1. |
- Thottappillil, Rajeev, et al.
(författare)
-
Response of Civilian Facilities to Intentional Electromagnetic Interference (IEMI), with Emphasis on the Swedish Railway Network
- 2005
-
Konferensbidrag (refereegranskat)abstract
- Recently a research program was initiated in Sweden to investigate the possible susceptibility of IEMI to civilian networks, with emphasis on the Swedish railway network. The objective is to develop a methodology for investigating and protecting sensitive railway facilities against IEMI and to recommend ways in which EMI control in the railways could be improved for better defense against IEMI. Details of the research program and some preliminary results are presented in this paper.
|
|
2. |
|
|
3. |
|
|
4. |
- Jia, Kelin, et al.
(författare)
-
Modelling an AC motor with high accuracy in a wide frequency range
- 2013
-
Ingår i: IET Electric Power Applications. - : Institution of Engineering and Technology (IET). - 1751-8660 .- 1751-8679. ; 7:2, s. 116-122
-
Tidskriftsartikel (refereegranskat)abstract
- This study presents a practical method to construct a high-frequency equivalent circuit model for AC motors in Spice-like simulation software. This model can be used to analyse the characteristics of the motor and predict the conducted electromagnetic noise in an adjustable speed drive system. The modelling is based on measured data of the impedance and vector fitting technique. The procedure of the modelling is elaborated in this study and verified by comparing simulated data with experimental data on a 200 kW induction motor in the frequency range from 10 kHz to 10 MHz. This modelling method can be extended to model other types of motors irrespective of the power rating of the motors. Applications of the motor modelling to study common mode voltage in the system and current oscillation in motor winding are presented.
|
|
5. |
|
|
6. |
- Velander, Erik, et al.
(författare)
-
An Ultralow Loss Inductorless dv/dt Filter Concept for Medium-Power Voltage Source Motor Drive Converters With SiC Devices
- 2018
-
Ingår i: IEEE transactions on power electronics. - : IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC. - 0885-8993 .- 1941-0107. ; 33:7, s. 6072-6081
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, a novel dv/dt filter is presented targeted for 100-kW to 1-MW voltage source converters using silicon carbide (SiC) power devices. This concept uses the stray inductance between the power device and the converter output as a filter component in combination with an additional small RC-link. Hence, a lossy, bulky, and costly filter inductor is avoided and the resulting output dv/dt is limited to 5-10 kV/mu s independent of the output current and switching speed of the SiC devices. As a consequence, loads with dv/dt constraints, e.g., motor drives can be fed from SiC devices enabling full utilization of their high switching speed. Moreover, a filter-model is proposed for the selection of filter component values for a certain dv/dt requirement. Finally, results are shown using a 300-A 1700-V SiC metal-oxide-semiconductor field-effect transistor (MOSFET). These results show that the converter output dv/dt can be limited to 7.5 kV/mu s even though values up to 47 kV/mu s weremeasured across the SiC MOSFET module. Hence, the total switching losses, including the filter losses, are verified to be three times lower compared to when the MOSFET dv/dt was slowed down by adjusting the gate driver.
|
|