| 1. |
- Ali, Sharafat, 1976-, et al.
(författare)
-
A cubic calcium oxynitrido-silicate, Ca2.89Si2N1.76O4.24
- 2011
-
Ingår i: Acta Crystallographica Section E. - 1600-5368. ; 67
-
Tidskriftsartikel (refereegranskat)abstract
- The title compound, tricalcium oxynitride silicate, withcomposition Ca3-xSi2N2-2xO4+2x (x ’ 0.12), is a perovskiterelatedcalcium oxynitrido silicate containing isolated oxynitridosilicate 12-rings. The N atoms are statistically disorderedwith O atoms (occupancy ratio N:O = 0.88:0.12) and occupythe bridging positions in the 12 ring oxynitrido silicate anion,while the remaining O atoms are located at the terminalpositions of the Si(O,N)4 tetrahedra. The majority of the Ca2+cations fill the channels along [100] in the packing of the 12-ring anions. The rest of these cations are located at severalpositions, with partial occupancy, in channels along the bodydiagonals.
|
|
| 2. |
- Berastegui, Pedro, et al.
(författare)
-
Electrochemical reactions of AgFeO2 as negative electrode in Li- and Na-ion batteries
- 2018
-
Ingår i: Journal of Power Sources. - : Elsevier. - 0378-7753 .- 1873-2755. ; 401, s. 386-396
-
Tidskriftsartikel (refereegranskat)abstract
- AgFeO2 nanoparticles synthesized via precipitation at room temperature are investigated in Li- and Na-ion cells through electrode coatings with an alginate binder. The electrochemical reactions of AgFeO2 with Li+ and Na+ions, as well as its role as alternative negative electrode in these cell systems are carefully evaluated. Initial Li uptake causes irreversible amorphization of the AgFeO2 structure with concomitant formation of Ag0 nanoparticles. Further Li incorporation results in conversion into Fe0 nanoparticles and Li2O, together with Li-alloying of these Ag0 clusters. Similar mechanisms are also found upon Na uptake, although such processes are hindered by overpotentials, the capacity and reversibility of the reactions with Na+ ions being not comparablewith those of their Li+ counterparts. The behaviour of AgFeO2 at low potentials vs. Li+/Li displays a synergic pseudo-capacitive charge storage overlapping Li-Ag alloying/de-alloying. This feature is exploited in full cells having deeply lithiated AgFeO2 and LiFePO4 as negative and positive electrodes, respectively. These environmentally friendly iron-based full cells exhibit attractive cycle performances with ≈80% capacity retention after 1000 cycles without any electrolyte additive, average round trip efficiency of ≈89% and operational voltage of 3.0 V combined with built-in pseudo-capacitive characteristics that enable high cycling rates up to≈25C.
|
|
| 3. |
- Berastegui, Pedro, et al.
(författare)
-
Magnetron Sputtering of Nanolaminated Cr2AlB2
- 2020
-
Ingår i: Coatings. - : MDPI. - 2079-6412. ; 10:8
-
Tidskriftsartikel (refereegranskat)abstract
- A ternary Cr(2)AlB(2)phase was deposited as a film using magnetron sputtering. Its anisotropic structure displays both structural and chemical similarities with the nanolaminated MAX phases (M(n+1)AX(n)(n = 1-3) where M usually is an early transition metal, A is typically an element in group 13-14 and X is C or N), and can be described as CrB slabs separated by layers of Al. Combinatorial sputtering was used to optimise the sputtering process parameters for films with the Cr(2)AlB(2)composition. The influences of substrate, temperature and composition were studied using X-ray diffraction, X-ray photoelectron spectroscopy and electron microscopy. Films deposited at room temperature were X-ray amorphous but crystalline films could be deposited on MgO substrates at 680 degrees C using a composite Al-B, Cr and Al targets. X-ray diffraction analyses showed that the phase composition and texture of the films was strongly dependent on the chemical composition. Films with several phases or with a single Cr(2)AlB(2)phase could be deposited, but an additional Al target was required to compensate for a loss of Al at the high deposition temperatures used in this study. The microstructure evolution during film growth was strongly dependent on composition, with a change in texture in Al-rich films from a preferred [010] orientation to a [100]/[001] orientation. A model based on Al desorption from the surface of the growing grains is proposed to explain the texture variations.
|
|
| 4. |
- Braceras, Inigo, et al.
