| 1. |
- Sharifi Brojerdi, Fatemeh
(författare)
-
Analysis of Seismic Data Acquired at the Forsmark Site for Storage of Spent Nuclear Fuel, Central Sweden
- 2015
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The Forsmark area, the main study area in this thesis, is located about 140 km north of Stockholm, central Sweden. It belongs to the Paleoproterozoic Svecokarelian orogen and contains several major ductile and brittle deformation zones including the Forsmark, Eckarfjärden and Singö zones. The bedrock between these zones, in general is less deformed and considered suitable for a nuclear waste repository. While several site investigations have already been carried out in the area, this thesis focuses primarily on (i) re-processing some of the existing reflection seismic lines to improve imaging of deeper structures, (ii) acquiring and processing high-resolution reflection and refraction data for better characterization of the near surface geology for the planning of a new access ramp, (iii) studying possible seismic anisotropy from active sources recorded onto sparse three-component receivers and multi-offset-azimuth vertical seismic profiling data (VSP). Reflection seismic surveys are an important component of these investigations. The re-processing helped in improving the deeper parts (1-5 km) of the seismic images and allowing three major deeper reflections to be better characterized, one of which is sub-horizontal while the other two are dipping moderately. These reflections were attributed to originate from either dolerite sills or brittle fault systems. First break traveltime tomography allowed delineating an undulating bedrock-surface topography, which is typical in the Forsmark area. Shallow reflections imaged in 3D, thanks to the acquisition design were compared with existing borehole data and explained by fractured or weak zones in the bedrock. The analysis of seismic anisotropy indicates the presence of shear-wave splitting due to transverse isotropy with a vertical symmetry axis in the uppermost hundreds of meters of crust. Open fractures and joints were interpreted to be responsible for the large delays observed between the transverse and radial components of the shear-wave arrivals, both on surface and VSP data.
|
|
| 2. |
- Bergman, Björn, 1973-
(författare)
-
High-Resolution Seismics Methods Applied to Till Covered Hard Rock Environments
- 2005
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Reflection seismic and seismic tomography methods can be used to image the upper kilometer of hard bedrock and the loose unconsolidated sediments covering it. Developments of these two methods and their application, as well as identifying issues concerning their usage, are the main focus of the thesis. Data used for this development were acquired at three different sites in Sweden, in Forsmark 140 km north of Stockholm, in the Oskarshamn area in southern Sweden, and in the northern part of the Siljan Ring impact crater area.The reflection seismic data were acquired with long source-receiver offsets relative to some of the targeted depths to be imaged. In the initial processing standard steps were applied, but the uppermost part of the sections were not always clear. The longer offsets imply that pre-stack migration is necessary in order to image the uppermost bedrock as clearly as possible. Careful choice of filters and velocity functions improve the pre-stack migrated image, allowing better correlation with near-surface geological information.The seismic tomography method has been enhanced to calculate, simultaneously with the velocity inversion, optimal corrections to the picked first break travel times in order to compensate for the delays due to the seismic waves passing through the loose sediments covering the bedrock.The reflection seismic processing used in this thesis has produced high-quality images of the upper kilometers, and in one example from the Forsmark site, the image of the uppermost 250 meters of the bedrock has been improved. The three-dimensional orientation of reflections has been determined at the Oskarshamn site. Correlation with borehole data shows that many of these reflections originate from fracture zones.The developed seismic tomography method produces high-detail velocity models for the site in the Siljan impact area and for the Forsmark site. In Forsmark, detailed estimates of the bedrock topography were calculated with the use of the developed tomography method.
|
|
