| 1. |
- Giardino, Claudia, et al.
(författare)
-
Assessment of water quality in Lake Garda (Italy) using Hyperion
- 2007
-
Ingår i: Remote Sensing of Environment. - : Elsevier BV. - 0034-4257 .- 1879-0704. ; 109:2, s. 183-195
-
Tidskriftsartikel (refereegranskat)abstract
- For testing the integration of the remote sensing related technologies into the water quality monitoring programs of Lake Garda (the largest Italian lake), the spatial and spectral resolutions of Hyperion and the capability of physics-based approaches were considered highly suitable. Hyperion data were acquired on 22nd July 2003 and water quality was assessed (i) defining a bio-optical model, (ii) converting the Hyperion atsensor radiances into subsurface irradiance reflectances, and (iii) adopting a bio-optical model inversion technique. The bio-optical model was parameterised using specific inherent optical properties of the lake and light field variables derived from a radiative transfer numerical model. A MODTRAN-based atmospheric correction code, complemented with an air/water interface correction was used to convert Hyperion at-sensor radiances into subsurface irradiance reflectance values. These reflectance values were comparable to in situ reflectance spectra measured during the Hyperion overpass, except at longer wavelengths (beyond 700 nm), where reflectance values were contaminated by severe atmospheric adjacency effects. Chlorophyll-a and tripton concentrations were retrieved by inverting two Hyperion bands selected using a sensitivity analysis applied to the bio-optical model. The sensitivity analysis indicated that the assessment of coloured dissolved organic matter was not achievable in this study due to the limited coloured dissolved organic matter concentration range of the lake, resulting in reflectance differences below the environmental measurement noise of Hyperion. The chlorophyll-a and tripton image-products were compared to in situ data collected during the Hyperion overpass, both by traditional sampling techniques (8 points) and by continuous flow-through systems (32 km). For chlorophyll-a the correlation coefficient between in situ point stations and Hyperion-inferred concentrations was 0.77 (data range from 1.30 to 2.16 mg m(-3)). The Hyperion-derived chlorophyll-a concentrations also match most of the flow-through transect data. For tripton, the validation was constrained by variable re-suspension phenomena. The correlation coefficient between in situ point stations and Hyperion-derived concentrations increased from 0.48 to 0.75 (data range from 0.95 to 2.13 g m(-3)) if the sampling data from the re-suspension zone was avoided. The comparison of Hyperionderived tripton concentrations and flow-through transect data exhibited a similar mismatch. The results of this research suggest further studies to address compatibilities of validation methods for water body features with a high rate of change, and to reduce the contamination by atmospheric adjacency effects on Hyperion data at longer wavelengths in Alpine environment. The transferability of the presented method to other sensors and the ability to assess water quality independent from in situ water quality data, suggest that management relevant applications for Lake Garda (and other subalpine lakes) could be supported by remote sensing.
|
|
| 2. |
- Pellegrino, Andrea, et al.
(författare)
-
Assessing the Accuracy of PRISMA Standard Reflectance Products in Globally Distributed Aquatic Sites
- 2023
-
Ingår i: Remote Sensing. - 2072-4292. ; 15:8
-
Tidskriftsartikel (refereegranskat)abstract
- PRISMA is the Italian Space Agency’s first proof-of-concept hyperspectral mission launched in March 2019. The present work aims to evaluate the accuracy of PRISMA’s standard Level 2d (L2d) products in visible and near-infrared (NIR) spectral regions over water bodies. For this assessment, an analytical comparison was performed with in situ water reflectance available through the ocean color component of the Aerosol Robotic Network (AERONET-OC). In total, 109 cloud-free images over 20 inland and coastal water sites worldwide were available for the match-up analysis, covering a period of three years. The quality of L2d products was further evaluated as a function of ancillary parameters, such as the trophic state of the water, aerosol optical depth (AOD), observation and illumination geometry, and the distance from the coastline (DC). The results showed significant levels of uncertainty in the L2d reflectance products, with median symmetric accuracies (MdSA) varying from 33% in the green to more than 100% in the blue and NIR bands, with higher median uncertainties in oligotrophic waters (MdSA of 85% for the entire spectral range) than in meso-eutrophic (MdSA of 46%) where spectral shapes were retained adequately. Slight variations in the statistical agreement were then noted depending on AOD values, observation and illumination geometry, and DC. Overall, the results indicate that water-specific atmospheric correction algorithms should be developed and tested to fully exploit PRISMA data as a precursor for future operational hyperspectral missions as the standard L2d products are mostly intended for terrestrial applications.
|
|
| 3. |
- Sathyendranath, Shubha, et al.