(författare)
-
On the electro-tribological properties and degradation resistance of silver-aluminum coatings
- 2018
-
Ingår i: Wear. - : ELSEVIER SCIENCE SA. - 0043-1648 .- 1873-2577. ; 414, s. 202-211
-
Tidskriftsartikel (refereegranskat)abstract
- Contact materials in sliding electrical applications must possess low electrical contact resistance, low friction and wear coefficients, and high degradation resistance to the surrounding media. Silver coatings are commonly used in such applications despite their shortcomings. This work has focused on the study of alternative silver-aluminum coatings deposited by PVD. The main findings include the strong dependence of the tribological performance on the concentration of Al and hence the phases present in the coatings. Besides, the wear mechanism was found to be affected by the working media, either on air or insulating oil. Results have shown that for full HCP phase coatings (Ag67Al33), wear rates are lowest, with no adhesive wear and good surface sulphidation resistance, though with some proclivity to oxidation, coupled with a moderate increase in the electrical contact resistance.
|
|
| 5. |
- Cedervall, Johan, et al.
(författare)
-
Phase stability and structural transitions in compositionally complex LnMO 3 perovskites
- 2021
-
Ingår i: Journal of Solid State Chemistry. - : Elsevier BV. - 0022-4596 .- 1095-726X. ; 300
-
Tidskriftsartikel (refereegranskat)abstract
- Entropy stabilised materials have possibilities for tailoring functionalities to overcome challenges in materials science. The concept of configurational entropy can also be applied to metal oxides, but it is unclear whether these could be considered as solid solutions in the case of perovskite-structured oxides and if the configurational entropy plays a stabilising role. In this study, compositionally complex perovskite oxides, LnMO3 (Ln = La, Nd, Sm, Ca and Sr, M = Ti, Cr, Mn, Fe, Co, Ni, and Cu), are investigated for their phase stability and magnetic behaviour. Phase-pure samples were synthesised, and the room temperature structures were found to crystallise in either Pnma or R3¯c space groups, depending on the composition and the resulting tolerance factor, while the structural transition temperatures correlate with the pseudo cubic unit cell volume. The techniques used included diffraction with X-rays and neutrons, both ex- and in-situ, X-ray photoelectron spectroscopy, magnetometry as well as electron microscopy. Neutron diffraction studies on one sample reveal that no oxygen vacancies are found in the structure and that the magnetic properties are ferrimagnetic-like with magnetic moments mainly coupled antiferromagnetically along the crystallographic c-direction. X-ray photoelectron spectroscopy gave indications of the oxidation states of the constituting ions where several mixed oxidation states are observed in these valence-compensated perovskites.
|
|
| 6. |
- Fang, Hailiang, et al.
(författare)
-
Insights into formation and stability of tau-MnAlZ(x) (Z = C and B)
- 2017
-
Ingår i: Journal of Alloys and Compounds. - : Elsevier BV. - 0925-8388 .- 1873-4669. ; 692, s. 198-203
-
Tidskriftsartikel (refereegranskat)abstract
- The tau-phase MnAl alloys are promising candidate for rare earth free permanent magnets. In this study, In order to better understand the MnAl epsilon ->tau phase transition mechanism in a continuous cooling process and metastable MnAl tau-phase high temperature stability, Mn0.54Al0.46, Mn0.55Al0.45C0.02 and Mn0.55Al0.45B0.02 alloys were systematically studied by in situ synchrotron X-ray powder diffraction (SR-XRD). The relationship between tau-phase formation tendency and different cooling rates of Mn0.55Al0.45C0.02 was investigated. Besides, the high temperature stabilities of undoped tau-MnAl and carbon/boron doped tau-MnAl were studied. Differential thermal analysis (DTA) was also employed to study the phase transformation as well. The research results show that a high cooling rate of 600 degrees C/min leads to a 50/50 wt% mixture of epsilon- and tau-phase; almost pure tau-phase was obtained when cooled at a moderate cooling rate of 10 degrees C/min; while for a slow cooling rate of 2 degrees C/min, the tau-phase partially decomposed into beta and gamma(2) phases. No intermediate epsilon'-phase was observed during the epsilon ->tau phase transition during the experiments. For the boron and carbon doped tau-MnAl, the 800 degrees C high temperature stability experiments reveal that C stabilizes the tau-MnAl while doped B destabilises the tetragonal structure and it decomposes into beta- and gamma(2)-phases.
