| 1. |
|
|
| 2. |
- Lyngfelt, Anders, 1955, et al.
(författare)
-
11,000 h of chemical-looping combustion operation—Where are we and where do we want to go?
- 2019
-
Ingår i: International Journal of Greenhouse Gas Control. - : Elsevier BV. - 1750-5836. ; 88, s. 38-56
-
Forskningsöversikt (refereegranskat)abstract
- A key for chemical-looping combustion (CLC) is the oxygen carrier. The ultimate test is obviously the actual operation, which reveals if it turns to dust, agglomerates or loses its reactivity or oxygen carrier capacity. The CLC process has been operated in 46 smaller chemical-looping combustors, for a total of more than 11,000 h. The operation involves both manufactured oxygen carriers, with 70% of the total time of operation, and less costly materials, i.e. natural ores or waste materials. Among manufactured materials, the most popular materials are based on NiO with 29% of the operational time, Fe2O3 with 16% and CuO with 13%. Among the monometallic oxides there are also Mn3O4 with 1%, and CoO with 2%. The manufactured materials also include a number of combined oxides with 11% of operation, mostly calcium manganites and other combined manganese oxides. Finally, the natural ores and waste materials include ilmenite, FeTiO3 with 13%, iron ore/waste with 9% and manganese ore with 6%. In the last years a shift towards more focus on CuO, combined oxides and natural ores has been seen. The operational experience shows a large variation in performance depending on pilot design, operational conditions, solids inventory, oxygen carrier and fuel. However, there is at present no experience of the process at commercial or semi-commercial scale, although oxygen-carrier materials have been successfully used in commercial fluidized-bed boilers for Oxygen-Carrier Aided Combustion (OCAC) during more than 12,000 h of operation. The paper discusses strategies for upscaling as well as the use of biomass for negative emissions. A key question is how scaling-up will affect the performance, which again will determine the costs for purification of CO2 through e.g. oxy-polishing. Unfortunately, the conditions in the small-scale pilots do not allow for any safe conclusions with respect to performance in full scale. Nevertheless, the experiences from pilot operation shows that the process works and can be expected to work in the large scale and gives important information, for instance on the usefulness of various oxygen-carriers. Because further research is not likely to improve our understanding of the performance that can be achieved in full scale, there is little sense in waiting with the scale-up. A major difficulty with the scaling-up of a novel process is in the risk. First-of-its-kind large-scale projects include risks of technical mistakes and unforeseen obstacles, leading to added costs or, in the worst case, failure. One way of addressing these risks is to focus on the heart of the process and build it with maximum flexibility for future use. A concept for maximum flexibility is the Multipurpose Dual Fluidized Bed (MDFB). Another is to find a suitable existing plant, e.g. a dual fluidized-bed thermal gasifier. With present emissions the global CO2 budget associated with a maximum temperature of 2 °C may be spent in around 20–25 years, whereas the CO2 budget for 1.5 °C is may be exhausted in 10 years. Thus, the need for both CO2 neutral fuels and negative emissions will become increasingly urgent as we are nearing or transgressing the maximum amount of CO2 that can be emitted without compromising the global climate agreement in Paris saying we must keep “well below” 2 °C and aim for a maximum of 1.5 °C. Thus, biomass may turn out to be a key fuel for Carbon Capture and Storage (CCS), because CO2-free power does not necessarily need CCS, but negative emissions will definitely need Bio-CCS.
|
|
| 3. |
- Mellhammar, Lisa, et al.
(författare)
-
Sepsis - vår tids okända folksjukdom
- 2015
-
Ingår i: Läkartidningen. - 0023-7205 .- 1652-7518. ; 112:47
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)
|
|
| 4. |
- Rydén, Magnus, 1975, et al.
