| 1. |
- Benediktsdottir, Asdis, et al.
(författare)
-
Ambient noise tomography of Eyjafjallajokull volcano, Iceland
- 2017
-
Ingår i: Journal of Volcanology and Geothermal Research. - : Elsevier BV. - 0377-0273 .- 1872-6097. ; 347, s. 250-263
-
Tidskriftsartikel (refereegranskat)abstract
- We present a shear-velocity model for the Eyjafjallajokull stratovolcano, based on ambient seismic noise tomography applied to seven months of data from six permanent stations and -10 temporary seismic stations, deployed during and after the 2010 volcanic unrest. Vertical components of noise were cross correlated resulting in 30 robust phase-velocity dispersion curves between 1.6 and 6.5 s in period, displaying a +/- 20% variation in phase velocity beneath the volcano. The uneven distribution of noise sources, evaluated using signal-to-noise ratios, was estimated to cause less than 2% error in most curves. Sensitivity kernels showed resolution down to 10 km and the lateral resolution of the resulting phase-velocity maps was about 5 km. The model reveals east-west oriented high-velocity anomalies due east and west of the caldera. Between these a zone of lower velocity is identified, coinciding with the location of earthquakes that occurred during the summit eruption in April 2010. A shallow, southwest elongated low-velocity anomaly is located 5 km southwest of the caldera. The limited depth resolution of the shear-velocity model precludes detection of melt within the volcano.
|
|
| 2. |
- Benediktsdottir, Asdis, et al.
(författare)
-
Volcanic tremor of the 2010 Eyjafjallajökull eruption
- 2022
-
Ingår i: Geophysical Journal International. - : Oxford University Press. - 0956-540X .- 1365-246X. ; 228:2, s. 1015-1037
-
Tidskriftsartikel (refereegranskat)abstract
- Volcanic eruptions in Iceland generally start with an increase in tremor levels. These signals do not have clear onset, like many earthquakes. As the character of the tremor signal is variable from one volcano to another, locating the source of the tremor signal may require different techniques for different volcanoes. Continuous volcanic tremor varied considerably during the course of the Eyjafjallajökull summit eruption, 14 April to 22 May 2010, and was clearly associated with changes in eruptive style. The tremor frequencies ranged between 0.5 and 10 Hz, with increased vigour during an effusive and explosive phase, in comparison with purely explosive phases. Higher-frequency tremor bursts early in the eruption were caused by processes at the eruption site. Location of the tremor using a method based on differential phase information extracted from interstation correlograms showed the tremor to be stable near the eruption vent, through time, for signals between 0.5 and 2 Hz. Analyses of power variations of the vertical component of the tremor with distance from the eruption site are consistent with tremor waveform content being dominated by surface waves in the 0.5–2 Hz frequency range. The tremor source depth was argued to be shallow, less than about 1 km. The attenuation quality factor (Q) was found to be on the order of Q = 10–20 for paths in the area around Eyjafjallajökull and Q = 20–50 for paths outside the volcano. The pattern of radiated wave energy from the tremor source varied with time, defining ten different epochs during the eruption. Thus the tremor-source radiation did not remain isotropic, which needs to be considered when locating tremor based on amplitude, that is azimuthally variable source radiation.
|
|