|
|
| 7. |
|
|
| 8. |
- Grippa, Alexander, 1977-
(författare)
-
Structural investigation of Nb-based layer sulfides
- 2004
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- In this work we have investigated the intercalation of electron-donors between NbS2 slabs in Nb-based layer sulfides.Two series of Sr substituted Nb-based misfit sulfides belonging to the 1.5Q/1H and 1Q/1H series of misfit layer compounds have been synthesised. For large lanthanides (Ln=La, Ce), only the 1Q/1H compounds formed whereas for smaller lanthanides and yttrium, both types of phases can be obtained. The crystal structure of misfit sulfide (Pr0.55Sr0.45S)1.15NbS2 has been refined using the composite approach. In the Q-slab, Pr-atoms are partly replaced by Sr with a random distribution over one cation position. The crystal structure of misfit sulfide [(Sm1/3Sr2/3S)1.5]1.15NbS2 belonging to the 1.5Q/1H series have also been determined. The obtained results suggest a preferred occupancy of the cation positions in the slab where Sr atoms mainly occupy positions on the exterior of the slab while Sm atoms are in the center of the slab. The (La1-xSrxS)1.15NbS2 solid solution (0.1An attempt to synthesize SrxNbS2 (0.1≤x≤0.5) intercalates was made but single phases were not obtained and increasing the temperature from 1000оС to 1100оС leads to the decomposition of these intercalates. Single crystals of Sr0.22Nb1.05S2 and Sr0.23NbS2 were found and their structures were determined. The structures belong to two different types of packings with statistical distribution of Sr between layers.A new superconducting sulfide, "EuNb2S5", was investigated by ED and HREM and its structure model consisting of Nb7S14 and (Eu3S4)2 slabs alternating along the c-axis is suggested. An attempt to suggest a model for the structure of "SrNb2S5" by means of X-ray single crystal diffraction was made. The proposed structure consists of two types of slabs: a Nb7S14 and a [Sr6(NbS4)2S] slab with niobium in tetrahedral coordination. It is shown that "SrNb2S5" and "EuNb2S5" are have similar structures.For the first time, single crystals of the complex sulfide BaNb0.9S3 have also been studied by means of X-ray single crystal diffraction. The single crystal refinement and EDX analysis showed the existence of cation vacancies at the niobium position. BaNb0.9S3 has also been studied by ED and no superstructure was found which implies that and the vacancies are statistically distributed.No improvement of the magnetic properties of the studied compounds was observed in comparison to NbS2.
|
|
| 9. |
- Hedin, Allan, et al.
(författare)
-
Corrosion of copper in pure O2-free water?
- 2018
-
Ingår i: Corrosion Science. - : Elsevier BV. - 0010-938X .- 1879-0496. ; 137, s. 1-12
-
Tidskriftsartikel (refereegranskat)abstract
- Copper exposed to pure, O-2-free water for several months in glass- and metal-contained, well-controlled systems shows no evidence of corrosion, either through hydrogen evolution or through the occurrence of oxidized copper. The results contradict the interpretation of recent experiments where it has been claimed that copper corrodes in pure, O-2-free water far above the very limited extent predicted by established thermodynamic data. Reasons for the different experimental outcomes are discussed. Experimental and theoretical efforts to identify hitherto unknown, potentially corrosion driving species of the Cu-O-H system and studies of copper/water surface reactions are reviewed as background for the present study.
|
|
| 10. |
|
|