(författare)
-
Negative CO2 Emissions with Chemical-Looping Combustion of Biomass - A Nordic Energy Research Flagship Project
- 2017
-
Ingår i: Energy Procedia. - : Elsevier BV. - 1876-6102. ; 114, s. 6074-6082
-
Konferensbidrag (refereegranskat)abstract
- The Nordic countries constitute a natural location for the development and deployment of Bio-Energy with Carbon Capture and Storage (BECCS). Finland, Sweden and Denmark are world-leading with respect to heat and power generation from sustainable biomass. Norway is world-leading with respect to Carbon Capture and Storage (CCS). The Nordic countries also have ambitious targets for reductions of their CO2 emissions, host leading technology providers, and have large biomass potential per capita. System studies suggest that bioenergy could be the single largest energy carrier in the Nordic countries by 2050. Negative CO2 Emissions with Chemical Looping Combustion of Biomass is a multi-partner project with the goal to develop new technology that: i) enables CO2 capture and negative CO2 emissions at the lowest possible cost, ii) is able to produce power and steam for industrial and other applications, iii) utilizes Nordic expertise in fluidized bed technology and iv) has potential to achieve improved fuel utilization. The technology capable of achieving these goals is Chemical-Looping Combustion of biomass (Bio-CLC). The article presents the project and features some early results from its implementation.
|
|
| 5. |
- Aamodt, K., et al.
(författare)
-
Alignment of the ALICE Inner Tracking System with cosmic-ray tracks
- 2010
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 5
-
Konferensbidrag (refereegranskat)abstract
- ALICE (A Large Ion Collider Experiment) is the LHC (Large Hadron Collider) experiment devoted to investigating the strongly interacting matter created in nucleus-nucleus collisions at the LHC energies. The ALICE ITS, Inner Tracking System, consists of six cylindrical layers of silicon detectors with three different technologies; in the outward direction: two layers of pixel detectors, two layers each of drift, and strip detectors. The number of parameters to be determined in the spatial alignment of the 2198 sensor modules of the ITS is about 13,000. The target alignment precision is well below 10 mu m in some cases (pixels). The sources of alignment information include survey measurements, and the reconstructed tracks from cosmic rays and from proton-proton collisions. The main track-based alignment method uses the Millepede global approach. An iterative local method was developed and used as well. We present the results obtained for the ITS alignment using about 10(5) charged tracks from cosmic rays that have been collected during summer 2008, with the ALICE solenoidal magnet switched off.
|
|
| 6. |
- Aamodt, K., et al.
(författare)
-
First proton-proton collisions at the LHC as observed with the ALICE detector: measurement of the charged-particle pseudorapidity density at root s=900 GeV
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 65:1-2, s. 111-125
-
Tidskriftsartikel (refereegranskat)abstract
- On 23rd November 2009, during the early commissioning of the CERN Large Hadron Collider (LHC), two counter-rotating proton bunches were circulated for the first time concurrently in the machine, at the LHC injection energy of 450 GeV per beam. Although the proton intensity was very low, with only one pilot bunch per beam, and no systematic attempt was made to optimize the collision optics, all LHC experiments reported a number of collision candidates. In the ALICE experiment, the collision region was centred very well in both the longitudinal and transverse directions and 284 events were recorded in coincidence with the two passing proton bunches. The events were immediately reconstructed and analyzed both online and offline. We have used these events to measure the pseudorapidity density of charged primary particles in the central region. In the range vertical bar eta vertical bar < 0.5, we obtain dN(ch)/d eta = 3.10 +/- 0.13(stat.) +/- 0.22(syst.) for all inelastic interactions, and dN(ch)/d eta = 3.51 +/- 0.15(stat.) +/- 0.25(syst.) for nonsingle diffractive interactions. These results are consistent with previous measurements in proton-antiproton interactions at the same centre-of-mass energy at the CERN Sp<(p)over bar>S collider. They also illustrate the excellent functioning and rapid progress of the LHC accelerator, and of both the hardware and software of the ALICE experiment, in this early start-up phase.
|
|
| 7. |
- Aamodt, K., et al.
