| 1. |
- Merte, Lindsay R., et al.
(författare)
-
Oxygen Storage by Tin Oxide Monolayers on Pt3Sn(111)
- 2023
-
Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 127:6, s. 2988-2994
-
Tidskriftsartikel (refereegranskat)abstract
- The high performance of platinum–tin catalysts for oxidation reactions has been linked to the formation of tin oxides at the metal surface, but little is known about the structure of these oxides or the chemical behavior that determines their catalytic properties. We show here how surface oxides on Pt3Sn(111) incorporate oxygen at the metal interface, which may be subsequently removed by reaction with CO. The storage mechanism, where oxygen uptake occurs without loss of interfacial Pt–Sn bonds, is enabled by the peculiar asymmetrical coordination state of Sn2+. O atoms are bound at pocket sites in the 2D oxide sheet between these outward-buckled Sn atoms and metallic Sn in the alloy surface below.
|
|
| 2. |
- Wallander, Harald J., et al.
(författare)
-
Dynamic Behavior of Tin at Platinum Surfaces during Catalytic CO Oxidation
- 2023
-
Ingår i: ACS Catalysis. - : American Chemical Society (ACS). - 2155-5435. ; 13:24, s. 16158-16167
-
Tidskriftsartikel (refereegranskat)abstract
- Platinum-tin surfaces are active for CO oxidation, but their activity and the effects of tin oxide phases that form under reaction conditions are poorly understood. We have studied surface alloys of tin prepared on platinum single crystals during catalytic CO oxidation using near-ambient-pressure X-ray photoemission spectroscopy. On the flat terraces of Sn/Pt(111), a wetting layer of Sn(II) surface oxide forms, while on the stepped Sn/Pt(223) surface, 3D clusters of Sn(IV) oxide are formed. Oxidation of tin by O2 competes with the reduction of the oxides by CO under reaction conditions. Oxides that do not completely cover the surface can be reduced to metallic tin, while a fully covering layer of Sn(II) oxide cannot, showing the importance of oxide edge sites for the reduction process. The samples where 2D oxide layers are formed show a higher CO oxidation activity than for pure platinum at low temperatures, while the Sn(IV) oxide clusters on the stepped surfaces do not affect the measured CO oxidation rate. We therefore identify 2D Sn(II) oxide as an active phase for CO oxidation. While oxide island edges appear to make only minor contributions to conversion under these conditions, reactions at these sites play a major role in determining the phases present and their transformations.
|
|
