0.5 Fe 0.5 Mg 0.5 O 3 shows the highest conductivity of 5.451 × 10 -3 S cm -1 at 800 °C. It was observed that 50% molar ratio of Mg and Zr doping performed highest conductivity.
|
|
| 10. |
-
Adaptive Mobile Robotics : Proceedings Of The 15th International Conference On Climbing And Walking Robots And The Support Technologies For Mobile Machines, Baltimore, USA, 23–26 July 2012
- 2012
-
Proceedings (redaktörskap) (refereegranskat)abstract
- This book provides state-of-the-art scientific and engineering research findings and developments in the area of mobile robotics and associated support technologies. The book contains peer reviewed articles presented at the CLAWAR 2012 conference. Robots are no longer confined to industrial manufacturing environments. A great deal of interest is invested in the use of robots outside the factory environment. The CLAWAR conference series, established as a high profile international event, acts as a platform for dissemination of research and development findings and supports such a trend to address the current interest in mobile robotics to meet the needs of mankind in various sectors of the society. These include personal care, public health, services in the domestic, public and industrial environments. The editors of the book have extensive research experience and publications in the area of robotics in general and in mobile robotics specifically, and their experience is reflected in editing the contents of the book.
|
|