(författare)
-
The ALICE experiment at the CERN LHC
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3:S08002
-
Forskningsöversikt (refereegranskat)abstract
- ALICE (A Large Ion Collider Experiment) is a general-purpose, heavy-ion detector at the CERN LHC which focuses on QCD, the strong-interaction sector of the Standard Model. It is designed to address the physics of strongly interacting matter and the quark-gluon plasma at extreme values of energy density and temperature in nucleus-nucleus collisions. Besides running with Pb ions, the physics programme includes collisions with lighter ions, lower energy running and dedicated proton-nucleus runs. ALICE will also take data with proton beams at the top LHC energy to collect reference data for the heavy-ion programme and to address several QCD topics for which ALICE is complementary to the other LHC detectors. The ALICE detector has been built by a collaboration including currently over 1000 physicists and engineers from 105 Institutes in 30 countries, Its overall dimensions are 16 x 16 x 26 m(3) with a total weight of approximately 10 000 t. The experiment consists of 18 different detector systems each with its own specific technology choice and design constraints, driven both by the physics requirements and the experimental conditions expected at LHC. The most stringent design constraint is to cope with the extreme particle multiplicity anticipated in central Pb-Pb collisions. The different subsystems were optimized to provide high-momentum resolution as well as excellent Particle Identification (PID) over a broad range in momentum, up to the highest multiplicities predicted for LHC. This will allow for comprehensive studies of hadrons, electrons, muons, and photons produced in the collision of heavy nuclei. Most detector systems are scheduled to be installed and ready for data taking by mid-2008 when the LHC is scheduled to start operation, with the exception of parts of the Photon Spectrometer (PHOS), Transition Radiation Detector (TRD) and Electro Magnetic Calorimeter (EMCal). These detectors will be completed for the high-luminosity ion run expected in 2010. This paper describes in detail the detector components as installed for the first data taking in the summer of 2008.
|
|
| 8. |
- Adman, Per, et al.
(författare)
-
171 forskare: ”Vi vuxna bör också klimatprotestera”
- 2019
-
Ingår i: Dagens nyheter (DN debatt). - Stockholm. - 1101-2447.
-
Tidskriftsartikel (populärvet., debatt m.m.)abstract
- DN DEBATT 26/9. Vuxna bör följa uppmaningen från ungdomarna i Fridays for future-rörelsen och protestera eftersom det politiska ledarskapet är otillräckligt. Omfattande och långvariga påtryckningar från hela samhället behövs för att få de politiskt ansvariga att utöva det ledarskap som klimatkrisen kräver, skriver 171 forskare i samhällsvetenskap och humaniora.
|
|
| 9. |
- Bengtsson, Anders, et al.
(författare)
-
Counterterms in Gravity in the Light-Front Formulation and a D=2 Conformal-like Summetry in Gravity
- 2013
-
Ingår i: Journal of High Energy Physics (JHEP). - 1126-6708 .- 1029-8479. ; 2013:3
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- In this paper we discuss gravity in the light-front formulation (light-cone gauge) and show how possible counterterms arise. We find that Poincare invariance is not enough to find the three-point counterterms uniquely. Higher-spin fields can intrude and mimic three-point higher derivative gravity terms. To select the correct term we have to use the remaining reparametrization invariance that exists after the gauge choice. We finally sketch how the corresponding programme for N=8 Supergravity should work.
|
|
| 10. |
- Bengtsson, Anders, 1988, et al.
(författare)
-
Counterterms in gravity in the light-front formulation and a D=2 conformal-like symmetry in gravity
- 2013
-
Ingår i: Journal of High Energy Physics. - : Springer Science and Business Media LLC. - 1029-8479 .- 1126-6708. ; 58:5-6, s. 485-501
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper we discuss gravity in the light-front formulation (light-cone gauge) and show how possible counterterms arise. We find that Poincare invariance is not enough to find the three-point counterterms uniquely. Higher-spin fields can intrude and mimic three-point higher derivative gravity terms. To select the correct term we have to use the remaining reparametrization invariance that exists after the gauge choice. We finally sketch how the corresponding programme for N = 8 Supergravity should work.
|
|