(författare)
-
An Ocean-Colour Time Series for Use in Climate Studies : The Experience of the Ocean-Colour Climate Change Initiative (OC-CCI)
- 2019
-
Ingår i: Sensors. - : MDPI AG. - 1424-8220. ; 19:19
-
Tidskriftsartikel (refereegranskat)abstract
- Ocean colour is recognised as an Essential Climate Variable (ECV) by the Global Climate Observing System (GCOS); and spectrally-resolved water-leaving radiances (or remote-sensing reflectances) in the visible domain, and chlorophyll-a concentration are identified as required ECV products. Time series of the products at the global scale and at high spatial resolution, derived from ocean-colour data, are key to studying the dynamics of phytoplankton at seasonal and inter-annual scales; their role in marine biogeochemistry; the global carbon cycle; the modulation of how phytoplankton distribute solar-induced heat in the upper layers of the ocean; and the response of the marine ecosystem to climate variability and change. However, generating a long time series of these products from ocean-colour data is not a trivial task: algorithms that are best suited for climate studies have to be selected from a number that are available for atmospheric correction of the satellite signal and for retrieval of chlorophyll-a concentration; since satellites have a finite life span, data from multiple sensors have to be merged to create a single time series, and any uncorrected inter-sensor biases could introduce artefacts in the series, e.g., different sensors monitor radiances at different wavebands such that producing a consistent time series of reflectances is not straightforward. Another requirement is that the products have to be validated against in situ observations. Furthermore, the uncertainties in the products have to be quantified, ideally on a pixel-by-pixel basis, to facilitate applications and interpretations that are consistent with the quality of the data. This paper outlines an approach that was adopted for generating an ocean-colour time series for climate studies, using data from the MERIS (MEdium spectral Resolution Imaging Spectrometer) sensor of the European Space Agency; the SeaWiFS (Sea-viewing Wide-Field-of-view Sensor) and MODIS-Aqua (Moderate-resolution Imaging Spectroradiometer-Aqua) sensors from the National Aeronautics and Space Administration (USA); and VIIRS (Visible and Infrared Imaging Radiometer Suite) from the National Oceanic and Atmospheric Administration (USA). The time series now covers the period from late 1997 to end of 2018. To ensure that the products meet, as well as possible, the requirements of the user community, marine-ecosystem modellers, and remote-sensing scientists were consulted at the outset on their immediate and longer-term requirements as well as on their expectations of ocean-colour data for use in climate research. Taking the user requirements into account, a series of objective criteria were established, against which available algorithms for processing ocean-colour data were evaluated and ranked. The algorithms that performed best with respect to the climate user requirements were selected to process data from the satellite sensors. Remote-sensing reflectance data from MODIS-Aqua, MERIS, and VIIRS were band-shifted to match the wavebands of SeaWiFS. Overlapping data were used to correct for mean biases between sensors at every pixel. The remote-sensing reflectance data derived from the sensors were merged, and the selected in-water algorithm was applied to the merged data to generate maps of chlorophyll concentration, inherent optical properties at SeaWiFS wavelengths, and the diffuse attenuation coefficient at 490 nm. The merged products were validated against in situ observations. The uncertainties established on the basis of comparisons with in situ data were combined with an optical classification of the remote-sensing reflectance data using a fuzzy-logic approach, and were used to generate uncertainties (root mean square difference and bias) for each product at each pixel.
|
|
| 4. |
- Valente, Andre, et al.
(författare)
-
A compilation of global bio-optical in situ data for ocean-colour satellite applications
- 2016
-
Ingår i: Earth System Science Data. - : Copernicus GmbH. - 1866-3508 .- 1866-3516. ; 8:1, s. 235-252
-
Tidskriftsartikel (refereegranskat)abstract
- A compiled set of in situ data is important to evaluate the quality of ocean-colour satellite-data records. Here we describe the data compiled for the validation of the ocean-colour products from the ESA Ocean Colour Climate Change Initiative (OC-CCI). The data were acquired from several sources (MOBY, BOUSSOLE, AERONET-OC, SeaBASS, NOMAD, MERMAID, AMT, ICES, HOT, GeP&CO), span between 1997 and 2012, and have a global distribution. Observations of the following variables were compiled: spectral remote-sensing reflectances, concentrations of chlorophyll a, spectral inherent optical properties and spectral diffuse attenuation coefficients. The data were from multi-project archives acquired via the open internet services or from individual projects, acquired directly from data providers. Methodologies were implemented for homogenisation, quality control and merging of all data. No changes were made to the original data, other than averaging of observations that were close in time and space, elimination of some points after quality control and conversion to a standard format. The final result is a merged table designed for validation of satellite-derived ocean-colour products and available in text format. Metadata of each in situ measurement (original source, cruise or experiment, principal investigator) were preserved throughout the work and made available in the final table. Using all the data in a validation exercise increases the number of matchups and enhances the representativeness of different marine regimes. By making available the metadata, it is also possible to analyse each set of data separately. The compiled data are available at doi: 10.1594/PANGAEA.854832 (Valente et al., 2015).
|
|
| 5. |
- Valente, André, et al.
(författare)
-
A compilation of global bio-optical in situ data for ocean-colour satellite applications - version two
- 2019
-
Ingår i: Earth System Science Data. - : Copernicus GmbH. - 1866-3508 .- 1866-3516. ; 11:3, s. 1037-1068
-
Tidskriftsartikel (refereegranskat)abstract
- A global compilation of in situ data is useful to evaluate the quality of ocean-colour satellite data records. Here we describe the data compiled for the validation of the ocean-colour products from the ESA Ocean Colour Climate Change Initiative (OC-CCI). The data were acquired from several sources (including, inter alia, MOBY, BOUSSOLE, AERONET-OC, SeaBASS, NOMAD, MERMAID, AMT, ICES, HOT and GeP&CO) and span the period from 1997 to 2018. Observations of the following variables were compiled: spectral remote-sensing reflectances, concentrations of chlorophyll a, spectral inherent optical properties, spectral diffuse attenuation coefficients and total suspended matter. The data were from multi-project archives acquired via open internet services or from individual projects, acquired directly from data providers. Methodologies were implemented for homogenization, quality control and merging of all data. No changes were made to the original data, other than averaging of observations that were close in time and space, elimination of some points after quality control and conversion to a standard format. The final result is a merged table designed for validation of satellite-derived ocean-colour products and available in text format. Metadata of each in situ measurement (original source, cruise or experiment, principal investigator) was propagated throughout the work and made available in the final table. By making the metadata available, provenance is better documented, and it is also possible to analyse each set of data separately. This paper also describes the changes that were made to the compilation in relation to the previous version (Valente et al., 2016). The compiled data are available at https://doi.org/10.1594/PANGAEA.898188 (Valente et al., 2019).
|
|
