| 1. |
- Niemi, MEK, et al.
(författare)
-
- 2021
-
swepub:Mat__t
|
|
| 2. |
- Kanai, M, et al.
(författare)
-
- 2023
-
swepub:Mat__t
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 7. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 8. |
|
|
| 9. |
- Fowkes, F. G. R., et al.
(författare)
-
Development and validation of an ankle brachial index risk model for the prediction of cardiovascular events
- 2014
-
Ingår i: European Journal of Preventive Cardiology. - : Oxford University Press (OUP). - 2047-4881 .- 2047-4873. ; 21:3, s. 310-320
-
Tidskriftsartikel (refereegranskat)abstract
- Background The ankle brachial index (ABI) is related to risk of cardiovascular events independent of the Framingham risk score (FRS). The aim of this study was to develop and evaluate a risk model for cardiovascular events incorporating the ABI and FRS. Design An analysis of participant data from 18 cohorts in which 24,375 men and 20,377 women free of coronary heart disease had ABI measured and were followed up for events. Methods Subjects were divided into a development and internal validation dataset and an external validation dataset. Two models, comprising FRS and FRS + ABI, were fitted for the primary outcome of major coronary events. Results In predicting events in the external validation dataset, C-index for the FRS was 0.672 (95% CI 0.599 to 0.737) in men and 0.578 (95% CI 0.492 to 0.661) in women. The FRS + ABI led to a small increase in C-index in men to 0.685 (95% CI 0.612 to 0.749) and large increase in women to 0.690 (95% CI 0.605 to 0.764) with net reclassification improvement (NRI) of 4.3% (95% CI 0.0 to 7.6%, p = 0.050) and 9.6% (95% CI 6.1 to 16.4%, p < 0.001), respectively. Restricting the FRS + ABI model to those with FRS intermediate 10-year risk of 10 to 19% resulted in higher NRI of 15.9% (95% CI 6.1 to 20.6%, p < 0.001) in men and 23.3% (95% CI 13.8 to 62.5%, p = 0.002) in women. However, incorporating ABI in an improved newly fitted risk factor model had a nonsignificant effect: NRI 2.0% (95% CI 2.3 to 4.2%, p = 0.567) in men and 1.1% (95% CI 1.9 to 4.0%, p = 0.483) in women. Conclusions An ABI risk model may improve prediction especially in individuals at intermediate risk and when performance of the base risk factor model is modest.
|
|
| 10. |
- Knaapen, M, et al.
(författare)
-
Establishing a core outcome set for treatment of uncomplicated appendicitis in children: study protocol for an international Delphi survey
- 2019
-
Ingår i: BMJ open. - : BMJ. - 2044-6055. ; 9:5, s. e028861-
-
Tidskriftsartikel (refereegranskat)abstract
- Appendicitis is a global disease affecting roughly 1 in every 12 people in the world, with the highest incidence between ages 10 and 19 years. To date, a wide variety of health outcomes have been reported in randomised controlled trials and meta-analyses evaluating treatments for appendicitis. This is especially the case in studies comparing non-operative treatment with operative treatment. A set of standard outcomes, to be reported in all future trials, is needed to allow for adequate comparison and interpretation of clinical trial results and to make data pooling possible. This protocol describes the development of such a global core outcome set (COS) to allow unified reporting of treatment interventions in children with acute uncomplicated appendicitis.Methods and analysisWe use current international standard methodology for the development and reporting of this COS. Its development consists of three phases: (1) an update of the most recent systematic review on outcomes reported in uncomplicated paediatric appendicitis research to identify additional outcomes, (2) a three-step global Delphi study to identify a set of core outcomes for which there is consensus between parents and (paediatric) surgeons and (3) an expert meeting to finalise the COS and its definitions. Children and young people will be involved through their parents during phase 2 and will be engaged directly using a customised face-to-face approach.Ethics and disseminationThe medical research ethics committee of the Academic Medical Center Amsterdam has approved the study. Each participating country/research group will ascertain ethics board approval. Electronic informed consent will be obtained from all participants. Results will be presented in peer-reviewed academic journals and at (international) conferences.Trial registration numberCOMET registration: 1119
|
|
